Search NASA⌕ Search

Engineering topics

Kelly, J. J.

Publications and source records attributed to Kelly, J. J..

10 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2000

Evaluation of an Impedance Model for Perforates Including the Effect of Bias Flow

A new bias flow impedance model is developed for perforated plates from basic principles using as little empiricisms as possible. A quality experimental database was used to determine the predictive validity of the model. Results show that the model performs better for higher (15%) rather than lower (5%) percent open area (POA) samples. Based on the least squares ratio of numerical vs. experimental results, model predictions were on average within 20% and 30% for the higher and lower (POA), respectively. It is hypothesized on the work of other investigators that at lower POAs the higher fluid velocities in the perforate's orifices start forming unsteady vortices, which is not accounted for in our model. The numerical model, in general also underpredicts the experiments. It is theorized that the actual acoustic C(sub D) is lower than the measured raylometer C(sub D) used in the model. Using a larger C(sub D) makes the numerical model predict lower impedances. The frequency domain model derived in this paper shows very good agreement with another model derived using a time domain approach.

Betts, J. F.↗
NASA NTRS1999

F-16XL and F-18 High Speed Acoustic Flight Test Databases

This report presents the recorded acoustic data and the computed narrow-band and 1/3-octave band spectra produced by F-18 and F-16XL aircraft in subsonic flight over an acoustic array. Both broadband-shock noise and turbulent mixing noise are observed in the spectra. Radar and c-band tracking systems provided the aircraft position which enabled directivity and smear angles from the aircraft to each microphone to be computed. These angles are based on source emission time and thus give some idea about the directivity of the radiated sound field due to jet noise. A follow-on static test was also conducted where acoustic and engine data were obtained. The acoustic data described in the report has application to community noise analysis, noise source characterization and validation of prediction models. A detailed description of the signal processing procedures is provided. Follow-on static tests of each aircraft were also conducted for which engine data and far-field acoustic data are presented.

Kelly, J. J.↗
NASA NTRS1999

A Mode Detection Method Using the Azimuthal Directivity of a Turbofan Model

The azimuthal, far field directivity of a scale fan model was measured in high resolution. The model is a 12 inch diameter rotor with 16 blades followed by 40 stator vanes. The tests were conducted at the nominal 100% speed corresponding to a tip speed of 905 ft/sec. Measurement of the radiated sound field, forward of the fan, was made in an anechoic chamber with an inflow control device and a baffle separating the aft and forward radiated interaction noise. The acoustic field was surveyed with a circular hoop array of 16 microphones which was moved to 14 axial stations. At each axial station the hoop was rotated in half-degree increments to take 736 points in the azimuthal angle. In addition to sound pressure level, the phase angle relative to a reference microphone was measured at each point. The sound pressure level is shown to vary in patterns by 10-15 dB especially for the fundamental tone but also for the first and second harmonic. A far field mode detection method has been developed and used with the data which determines the modes generated by the fan and which then interact to form the azimuthal directivity.

Thomas, R. H.↗
NASA NTRS1997

A User''s Guide to the Zwikker-Kosten Transmission Line Code (ZKTL)

This user's guide documents updates to the Zwikker-Kosten Transmission Line Code (ZKTL). This code was developed for analyzing new liner concepts developed to provide increased sound absorption. Contiguous arrays of multi-degree-of-freedom (MDOF) liner elements serve as the model for these liner configurations, and Zwikker and Kosten's theory of sound propagation in channels is used to predict the surface impedance. Transmission matrices for the various liner elements incorporate both analytical and semi-empirical methods. This allows standard matrix techniques to be employed in the code to systematically calculate the composite impedance due to the individual liner elements. The ZKTL code consists of four independent subroutines: 1. Single channel impedance calculation - linear version (SCIC) 2. Single channel impedance calculation - nonlinear version (SCICNL) 3. Multi-channel, multi-segment, multi-layer impedance calculation - linear version (MCMSML) 4. Multi-channel, multi-segment, multi-layer impedance calculation - nonlinear version (MCMSMLNL) Detailed examples, comments, and explanations for each liner impedance computation module are included. Also contained in the guide are depictions of the interactive execution, input files and output files.

Kelly, J. J.↗
NASA NTRS1993

Signal processing of aircraft flyover noise

A detailed analysis of signal processing concerns for measuring aircraft flyover noise is presented. Development of a de-Dopplerization scheme for both corrected time history and spectral data is discussed along with an analysis of motion effects on measured spectra. A computer code was written to implement the de-Dopplerization scheme. Input to the code is the aircraft position data and the pressure time histories. To facilitate ensemble averaging, a level uniform flyover is considered in the study, but the code can accept more general flight profiles. The effects of spectral smearing and its removal are discussed. Using test data acquired from an XV-15 tilt-rotor flyover, comparisons are made between the measured and corrected spectra. Frequency shifts are accurately accounted for by the de-Dopplerization procedure. It is shown that by correcting for spherical spreading and Doppler amplitude, along with frequency, can give some idea about noise source directivity. The analysis indicated that smearing increases with frequency and is more severe on approach than recession.

Kelly, J. J.↗
NASA NTRS1985

The effect of source location on the structural-acoustic interaction of an infinite elastic shell

This paper deals with the response of an infinite elastic shell to simple acoustic sources (monopole and dipole). This simplified model is considered in order to gain insight into the characteristics of aircraft interior noise. The shell represents the aircraft fuselage and the sources are due to the propellor. Specifically, in this study the location of the source with respect to the cylinder is the major concern. How this affects acoustic line power, intensity flow into the shell and internal sound pressure is analyzed.

Kelly, J. J.↗
NASA NTRS1982

Acoustic propagation in partially choked converging-diverging ducts

A computer model based on the wave-envelope technique is used to study acoustic propagation in converging-diverging hard walled and lined circular ducts carrying near sonic mean flows. The influences of the liner admittance, boundary layer thickness, spinning mode number, and mean Mach number are considered. The numerical results indicate that the diverging portion of the duct can have a strong reflective effect for partially choked flows.

Kelly, J. J.↗
NASA NTRS1982

Propagation of spinning acoustic modes in partially choked converging ducts

A computer model based on the wave-envelope technique is used to study the propagation of spinning acoustic modes in converging hard-walled and lined circular ducts carrying near sonic mean flows. The results show that with increasing spinning mode number the intensification of the acoustic signal at the throat decreases for upstream propagation. The influence of the throat Mach number, frequency, boundary-layer thickness, and liner admittance on the propagation of spinning modes is considered.

Nayfeh, A. H.↗
NASA NTRS1981

Non-linear propagation in near sonic flows

A nonlinear analysis is developed for sound propagation in a variable-area duct in which the mean flow approaches choking conditions. A quasi-one-dimensional model is used and the nonlinear analysis represents the acoustic disturbance as a sum of interacting harmonics. The numerical procedure is stable for cases of strong interaction and is able to integrate through the throat region without any numerical instability.

Nayfeh, A. H.↗