Engineering topics

Kerns, Peter

Publications and source records attributed to Kerns, Peter.

9 records

DOE OSTI2023

Ultrasmall Cu Nanoparticles Supported on Crystalline, Mesoporous ZnO for Selective CO 2 Hydrogenation

Converting CO 2 to value-added chemicals, e. g., CH 3 OH, is highly desirable in terms of the carbon cycling while reducing CO 2 emission from fossil fuel combustion. Cu-based nanocatalysts are among the most efficient for selective CO 2 -to-CH 3 OH transformation; this conversion, however, suffers from low reactivity especially in the thermodynamically favored low temperature range. We herein report ultrasmall copper (Cu) nanocatalysts supported on crystalline, mesoporous zinc oxide nanoplate (Cu@mZnO) with notable activity and selectivity of CO 2 -to-CH 3 OH in the low temperature range of 200–250 °C. Cu@mZnO nanoplates are prepared based on the crystal-crystal transition of mixed Cu and Zn basic carbonates to mesoporous metal oxides and subsequent hydrogen reduction. Under the nanoconfinement of mesopores in crystalline ZnO frameworks, ultrasmall Cu nanoparticles with an average diameter of 2.5 nm are produced. Cu@mZnO catalysts have a peak CH 3 OH formation rate of 1.13 mol h −1 per 1 kg under ambient pressure at 246 °C, about 25 °C lower as compared to that of the benchmark catalyst of Cu−Zn−Al oxides. In conclusion, our new synthetic strategy sheds some valuable insights into the design of porous catalysts for the important conversion of CO 2 -to-CH 3 OH.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2021

Partially reduced Ru/RuO 2 composites as efficient and pH-universal electrocatalysts for hydrogen evolution

Efficient and long-term stable electrocatalysts for the hydrogen evolution reaction (HER) via water splitting are urgently desired to ease the energy crisis and develop the sustainability of human society. However, the HER performance of state-of-the-art Pt in non-acidic solutions is unsatisfactory due to the severely sluggish kinetics. In this work, DFT theoretical calculations reveal that the Ru/RuO 2 composites enable high HER activity to be pursued under non-acidic conditions because of the distinctive Ru and RuO 2 interface, which possess not only a strong capability to adsorb and dissociate water but also appropriate binding energies of H and OH. Therefore, we employ a simple strategy, including heating under an oxygen-poor environment and/or in situ electrochemical reduction, to partially reduce RuO 2 . The formed Ru/RuO 2 interfaces demonstrate superior HER activities (e.g. η 10 = 17 mV, 35 mV dec –1 in 1 M KOH) than Pt/C (e.g. η 10 = 27 mV, 58 mV dec –1 in 1 M KOH) at both small (10–100 mA cm –2 ) and large (1 A cm –2 ) current densities in alkaline solution and even real seawater. Comprehensive experiments were conducted to investigate the structure-HER performance relationships. Moreover, benefiting from the bifunctional character of RuO2, a two-electrode system based on Ru/RuO 2 composites and RuO 2 exhibits the lowest cell voltage for water splitting in both 1 M KOH and 0.5 M H 2 SO 4 , respectively. A 300 h-stability test at 10 mA cm –2 without an obvious decay demonstrates the industrial prospects of the Ru/RuO 2 composites to generate green energy.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2020

Voltage-Dependent Photoluminescence of Carbon Dots

Carbon dots are fluorescent carbon-based nanoparticles with great potential in bioimaging because they offer multiple imaging windows owing to their excitation dependent emission features. A recent theory study shows that emission of graphene quantum dots responds to external elec. field due to Stark effect. Inspired by this work, we have demonstrated here the first exptl. study of the Stark effect of fluorescent carbon dots synthesized via a soft-template method. The carbon dots exhibit excitation-dependent emission covering blue to orange emission range. After being encapsulated in artificial lipid bilayers, the carbon dots show voltage-sensitivity of fluorescence. The fluorescence intensity change per mV is comparable with that of com. membrane potential sensing dyes. Our results demonstrate the great potential of carbon dots in membrane voltage sensing.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2020

