Search NASA⌕ Search

Engineering topics

Kerr, A. R.

Publications and source records attributed to Kerr, A. R..

At least 19 records

Embedding impedance approximations in the analysis of SIS mixers

Future millimeter-wave radio astronomy instruments will use arrays of many SIS receivers, either as focal plane arrays on individual radio telescopes, or as individual receivers on the many antennas of radio interferometers. Such applications will require broadband integrated mixers without mechanical tuners. To produce such mixers, it will be necessary to improve present mixer design techniques, most of which use the three-frequency approximation to Tucker's quantum mixer theory. This paper examines the adequacy of three approximations to Tucker's theory: (1) the usual three-frequency approximation which assumes a sinusoidal LO voltage at the junction, and a short-circuit at all frequencies above the upper sideband; (2) a five-frequency approximation which allows two LO voltage harmonics and five small-signal sidebands; and (3) a quasi five-frequency approximation in which five small-signal sidebands are allowed, but the LO voltage is assumed sinusoidal. These are compared with a full harmonic-Newton solution of Tucker's equations, including eight LO harmonics and their corresponding sidebands, for realistic SIS mixer circuits. It is shown that the accuracy of the three approximations depends strongly on the value of omega R(sub N)C for the SIS junctions used. For large omega R(sub N)C, all three approximations approach the eight-harmonic solution. For omega R(sub N)C values in the range 0.5 to 10, the range of most practical interest, the quasi five-frequency approximation is a considerable improvement over the three-frequency approximation, and should be suitable for much design work. For the realistic SIS mixers considered here, the five-frequency approximation gives results very close to those of the eight-harmonic solution. Use of these approximations, where appropriate, considerably reduces the computational effort needed to analyze an SIS mixer, and allows the design and optimization of mixers using a personal computer.

Kerr, A. R.↗

A general numerical analysis program for the superconducting quasiparticle mixer

A user-oriented computer program SISCAP (SIS Computer Analysis Program) for analyzing SIS mixers is described. The program allows arbitrary impedance terminations to be specified at all LO harmonics and sideband frequencies. It is therefore able to treat a much more general class of SIS mixers than the widely used three-frequency analysis, for which the harmonics are assumed to be short-circuited. An additional program, GETCHI, provides the necessary input data to program SISCAP. The SISCAP program performs a nonlinear analysis to determine the SIS junction voltage waveform produced by the local oscillator. The quantum theory of mixing is used in its most general form, treating the large signal properties of the mixer in the time domain. A small signal linear analysis is then used to find the conversion loss and port impedances. The noise analysis includes thermal noise from the termination resistances and shot noise from the periodic LO current. Quantum noise is not considered. Many aspects of the program have been adequately verified and found accurate.

Hicks, R. G.↗

A superconducting tunnel junction receiver for millimeter-wave astronomy

The development and construction of an ultralow noise heterodyne receiver for millimeter wave astronomy is described along with its use for 115.3 GHz Co line observations. The receiver uses a Superconductor-Insulator-Superconductor (SIS) quasiparticle tunnel junction mixer to convert the millimeter wave signal to a microwave intermediate frequency. Experiments aimed at quantitative verification of J. R. Tucker's quantum mixer theory are studied, to see whether it could be used as the basis for the design of a practical receiver. The experimental results were in excellent agreement with the theory, assuming the three frequency approximation. Infinite available gain and negative output resistance were observed for the first time, nonclassical effects which are not seen in conventional diode mixers. Using Tucker's theory, an SIS receiver was then designed and constructed. At 115 GHz, the single sideband receiver noise temperature is 83K, the lowest ever reported in this frequency range. A CO survey toward Cygnus-X region, using this SIS receiver on the Columbia-GISS 4 ft. telescope, is also described.

Pan, S. K.↗

A general numerical analysis of the superconducting quasiparticle mixer

For very low noise millimeter-wave receivers, the superconductor-insulator-superconductor (SIS) quasiparticle mixer is now competitive with conventional Schottky mixers. Tucker (1979, 1980) has developed a quantum theory of mixing which has provided a basis for the rapid improvement in SIS mixer performance. The present paper is concerned with a general method of numerical analysis for SIS mixers which allows arbitrary terminating impedances for all the harmonic frequencies. This analysis provides an approach for an examination of the range of validity of the three-frequency results of the quantum mixer theory. The new method has been implemented with the aid of a Fortran computer program.

Hicks, R. G.↗

Low-noise 115-GHz receiver using superconducting tunnel junctions

A 110-118-GHz receiver based on a superconducting quasiparticle tunnel junction mixer is described. The single-sideband noise temperature is as low as 68 + or - 3 K. This is nearly twice the sensitivity of any other receiver at this frequency. The receiver was designed using a low-frequency scale model in conjunction with the quantum mixer theory. A scaled version of the receiver for operation at 46 GHz has a single-sideband noise temperature of 55 K. The factors leading to the success of this design are discussed.

