Engineering topics

Kitaplioglu, C.

Publications and source records attributed to Kitaplioglu, C..

5 records

NASA NTRS2000

Blade-Vortex Interaction of an Isolated Full-Scale XV-15 Tilt-Rotor

Blade-vortex interaction noise of an isolated full-scale XV-15 tilt-rotor was investigated in the NASA Ames 80- by 120-Foot Wind Tunnel. The objective was to establish the baseline BVI noise signature of a fullscale tilt-rotor and to investigate several noise reduction concepts, including blade-tip subwings, reduced tip Mach number, and the addition of a fourth blade to the rotor system. At the nominal tip Mach number of 0.691, the peak BVI levels were found to occur at a tip-path-plane angle of 4-deg and at the highest advance ratio tested of 0.2. The BVI noise levels were found to be weakly dependent on CT/s. As would be expected, reducing tip Mach number, either of the baseline 3-blade rotor, or in conjunction with a 4-blade rotor, was found to be an effective way to significantly reduce noise. The addition of the tested subwings did not seem to be an effective strategy for noise reduction, and they incurred a performance penalty.

AEROMECHANICS↗

NASA NTRS1995

A study of blade-vortex interaction aeroacoustics utilizing an independently generated vortex

This paper presents results from an experimental study of rotor blade-vortex interaction (BVI) aerodynamics and acoustics. The experiment utilized an externally generated vortex interacting with a two-bladed rotor operating at zero thrust to minimize the influence of the rotor's own wake. The rotor blades were instrumented with a total of 60 absolute pressure transducers at three spanwise and ten chordwise stations on both the upper and lower surfaces. Acoustic data were obtained with fixed near-field microphones as well as a movable array of far-field microphones. The test was carried out in the acoustically treated test section of the NASA Ames 80- by 120-foot Wind Tunnel. Several parameters which influences BVI, such as vortex-rotor separation distance, vortex strength, and vortex sense (swirl direction), as well as rotor tip Mach number and advance ratio, were varied. Simultaneous measurements were obtained of blade surface pressure distributions, near-field acoustics, and far-field acoustics during the vortex-blade encounters.

Kitaplioglu, C.↗

NASA NTRS1986

A study of helicopter main rotor noise in hover

Some fundamental aspects of rotor noise generation and radiation are presented. Data on which the study is based were obtained during a hover test at the NASA Ames Outdoor Aerodynamic Research Facility of a one-sixth-scale, four-bladed, helicopter rotor. The test site provided an open environment ideal for acquiring good acoustic data. Information is presented on the delineation between the acoustic near-field and far-field, and on the effect of a simple boundary-layer trip device. Data obtained at near-zero thrust conditions indicate that it is possible to isolate thickness noise with minimum contamination by loading noise effects. An abrupt change in the nature of the emitted noise at high-thrust conditions is investigated and is related to unsteady wake/support interaction.

Kitaplioglu, C.↗

NASA NTRS1986

Scaling of helicopter main rotor noise in hover

A 2.1-m-diam, one-sixth-scale model helicopter main rotor was tested in hover at the NASA Ames Outdoor Aerodynamic Research Facility. It had previously been tested in hover in the NASA Ames 40- by 80-Foot Wind Tunnel test section. The primary objective of the tests was to obtain acoustic and performance data on a medium-scale rotor at various thrust coefficients and tip Mach numbers to compare to similar existing data on a full-scale helicopter main rotor. Information is presented on the effects of thrust- and tip-speed variation, the effects of boundary-layer trip strips, and the effects of wind conditions. In addition, a preliminary evaluation of the scaling of helicopter main-rotor noise in hover is presented. A secondary objective was to contribute to a data base that will permit the estimation of facility effects on acoustic testing.

Kitaplioglu, C.↗

NASA NTRS1985

Hover and forward flight acoustics and performance of a small-scale helicopter rotor system

A 2.1-m diam., 1/6-scale model helicopter main rotor was tested in hover in the test section of the NASA Ames 40- by 80- Foot Wind Tunnel. Subsequently, it was tested in forward flight in the Ames 7- by 10-Foot Wind Tunnel. The primary objective of the tests was to obtain performance and noise data on a small-scale rotor at various thrust coefficients, tip Mach numbers, and, in the later case, various advance ratios, for comparisons with similar existing data on full-scale helicopter rotors. This comparison yielded a preliminary evaluation of the scaling of helicopter rotor performance and acoustic radiation in hover and in forward flight. Correlation between model-scale and full-scale performance and acoustics was quite good in hover. In forward flight, however, there were significant differences in both performance and acoustic characteristics. A secondary objective was to contribute to a data base that will permit the estimation of facility effects on acoustic testing.

Kitaplioglu, C.↗