Effect of lithium incorporation on tweaking the electrocatalytic behavior of tantalum-based oxides

To study the effect of lithium incorporation on the electrochemical properties and catalytic behavior of tantalum-based oxides, a series of mesoporous lithium-contained tantalum oxides was developed adopting an inverse micelle-based sol gel synthesis method. Four various phases of amorphous Ta 2 O 5 , polycrystalline LiTaO 3 , Li 5.04 Ta 6.16 O 17.92 , and Li 3 TaO 4 were determined for samples synthesized at Li/Ta ratios of 0.5 (LTO-0.5), 1 (LTO-1), 2 (LTO-2), and 3 (LTO-3) respectively. The surface analysis revealed that LTO-2 sample is featured with lower amount of lithium atoms at the surface rather than the bulk of the sample. The electrochemical analysis of LTO samples showed that LTO-2 possesses lower charge transfer resistance extracted from impedance spectroscopy that consequently leads to a better electrocatalytic performance. The LTO-2 electrode also showed a low open circuit potential (OCP) combined with a relatively higher electroactive surface area, thus capable of running an electrooxidation reaction at a potential lower than all other LTO samples. The more negative OCP value of LTO-2 electrode in AA solution states a more facile electron transfer between the analyte and electrode compared to other synthesized samples. Mott–Schottky plots of LTO electrodes are characterized by positive slopes which indicate n-type semiconductor behavior. The charge carrier density (5.5 × 10 19 cm -3 ) in LTO-2 sample is the lowest among all other samples. The charge carrier density is dependent on the amount of applied lithium in the synthesis confirming various lithium diffusion behaviors in LTO samples. The lower carrier concentration in LTO-2 justifies its higher activity in electrooxidation providing less populated lower unoccupied molecular orbital (LUMO) for the accommodation of electrons extracted from the analyte higher occupied molecular orbital (HOMO). Therefore, LTO-2 showed an improved electrocatalytic performance due to lower charge transfer resistance (higher conductivity) offered by lower amount of lithium atom at its surface and higher oxygen vacancies in the bulk.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2020

Mesoporous Crystalline Niobium Oxide with a High Surface Area: A Solid Acid Catalyst for Alkyne Hydration

A mesoporous crystalline niobium oxide with tunable pore sizes was synthesized via the sol–gel-based inverse micelle method. The material shows a surface area of 127 m 2 /g, which is the highest surface area reported so far for crystalline niobium oxide synthesized by soft template methods. The material also has a monomodal pore size distribution with an average pore diameter of 5.6 nm. A comprehensive characterization of niobium oxide was performed using powder X-ray diffraction, Brunauer–Emmett–Teller, thermogravimetric analysis, scanning electron microscopy, transmission electron microscopy, UV–vis, and X-ray photoelectron spectroscopy. The material acts as an environmentally friendly, solid acid catalyst toward hydration of alkynes under with excellent catalytic activity (99% conversion, 99% selectivity, and 4.39 h –1 TOF). Brønsted acid sites present in the catalyst were found to be responsible for the high catalytic activity. Lastly, the catalyst was reusable up to five cycles without a significant loss of the activity.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2020

Enhanced visible-light-assisted peroxymonosulfate activation on cobalt-doped mesoporous iron oxide for orange II degradation

Sulfate radical-based advanced oxidation processes (SR-AOP) attracted a lot of attention due to their capability and adaptability in wastewater treatment. Although heterogeneous cobalt-based catalysts have been extensively studied and have emerged superior for peroxymonosulfate (PMS) activation, leaching of cobalt is still a major concern. Herein, we report a photo-assisted PMS activation approach using cobalt doped mesoporous iron oxide with exceptional activity and stability up to 7 cycles with very low cobalt leaching (0.5 ppm). The highest activity was obtained by 1 mol % cobalt doped mesoporous iron oxide. Orange II dye was completely degraded by the reactive oxygen species (ROS) generated under visible light irradiation within 1 min. ROS were evaluated using two distinct techniques (Fluorescence probes and Electron Paramagnetic Resonance (EPR). ROS quenching experiments were also used to highlight the dominant pathway. This study correlates the structural and electronic changes induced with cobalt doping to the exceptional activity.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2020

