Engineering topics

Kelly, Arnold J.

Publications and source records attributed to Kelly, Arnold J..

6 records

NASA NTRS1992

Anode power deposition in a MPD thruster with a magnetically annulled Hall parameter anode

Results from previous studies indicate that the anode fall increases monotonically with the electron Hall parameter. In an attempt to reduce the anode fall by decreasing the local electron Hall parameter, a proof-of-concept test was performed in which an array of 36 permanent magnets were imbedded within the anode of a high power quasi-steady MPD thruster to decrease the local azimuthal component of the induced magnetic field. The modified thruster was operated at power levels between 150 kW and 4 MW with Ar and He propellants. Terminal voltage, triple probe, floating probe, and magnetic probe measurements were made to characterize the performance of the thruster with new anode. Incorporation of the modified anode resulted in a reduction of the anode fall by up to 15 V with Ar and 20 V with He, which corresponded to decreased anode power fractions of 40 and 45 percent with Ar and He, respectively.

Gallimore, Alec D.↗

NASA NTRS1992

Numerical simulation of MPD thruster flows with anomalous transport

Anomalous transport effects in an Ar self-field coaxial MPD thruster are presently studied by means of a fully 2D two-fluid numerical code; its calculations are extended to a range of typical operating conditions. An effort is made to compare the spatial distribution of the steady state flow and field properties and thruster power-dissipation values for simulation runs with and without anomalous transport. A conductivity law based on the nonlinear saturation of lower hybrid current-driven instability is used for the calculations. Anomalous-transport simulation runs have indicated that the resistivity in specific areas of the discharge is significantly higher than that calculated in classical runs.

Caldo, Giuliano↗

NASA NTRS1992

Current-driven plasma acceleration versus current-driven energy dissipation. III - Anomalous transport

In the present paper the linear stability description and weak turbulence theory are used to develop a second order description of wave-particle transport and anomalous dissipation. The goal is to arrive at anomalous transport coefficients that can be readily included in fluid flow codes. In particular, expressions are derived for the heating rates of ions and electrons by the unstable waves and for the electron-wave momentum exchange rate that controls the anomalous resistivity effect. Comparative calculations were undertaken assuming four different saturation models: ion trapping, electron trapping, ion resonance broadening, and thermodynamic bound. A foremost finding is the importance of the role of electron Hall parameter in scaling the level of anomalous dissipation for the parameter range of the MPD thruster plasma. Polynomial expressions of the relevant transport coefficients cast solely in terms of macroscopic parameters are also obtained for inclusion in plasma fluid codes for the self-consistent numerical simulation of real thruster flows including microturbulent effects.

Choueiri, Edgar Y.↗

NASA NTRS1990

The application of the triple probe method to MPD thruster plumes

The triple probe method is an attractive technique for measuring axial and radial profiles of electron temperature T(e) and electron number density n(e) in magnetoplasmadynamic (MPD) thruster plumes. In this paper the performance and applicability of the triple probe to MPD thruster plumes is evaluated by identifying sources of error, correction methods, and error estimation techniques. Included in the analysis is an adaptation of Laframboise's exact calculations to the triple probe, aligned with the flow vector, and a preliminary investigation of the effect of flow transverse to the probe axis. In MPD thrusters, the triple probe method can provide measurement accuracy of T(e) wintin about 10 percent and n(e) within about 60 percent.

Kelly, Arnold J.↗

NASA NTRS1990

Anode power deposition in quasi-steady MPD thrusters

Spatially resolved anode heat flux measurements of a pulsed quasi-steady MPD thruster have been made by embedding thermocouples to the inner surface of a hollowed anode. Results obtained using argon propellant at mass flow rates of 4 and 16 g/s with the thruster operating at currents between 8 and 24 kA are presented. The results show that the anode fall voltage increases linearly with thruster current and does not depend on propellant mass flow rate. The fraction of thruster power deposited into the anode is 42 percent at 1 MW and falls to less than 20 percent at 6 MW. At any given operating condition, there is an inverse relationship between the anode fall and anode current density.

Kelly, Arnold J.↗

NASA NTRS1987

Megawatt level electric propulsion perspectives

For long range space missions, deliverable payload fraction is an inverse exponential function of the propellant exhaust velocity or specific impulse of the propulsion system. The exhaust velocity of chemical systems are limited by their combustion chemistry and heat transfer to a few km/s. Nuclear rockets may achieve double this range, but are still heat transfer limited and ponderous to develop. Various electric propulsion systems can achieve exhaust velocities in the 10 km/s range, at considerably lower thrust densities, but require an external electrical power source. A general overview is provided of the currently available electric propulsion systems from the perspective of their characteristics as a terminal load for space nuclear systems. A summary of the available electric propulsion options is shown and generally characterized in the power vs. exhaust velocity plot. There are 3 general classes of electric thruster devices: neutral gas heaters, plasma devices, and space charge limited electrostatic or ion thrusters.

Jahn, Robert G.↗