Pan, S.-K.↗

Schottky diode mm detectors with improved sensitivity and dynamic range

A detector which features a low-barrier Si Schottky diode is discussed. The unbiased diode has a sensitivity of -60 dBm and a range of 50 dB at 95 GHz, and fixed tuning yields a sensitivity within 2 dB from 75-110 GHz. A limitation of the low-barrier diode is a reduction in the low-level sensitivity by 16 dB under a 100 kilohms load. Use of the diode with a video impedance of 120 kilohms enables the offset voltage to be nulled with an appropriate control. Operation of the diode in a waveguide mount for use as a mixer is described, along with detector rectification.

Kerr, A. R.↗

Observations of interstellar H2O emission at 183 gigahertz

Observations of the 183-GHz rotational transition of water vapor in interstellar molecular clouds are reported. The observations were made with a portable double-sideband superheterodyne radiometer used with the 91-cm Cassegrain telescope on board the Kuiper Airborne Observatory. An emission feature was detected in the direction of the Kleinmann-Low nebula in Orion with a peak antenna temperature of 15 K, a local standard of rest velocity of 8 km/sec, and a width of 15 km/sec. A plateau component of the emission profile is attributed to the 1-arcmin region characteristic of plateau emission from other observed molecules, with emission enhanced over that expected for thermal excitation, while the spike component observed is consistent with an optically thick source of the size of the molecular ridge in Orion at a temperature of 50 K and a column density greater than or equal to 3 x 10 to the 17th/sq cm, implying that H2O is one of the more abundant species in the Orion Molecular Cloud. Emission at 183 GHz was not detected in Sgr A, Sgr B2, W3, W43, W49, W51, DR 21, NGC 1333, NGC 7027, GL 2591 or the Rho Oph cloud; it may have been detected in M 17.

Waters, J. W.↗

Noise and loss in balanced and subharmonically pumped mixers. I - Theory. II - Application

The theory of noise and frequency conversion for two-diode balanced and subharmonically pumped mixers is presented. The analysis is based on the equivalent circuit of the Schottky diode, having nonlinear capacitance, series resistance, and shot and thermal noise. Expressions for the conversion loss, noise temperature, and input and output impedances are determined in a form suitable for numerical analysis. In Part II, the application of the theory to practical mixers is demonstrated, and the properties of some two-diode mixers are examined. The subharmonically pumped mixer is found to be much more strongly affected by the loop inductance than the balanced mixer, and the ideal two-diode mixer using exponential diodes has a multiport noise-equivalent network (attenuator) similar to that of the ideal single-diode mixer. It is concluded that the theory can be extended to mixers with more than two diodes and will be useful for their design and analysis, provided a suitable nonlinear analysis is available to determine the diode waveforms.

Kerr, A. R.↗

Aircraft search for millimeter-wavelength emission by stratospheric ClO

Three millimeter-wavelength transitions of ClO were searched for in the stratospheric emission spectrum during May-August 1977 using aircraft-based instruments. The measurements indicate that if stratospheric ClO has a vertical distribution of the form predicted by present photochemical models, then the ClO volume mixing ratio at the profile peak did not exceed 10 to the -9th at the time and place of the measurements. The observed spectra suggest the presence of ClO in the stratosphere but do not provide a definitive detection.

Waters, J. W.↗

A user oriented computer program for the analysis of microwave mixers, and a study of the effects of the series inductance and diode capacitance on the performance of some simple mixers

A user oriented computer program for analyzing microwave and millimeter wave mixers with a single Schottky barrier diode of known I-V and C-V characteristics is described. The program first performs a nonlinear analysis to determine the diode conductance and capacitance waveforms produced by the local oscillator. A small signal linear analysis is then used to find the conversion loss, port impedances, and input noise temperature of the mixer. Thermal noise from the series resistance of the diode and shot noise from the periodically pumped current in the diode conductance are considered. The effects of the series inductance and diode capacitance on the performance of some simple mixer circuits using a conventional Schottky diode, a Schottky diode in which there is no capacitance variation, and a Mott diode are studied. It is shown that the parametric effects of the voltage dependent capacitance of a conventional Schottky diode may be either detrimental or beneficial depending on the diode and circuit parameters.

