Search NASA⌕ Search

Engineering topics

Kim, M. J.

Publications and source records attributed to Kim, M. J..

14 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Verification of a Monte Carlo binary collision model for simulating elastic and inelastic collisions in particle-in-cell simulations

We present the development and verification of a Monte Carlo binary collision model for simulating elastic and inelastic collisions in particle-in-cell simulations. We apply the corrected binary collision model originally developed for charged-particles collisions to all considered scattering channels, including Coulomb collisions, elastic neutral–neutral and charged–neutral collisions, ionization, excitation, and fusion. The model's implementation is described and verified through a series of simulations, including charged- and neutral-particle thermal equilibration, slowing of electrons in warm solid-density aluminum, collisional damping of a Langmuir wave, helium gas breakdown in an applied electric field, and thermonuclear and beam–target fusion. Then, we demonstrate the model within simulations of hydrogen plasma formation in the Princeton Field-Reversed Configuration as well as of the burning of aneutronic fusion fuel p-11B. The latter includes measurement of the fusion power density in a low-density plasma and fusion production due to the stopping of a proton ignitor beam in a compressed boron target.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2023

TexAT detector upgrade for 14 O($α$, $p$) 17 F cross section measurement

A direct cross-section measurement of the 14 O($α$, $p$) 17 F reaction is important to understand the light curves of x-ray bursts. The measurement will be performed using the Texas Active Target TPC version 2 (TexAT_v2). The TexAT_v2 aims at measuring lower energy protons from the reaction than the original TexAT. Newly developed silicon and CsI(Tl) detector arrays are added at the left, right and bottom of a modified field cage to increase its detection efficiency. Furthermore, this paper describes the overall specifications and two commissioning experiments performed at Texas A&M University.

14O(α, p)17F↗
DOE OSTI2023

Proton branching ratios in 22 Mg for X-ray bursts

Here, decay protons from 22 Mg energy levels populated through a previously reported 24 Mg(p, t) 22 Mg transfer reaction (Chae et al. in Phys Rev C 79:055804, 2009) have been analyzed for proton branching ratios as a follow-up analysis. The measurement was performed at the Holifield Radioactive Ion Beam Facility of Oak Ridge National Laboratory by utilizing 41-MeV proton beams and 24 Mg solid targets. Decay protons and reaction tritons were simultaneously detected with a silicon detector array. By investigating the 24 Mg(p, t) 22 Mg*(p) 21 Na channels, the proton branching ratios of five 22 Mg excited states were obtained. The measured branching ratios provide constraints on the proton partial widths of the populated 22 Mg levels, which have implications for X-ray burst nucleosynthesis.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗
DOE OSTI2021

Cosmic Ray Background Removal With Deep Neural Networks in SBND

In liquid argon time projection chambers exposed to neutrino beams and running on or near surface levels, cosmic muons, and other cosmic particles are incident on the detectors while a single neutrino-induced event is being recorded. In practice, this means that data from surface liquid argon time projection chambers will be dominated by cosmic particles, both as a source of event triggers and as the majority of the particle count in true neutrino-triggered events. In this work, we demonstrate a novel application of deep learning techniques to remove these background particles by applying deep learning on full detector images from the SBND detector, the near detector in the Fermilab Short-Baseline Neutrino Program. We use this technique to identify, on a pixel-by-pixel level, whether recorded activity originated from cosmic particles or neutrino interactions.

