Search NASA⌕ Search

Engineering topics

Kirk, M A

Publications and source records attributed to Kirk, M A.

Synergetic effects of dual-beam implantation on the microstructural development in silicon

We report a synergy effect on the microstructural development of silicon specimens as a result of dual-beam high temperature irradiation/implantation. In situ transmission electron microscopy experiments using two different experimental setups have been used, where the primary 50 keV Co{sup +} ion implantation beam was supplemented with either a 300 keV electron beam or a 500 keV Si{sup +} ion beam. In both cases, the secondary beam intensity was such that both beams created comparable overall primary damage. Completely different microstructural response has been found in these two cases. An intensive electron irradiation was found to sharply accelerate the evolution of dislocation structure, only weakly affecting the disilicide kinetics. On the contrary, the Si ion beam weakly affected the kinetics of either dislocation loops or coherent CoSi{sub 2} precipitates, but drastically increased the number density of thermodynamically unstable semicoherent precipitates. Possible microstructural reasons for the observed effects and the implications for both dislocation loop and cobalt disilicide nucleation mechanisms in high-temperature implanted TEM samples are discussed and supported by detailed molecular dynamics calculations of annealing of cascade remnants produced by the energetic silicon recoils.

36 MATERIALS SCIENCE↗

Kr Ion Irradiation Study of the Depleted-Uranium Alloys

Fuel development for the Reduced Enrichment Research and Test Reactor program is tasked with the development of new low-enriched uranium nuclear fuels that can be employed to replace existing highly enriched uranium fuels currently used in some research reactors throughout the world. For dispersion-type fuels, radiation stability of the fuel/cladding interaction product has a strong impact on fuel performance. Three depleted uranium alloys are cast for the radiation stability studies of the fuel/cladding interaction product using Kr ion irradiation to investigate radiation damage from fission products. SEM analysis indicates the presence of the phases of interest: U(Si, Al)3, (U, Mo)(Si, Al)3, UMo2Al20, U6Mo4Al43, and UAl4. Irradiations of TEM disc samples were conducted with 500 keV Kr ions at 200ºC to ion doses up to 2.5 × 1015 ions/cm2 (~ 10 dpa) with an Kr ion flux of 1012 ions/cm2-sec (~ 4.0 × 10-3 dpa/sec). Microstructural evolution of the phases relevant to fuel-cladding interaction products was investigated using transmission electron microscopy.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗

In situ characterization of meals at extremes.

The fundamental processes taking place in metals under extreme conditions can occur on ultrafast timescales (i.e., nanoseconds to picoseconds), and yet their result can continue to have a significant impact on the structural properties for many years to follow. The challenge in developing in situ methods for characterization under extreme conditions therefore involves both the modification of the instrumentation to implement the high-temperature, strain, and radiation conditions and the definition of the timescale over which the measurement must be made. While techniques are well established for characterization of the long-term effects of extreme conditions, experiments are only just beginning to probe the initial stages of structural evolution. This article reviews recent developments in optical, x-ray, and electron probes of metals under extreme conditions and also discusses the needs for future experiments and potential pathways to achieving these goals.

36 MATERIALS SCIENCE↗

The temperature dependence of heavy-ion damage in iron: a microstructural transition at elevated temperatures.

A transition is reported in the dislocation microstructure of pure Fe produced by heavy-ion irradiation of thin foils, which took place between irradiation temperatures (T{sub irr}) of 300 C and 500 C. At T{sub irr} {le} 400 C, the microstructure was dominated by round or irregular non-edge dislocation loops of interstitial nature and with Burgers vectors b = 1/2 111, although interstitial 100 loops were also present; at 500 C only rectilinear pure-edge 100 loops occurred. At intermediate temperatures there was a gradual transition between the two types of microstructure. At temperatures just below 500 C, mobile 111 loops were seen to be subsumed by sessile 100 loops. A possible explanation of these observations is given.

36 MATERIALS SCIENCE↗

Vacancy defects in Fe : comparison between simulation and experiment.

The evolution of radiation damage under heavy-ion irradiation in thin foils of pure bcc Fe has been investigated by simulation and experiment. Simulations showed that vacancy loops are about as mobile as interstitial loops, and can be lost to the surface of a foil. Consistent with this, in situ real-time dynamic observations of the damage evolution showed that loops, many of which are believed to be of vacancy nature, were mobile and were often lost during irradiation. Atomistic simulations of vacancy defects in Fe showed that spherical voids, rather than vacancy loops, represent the lowest energy configurations for clusters of vacancies of any size. The simulations also indicated that the stability of loops strongly varies depending on their size. Closed loops above a critical diameter ({approx}2 nm) are highly metastable due to the difficulty of their transformation into voids. The greater stability of voids explains why the loop yield in Fe and other ferritic materials is very low.

36 MATERIALS SCIENCE↗

In-situ TEM and ion iradiation of ferritic materials.

The intermediate voltage electron microscope-tandem user facility in the Electron Microscopy Center at Argonne National Laboratory is described. The primary purpose of this facility is electron microscopy with in situ ion irradiation at controlled sample temperatures. To illustrate its capabilities and advantages a few results of two outside user projects are presented. The motion of dislocation loops formed during ion irradiation is illustrated in video data that reveals a striking reduction of motion in Fe-8%Cr over that in pure Fe. The development of extended defect structure is then shown to depend on this motion and the influence of nearby surfaces in the transmission electron microscopy thin samples. In a second project, the damage microstructure is followed to high dose (200 dpa) in an oxide dispersion strengthened ferritic alloy at 500 C, and found to be qualitatively similar to that observed in the same alloy neutron irradiated at 420 C.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Dynamic observations of heavy-ion damage in Fe and Fe-Cr alloys.

We give an overview and summary of recent in-situ heavy-ion irradiation experiments on Fe and Fe-Cr alloys carried out on the Argonne IVEM Facility at irradiation temperatures up to 500 C. Several new and unexpected observations were made. At low doses the contrast of new irradiation-induced dislocation loops sometimes developed over time intervals as long as 0.2 s, many orders of magnitude longer than expected for a process of cascade collapse. In addition at temperatures {le} 300 C, 'hopping' of 1/2<111> loops was induced by the ion or electron beams, especially in UHP Fe. At high doses complex microstructures developed in all materials, involving the formation of large interstitial loops. At 300 C and RT these loops had Burgers vectors of type b = 1/2<111> and large shear components. At 500 C only edge loops with b = <100> were produced.

36 MATERIALS SCIENCE↗