Search NASA⌕ Search

Engineering topics

Kissel, R.

Publications and source records attributed to Kissel, R..

4 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1992

Taguchi methods in electronics: A case study

Total Quality Management (TQM) is becoming more important as a way to improve productivity. One of the technical aspects of TQM is a system called the Taguchi method. This is an optimization method that, with a few precautions, can reduce test effort by an order of magnitude over conventional techniques. The Taguchi method is specifically designed to minimize a product's sensitivity to uncontrollable system disturbances such as aging, temperature, voltage variations, etc., by simultaneously varying both design and disturbance parameters. The analysis produces an optimum set of design parameters. A 3-day class on the Taguchi method was held at the Marshall Space Flight Center (MSFC) in May 1991. A project was needed as a follow-up after the class was over, and the motor controller was selected at that time. Exactly how to proceed was the subject of discussion for some months. It was not clear exactly what to measure, and design kept getting mixed with optimization. There was even some discussion about why the Taguchi method should be used at all.

Kissel, R.↗
NASA NTRS1985

Hardware math for the 6502 microprocessor

A floating-point arithmetic unit is described which is being used in the Ground Facility of Large Space Structures Control Verification (GF/LSSCV). The experiment uses two complete inertial measurement units and a set of three gimbal torquers in a closed loop to control the structural vibrations in a flexible test article (beam). A 6502 (8-bit) microprocessor controls four AMD 9511A floating-point arithmetic units to do all the computation in 20 milliseconds.

Kissel, R.↗
NASA NTRS1975

Accelerations experienced during low-G flight of Black Brant VC (NAS 21.015) on 4 October 1974

This investigation was to determine whether a Black Brant VC (BBVC) sounding rocket equipped with the Goddard Space Flight Center (GSFC) rate control system (RCS) would produce g-levels which are satisfactory for space processing. Accelerations measured by the Marshall Space Flight Center (MSFC) low-g accelerometer system (LGAS) were compared with accelerations calculated from measured payload RCS gyro data during a low-g flight of BBVC NAS 21.015 at White Sands Missile Range, N.M., on October 4, 1974. Accelerations of up to 0.0002 g existed at the LGAS accelerometers from 70 through 420 sec (5.8 min), with the exception of a spike at 101 sec of 0.0004 g which occurred when the RCS was activated the second time. Accelerations of 0.0001 g existed from 140 through 400 sec (4.3 min). Accelerations of 0.0002 g along the roll axis up to 150 sec and of 0.0015 g in the lateral plane at about 135 sec are being investigated by GSFC. They may be associated with leaking thruster valves or a leak in one of the heat pipe experiments. The vehicle rate buildup each time after the RCS nulls out are also being investigated by GSFC. This rate caused most of the 0.0001 g acceleration experienced after 150 sec into the flight. Aerodynamic drag produced no significant accelerations after about 80 sec. The principal conclusion was that the BBVC with the GSFC RCS produces g-levels satisfactory for space processing.

Kissel, R.↗