Mass Loaded Support Structures Random Vibration Predictions
No abstract available
mass loaded components↗
Engineering topics
Kern, Dennis
Publications and source records attributed to Kern, Dennis.
Prediction of Spacecraft Vibration using Acceleration and Force Envelopes
The base forces in the GLAST X- and Z-axis sine vibration tests were similar to those derived using generic inputs (from users guide and handbook), but the base forces in the sine test were generally greater than the flight data. Basedrive analyses using envelopes of flight acceleration data provided more accurate predictions of the base force than generic inputs, and as expected, using envelopes of both the flight acceleration and force provided even more accurate predictions The GLAST spacecraft interface accelerations and forces measured during the MECO transient were relatively low in the 60 to 150 Hz regime. One may expect the flight forces measured at the base of various spacecraft to be more dependent on the mass, frequencies, etc. of the spacecraft than are the corresponding interface acceleration data, which may depend more on the launch vehicle configuration.
Gordon, Scott↗
Flight Loads and Environments Initiative
A viewgraph presentation on the design of a lightweight non-intrusive force measurement device (FMD) to reduce the cost per effective payload (PL) mass into orbit (CPMO) by improving launch vehicle (LV) loads and environments.
Kaufman, Daniel↗
Derivation of Acoustic Criteria for the Cassini Spacecraft and Comparison with Flight Data
Acoustic measurements from eight pre-Cassini Titan IV flights, and an acoustic test of a Cassini simulator and Titan payload fairing (PLF), were used to derive acoustic flight and test criteria for the Cassini spacecraft. The flight and ground test data were used or modified to account for the following factors: (a) noise-spike contamination of flight data, (b) spatial and flight-to-flight variations of flight data, (c) application of a thicker banier-blanket to the PLF for the Cassini mission, (d) effects of locating two Cassini assemblies, the Huygens Probe, and the High Gain Antenna (HGA), near the PLF, and (e) higher thrust of upgraded Titan solid rocket motors (SRMS) for the Cassini mission. An overall sound pressure level (OA SPL) of 145 dB was verified for the protoflight acoustic test criteria for the Cassini spacecraft. Cassini flight liftoff data showed an average OA SPL of 133 dB.
Himelblau, Harry↗
Noise environment reduction foam spheres in space
The advent of lightweight fairings for new spacecraft and the increased thrust of new launch vehicles have intensified the need for better techniques for predicting and for reducing the low frequency noise environment of spacecraft at liftoff. This paper presents a VAPEPS (VibroAcoustic Payload Environment Prediction System) parametrical analysis of the noise reduction of spacecraft fairings and explores a novel technique for increasing the low frequency noise reduction of lightweight fairing by approximately 10 dB.
Scharton, Terry↗