79 ASTRONOMY AND ASTROPHYSICS↗
DOE OSTI2021

First measurement of proton decay from a transfer reaction to 21 Na

Decay protons from excited states in Na 21 populated through a previously reported Mg 24 ( p , α ) Na 21 transfer reaction [Cha et al. , Phys. Rev. C 96 , 025810 (2017) ] were analyzed to extract the proton branching ratios of the energy levels. Additionally, by utilizing 31-MeV proton beams from the Holifield Radioactive Ion Beam Facility of Oak Ridge National Laboratory and isotopically enriched Mg 24 solid targets, the decay protons were detected in coincidence with α particles from the ( p , α ) reaction using a silicon strip detector array. Proton decay branching ratios of several Na 21 levels were deduced for the p 0 and p 1 decay channels to the ground and first excited states in Ne 20 , respectively.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗
DOE OSTI2020

Proton Decay of 21 Na for 20 Ne Energy Levels

The 24 Mg(p,α) 21 Na transfer reaction has been previously studied for a spectroscopic study of 21 Na. In this follow-up analysis, the proton decays of the excited states of the radionuclide 21 Na, which were measured simultaneously, are reported. By investigating the coincidence between the reaction α-particles and decay protons, we were able to identify three groups of events that are associated with the energy levels in 20 Ne. The 20 Ne excitation energy plot was obtained as a result. Here, the four lowest known energy levels in 20 Ne (the ground state and excited states at E x = 1.633, 4.247 and 4.966 MeV) were clearly observed.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗
DOE OSTI2020

Construction of precision wire readout planes for the Short-Baseline Near Detector (SBND)

The Short-Baseline Near Detector time projection chamber is unique in the design of its charge readout planes. These anode plane assemblies (APAs) have been fabricated and assembled to meet strict accuracy and precision requirements: wire spacing of 3 mm ± 0.5 mm and wire tension of 7 N ± 1 N across 3,964 wires per APA, and flatness within 0.5 mm over the 4 m × 2.5 m extent of each APA . Here, we describe the design, manufacture and assembly of these key detector components, with a focus on the quality assurance at each stage.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗
DOE OSTI2020

Measurement of the Li 7 ( γ , t ) He 4 ground-state cross section between E γ = 4.4 and 10 MeV

Here, the Li 7 ( γ , t ) He 4 ground state cross section was measured for the first time using monoenergetic γ rays with energies between 4.4 and 10 MeV at the High Intensity Gamma-ray Source. The reaction is important for the primordial Li problem and for testing our understanding of the mirror α -capture reactions H 3 ( α , γ ) Li 7 and He 3 ( α , γ ) Be 7 . Although over the last 30 years most measurements of the H 3 ( α , γ ) Li 7 reaction have concentrated in an energy range below E γ = 3.65 MeV, measurements at higher energies could potentially restrict the extrapolation to astrophysically important energies. The experimental arrangement for measuring the Li 7 ( γ , t ) He 4 reaction included a large-area silicon detector array and several beam characterization instruments. The experimental astrophysical S factor of H 3 ( α , γ ) calculated from the present data was fitted using the R -matrix formalism. The results are in disagreement with previous experimental measurements in the same energy range but the extrapolated S factor agrees with the potential model calculation and lower energy experimental data.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗
NASA NTRS1972

Development of chip passivated monolithic complementary MISFET circuits with beam leads

Fabrication method is described for alumina passivated silicon MISFET arrays. Technique involves total passivation beam-lead approach and provides completely sealed chip with double level interconnect capability. Refractory metal alloy is used to form interconnect system and obtain metal contacts that withstand temperatures of 873 K for short periods of time.

Ragonese, L. J.↗
NASA NTRS1972

Development of chip passivated monolithic complementary MISFET circuits with beam leads

The results are presented of a program to demonstrate the processes for fabricating complementary MISFET beam-leaded circuits, which, potentially, are comparable in quality to available bipolar beam-lead chips that use silicon nitride passivation in conjunction with a platinum-titanium-gold metal system. Materials and techniques, different from the bipolar case, were used in order to be more compatible with the special requirements of fully passivated complementary MISFET devices. Two types of circuits were designed and fabricated, a D-flip-flop and a three-input NOR/NAND gate. Fifty beam-leaded chips of each type were constructed. A quality and reliability assurance program was performed to identify failure mechanisms. Sample tests and inspections (including destructive) were developed to measure the physical characteristics of the circuits.

Ragonese, L. J.↗