Highly microporous Parinari Curatellifolia carbon nanomaterials for supercapacitors

High surface area nanostructured electrodes are essential for understanding charge storage mechanisms in high capacitance supercapacitors. Additionally, a growing number of studies provide credible evidence that the highest capacitance in carbon nanomaterials is attainable only when the pore size is in micropore range. In this study therefore, micropore-dominatedcarbon materials derived from Parinari curatellifolia (PC) waste seeds are prepared via pyrolysis and subsequent chemical activation with KOH. SEM, EDAX, TEM, Raman, and XRD studies show that the microstructure and composition of the as-prepared microporous carbon materials are influenced by adjusting the KOH to carbon mass ratio. Sorption studies demonstrate a very high BET surface area of 1898 m 2 g –1 , type I isotherm, and 99% micropore content in all the samples. The BET surface area, S micro , V micro , and total volume increased with increasing KOH content during activation. The fabricated electrodes exhibit high specific capacitances of 423 F g –1 at 5 mV s –1 and cyclic stability of 98% after 50000 cycles both of which are indicative of our carbon materials huge potential in making high performance supercapacitors. The specific capacitance increased with the micropore content in the samples signifying that the pores enhanced diffusion and hence the charge storage. The PC carbon materials deliver high specific capacitance due to the enhancement of diffusion and charge storage stemming from the synergetic interplay of the aforementioned textural parameters. As a result, the PC carbon materials therefore provide good prospects for supercapacitor applications.

77 NANOSCIENCE AND NANOTECHNOLOGY↗

DOE OSTI2020

Self-grown NiCuO x hybrids on a porous NiCuC substrate as an HER cathode in alkaline solution

Electrocatalysts converted directly from the substrates hold the key to achieve high catalytic activity and durability due to their high bonding strength, intimate electronic contact, and tunable phase composition. Herein, an electrically conductive porous NiCuC substrate was adopted to develop a multi-porous NiCuO x /NiCuC hydrogen evolution reaction (HER) catalyst using a one-step oxidation method in this research. The NiCuO x hybrids were characterized as three typical layers: an outer layer with NiCuO 2 solid solution phase, a partially oxidized intermediate layer, and an inner layer with limited stable oxygen content. Here, the NiCuO x /NiCuC possesses abundant Ni(II)–Cu(II) sites to accelerate the Volmer step via the electrostatic effect with OH – , numerous metallic NiCu sites to facilitate the H adsorption, and highly accessible channels to promote the Heyrovsky step during HER catalysis. As a result, high electrocatalytic performance was obtained with an overpotential of 116 mV at a current density of 10 mA cm –2 in 1.0 M potassium hydroxide, and a stable catalytic performance during the HER process for more than 24 h.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2020

Amorphous Manganese Oxides: An Approach for Reversible Aqueous Zinc-Ion Batteries

Crystalline manganese oxides have attracted the most attention in aqueous zinc-ion batteries due to their diverse nanostructures and low cost. However, extensive studies on amorphous manganese oxides are lacking. Here in this paper, we report a mesoporous amorphous manganese oxide (UCT-1-250) as a cathode material with high capacity (222 mAh g –1 ), good cyclability (57% capacity retention after 200 cycles), and an acceptable discharge plateau (between 1.2 and 1.4 V). An approach to mechanistic studies was performed by comparison of UCT-1-250 and other crystalline manganese oxides through electrochemical, elemental, and structural analyses. An in situ conversion to ZnMn 2 O 4 spinel phase after initial cycling contributes to the high performance. The irreversible capacity fading is due to the formation of the woodruffite phase.

36 MATERIALS SCIENCE↗