Siegel, P. H.↗

The low-noise 115-GHz receiver on the Columbia-GISS 4-ft radio telescope

The superheterodyne millimeter-wave radiometer on the Columbia-GISS 4-ft telescope is described. This receiver uses a room-temperature Schottky diode mixer, with a resonant-ring filter as LO diplexer. The diplexer has low signal loss, efficient LO power coupling, and suppresses most of the LO noise at both sidebands. The receiver IF section has a parametric amplifier as its first stage with sufficient gain to overcome the second-stage amplifier noise. A broad-banded quarter-wave impedance transformer minimizes the mismatch between mixer and paramp. At 115 GHz, the SSB receiver noise temperature is 860 K, which is believed to be the lowest figure so far reported for a room-temperature receiver at this frequency.

Cong, H.-I.↗

Transport of majority and minority carriers in 2-micron-diameter Pt-GaAs Schottky barriers

An experimental study of small area (2-micron diameter) Pt-GaAs Schottky barrier diodes has been made, by using a wafer chip with a matrix of these diodes lying within approximately a minority carrier diffusion length of one another. Using one diode as collector and another as emitter, transistor measurements indicated that the dominant contribution to the current is the majority-carrier thermionic field emission current for large forward-bias voltage of the emitter junction (V-EB no less than about 0.4 V), whereas the smaller forward-bias (V-EB no greater than about 0.4 V) recombination in the space-charge region was most important. The minority carrier injection ratio is measurable only for large forward-bias voltages, decreasing from about 0.02 to 0.00001 as VEB increases from 0.5 to 1.0 V. The minority carrier diffusion length was measured to be about 1.3 microns. These results are of considerable significance for the understanding and optimization of the performance of these devices as classical detectors and mixers.

Chan, E. Y.↗

Shot-noise in resistive-diode mixers and the attenuator noise model

The representation of a pumped exponential diode, operating as a mixer, by an equivalent lossy network, is reexamined. It is shown that the model is correct provided the network has ports for all sideband frequencies at which (real) power flow can occur between the diode and its embedding. The temperature of the equivalent network is eta/2 times the physical temperature of the diode. The model is valid only if the series resistance and nonlinear capacitance of the diode are negligible. Expressions are derived for the input and output noise temperature and the noise-temperature ratio of ideal mixers. Some common beliefs concerning noise-figure and noise-temperature ratio are shown to be incorrect.

Kerr, A. R.↗

Contact Whiskers for Millimeter Wave Diodes

Several techniques are investigated for making short conical tips on wires (whiskers) used for contacting millimeter-wave Schottky diodes. One procedure, using a phosphoric and chromic acid etching solution (PCE), is found to give good results on 12 microns phosphor-bronze wires. Full cone angles of 60 degrees-80 degrees are consistently obtained, compared with the 15 degrees-20 degrees angles obtained with the widely used sodium hydroxide etch. Methods are also described for cleaning, increasing the tip diameter (i.e. blunting), gold plating, and testing the contact resistance of the whiskers. The effects of the whisker tip shape on the electrical resistance, inductance, and capacitance of the whiskers are studied, and examples given for typical sets of parameters.

Kerr, A. R.↗

Low-noise Josephson mixers at 115 GHz using recyclable point contacts

Thermally recyclable Nb point-contact Josephson junctions are investigated as low-noise mixers with an external local oscillator at 115 GHz. The best single sideband mixer noise temperature achieved is 140 (+ or - 20) K with a single sideband conversion loss of 2.4 (+ or - 0.5) dB. Such rugged junctions are suitable for use in practical receivers and should give unprecedented sensitivity at the shorter millimeter wavelengths.

Taur, Y.↗

Conversion loss and noise of microwave and millimeter-wave mixers. I - Theory. II - Experiment

The conversion loss and noise of microwave and millimeter-wave mixers are analyzed. Nonlinear capacitance, arbitrary embedding impedances, as well as shot, thermal and scattering noise arising in the diode, figure in the analysis. The anomalous mixer noise noted in millimeter-wave mixers by Kerr (1975) is shown to be explainable in terms of the correlation of down-converted components of the time-varying shot noise. A digital computer analysis of the conversion loss, noise, and output impedance of an 80-120-GHz mixer is also conducted.

Held, D. N.↗

Progress on millimeter wave Josephson junction mixers

Preset, recyclable Nb point contacts are tested as low-noise Josephson mixers at a signal frequency of 115 GHz. The best result achieved is a mixer noise temperature (single sideband) of 120 K with unity conversion efficiency (SSB) for a junction at 6 K. Variation of mixer properties with temperature and other parameters is presented.

Taur, Y.↗

A new mixer design for 140-220 GHz

A new Schottky-diode mixer is described which has low noise and conversion loss in the 140-220-GHz band. At 170 GHz mixer noise temperatures of 1100-1300 K have been measured, with 6.2-7.2-dB single sideboard conversion loss. The design should be usable up to about 300 GHz with appropriate scaling. The mixer has been successfully used in airborne radiometers on the NASA Convair 990 and C-141 aircraft.

Kerr, A. R.↗