Search NASA⌕ Search

Engineering topics

Keith, Theo G.

Publications and source records attributed to Keith, Theo G..

A Dynamic Analysis of Hydrodynamic Wave Journal Bearings

The purpose of this paper is to study the dynamic behavior of a three-wave journal bearing using a transient approach. The transient analysis permits the determination of the rotor behavior after the fractional frequency whirl appears. The journal trajectory is determined by solving a set of nonlinear equations of motion using the Runge-Katta method. The fluid film forces are computed by integrating the transient Reynolds equation at each time step location of the shaft with respect to the bearing. Because of the large values of the rotational speeds, turbulent effects were included in the computations. The influence of the temperature on the viscosity was also considered. Numerical results were compared to experimenta1 results obtained at the NASA Glenn Research Center. Comparisons of the theoretical results with experimental data were found to be in good agreement. The numerical and experimental results showed that the fluid film of a three-wave journal bearing having a diameter of 30 mm, a length of 27 mm, and a wave amplitude ratio greater than 0.15 is stable even at rotational speeds of 60,000 RPM. For lower wave amplitude ratios, the threshold speed at which the fluid film becomes unstable depends on the wave amplitude and on the supply pocket pressure. Even if the fluid film is unstable, the wave bearing maintains the whirl orbit inside the bearing clearance.

Ene, Nicoleta M.↗

Elevated Temperature Testing and Modeling of Advanced Toughened Ceramic Materials

The purpose of this report is to provide a final report for the period of 12/1/03 through 11/30/04 for NASA Cooperative Agreement NCC3-776, entitled "Elevated Temperature Testing and Modeling of Advanced Toughened Ceramic Materials." During this final period, major efforts were focused on both the determination of mechanical properties of advanced ceramic materials and the development of mechanical test methodologies under several different programs of the NASA-Glenn. The important research activities made during this period are: 1. Mechanical properties evaluation of two gas-turbine grade silicon nitrides. 2) Mechanical testing for fuel-cell seal materials. 3) Mechanical properties evaluation of thermal barrier coatings and CFCCs and 4) Foreign object damage (FOD) testing.

Keith, Theo G.↗

Overview of numerical codes developed for predicted electrothermal deicing of aircraft blades

An overview of the deicing computer codes that have been developed at the University of Toledo under sponsorship of the NASA-Lewis Research Center is presented. These codes simulate the transient heat conduction and phase change occurring in an electrothermal deicier pad that has an arbitrary accreted ice shape on its surface. The codes are one-dimensional rectangular, two-dimensional rectangular, and two-dimensional with a coordinate transformation to model the true blade geometry. All modifications relating to the thermal physics of the deicing problem that have been incorporated into the codes will be discussed. Recent results of reformulating the codes using different numerical methods to increase program efficiency are described. In particular, this reformulation has enabled a more comprehensive two-dimensional code to run in much less CPU time than the original version. The code predictions are compared with experimental data obtained in the NASA-Lewis Icing Research Tunnel with a UH1H blade fitted with a B. F. Goodrich electrothermal deicer pad. Both continuous and cyclic heater firing cases are considered. The major objective in this comparison is to illustrate which codes give acceptable results in different regions of the airfoil for different heater firing sequences.

Keith, Theo G.↗