Search NASA⌕ Search

Engineering topics

Kimbrough, B. S.

Publications and source records attributed to Kimbrough, B. S..

Comparison of Orbiter STS-2 development flight instrumentation data with thermal math model predictions

Thermal performance verification of Reusable Surface Insulation (RSI) has been accomplished by comparisons of STS-2 Orbiter Flight Test (OFT) data with Thermal Math Model (TMM) predictions. The OFT data was obtained from Development Flight Instrumentation RSI plug and gap thermocouples. Quartertile RSI TMMs were developed using measured flight data for surface temperature and pressure environments. Reference surface heating rates, derived from surface temperature data, were multiplied by gap heating ratios to obtain tile sidewall heating rates. This TMM analysis resulted in good agreement of predicted temperatures with flight data for thermocouples located in the RSI, Strain Isolation Pad, filler bar and structure.

Norman, I.↗

Arc-jet test and analysis of Orbiter TPS inter-tile heating in high pressure gradient flow

During entry of the Space Shuttle Orbiter, the convective heating within inter-tile gaps of the Thermal Protection System (TPS) material produces elevated tile sidewall temperatures in regions of high surface pressure gradient. Arc-jet tests have been conducted recently to obtain a measure of the gap heating down the TPS tile sidewalls at test conditions representative of Orbiter flight environments. The object of this paper is to present the gap heating correlations that were developed from a thermal analysis for 3-D curved and flat TPS tile segments. Predictions of gap sidewall temperature were obtained within 30 F of test data on both Wing Glove and Double Wedge models. Derived heating ratios were obtained for a range of test conditions (pressure, pressure gradient, enthalpy, boundary layer thickness, gap width, surface temperature, etc.). The results of the study, which showed that heating ratios varied with the pressure gradient times the square root of the surface pressure, are being used to provide an assessment of gap filler requirements on Orbiter forward fuselage/chine and wing glove regions.

Rochelle, W. C.↗