Search NASA⌕ Search

Engineering topics

Knepper, D. H.

Publications and source records attributed to Knepper, D. H..

9 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1976

Application of LANDSAT data to delimitation of avalanche hazards in Montane, Colorado

The author has identified the following significant results. With rare exceptions, avalanche areas cannot be identified on LANDSAT imagery. Avalanche hazard mapping on a regional scale is best conducted using LANDSAT imagery in conjunction with complementary data sources. Level of detail of such maps will be limited by the amount and completeness of the complementary information used.

Knepper, D. H.↗
NASA NTRS1976

Application of LANDSAT data to delimitation of avalanche hazards in Montane, Colorado

The author has identified the following significant results. Photointerpretation of individual avalanche paths on single band black and white LANDSAT images is greatly hindered by terrain shadows and the low spatial resolution of the LANDSAT system. Maps produced in this way are biased towards the larger avalanche paths that are under the most favorable illumination conditions during imaging; other large avalanche paths, under less favorable illumination, are often not detectable and the smaller paths, even those defined by sharp trimlines, are only rarely identifiable.

Knepper, D. H.↗
NASA NTRS1975

Geologic and mineral and water resources investigations in western Colorado, using Skylab EREP data

The author has identified the following significant results. Skylab photographs are superior to ERTS images for photogeologic interpretation, primarily because of improved resolution. Lithologic contacts can be detected consistently better on Skylab S190A photos than on ERTS images. Color photos are best; red and green band photos are somewhat better than color-infrared photos; infrared band photos are worst. All major geologic structures can be recognized on Skylab imagery. Large folds, even those with very gentle flexures, can be mapped accurately and with confidence. Bedding attitudes of only a few degrees are recognized; vertical exaggeration factor is about 2.5X. Mineral deposits in central Colorado may be indicated on Skylab photos by lineaments and color anomalies, but positive identification of these features is not possible. S190A stereo color photography is adequate for defining drainage divides that in turn define the boundaries and distribution of ground water recharge and discharge areas within a basin.

Lee, K.↗
NASA NTRS1975

Application of LANDSAT data to delimitation of avalanche hazards in Montane Colorado

The author has identified the following significant results. Interpretation of small scale LANDSAT imagery provides a means for determining the general location and distribution of avalanche paths. The accuracy and completeness of small scale mapping is less than is obtained from the interpretation of large scale color infrared photos. Interpretation of enlargement prints (18X) of LANDSAT imagery is superior to small scale imagery, because more detailed information can be extracted and annotated.

Knepper, D. H.↗
NASA NTRS1975

Geological significance of features observed in Colorado from orbital altitudes

Three major investigations using LANDSAT and Skylab imagery concerned with analyses of color anomalies and linear features of central Colorado are discussed. The studies conducted are concerned with the geological significance of spectral and spatial features on the images. Color anomalies in Skylab photographs were analyzed and evaluated for locating indicators of mineralization. The relationships were determined of all linear features in a LANDSAT image to the rock joint systems and the detectable larger geologic structures; techniques for extracting that geologic information are indicated. Some anomalous megalinear features in LANDSAT and Skylab images are analyzed which transect major structures and, their associated geologic features are described.

Sawatzky, D. L.↗
NASA NTRS1974

Geologic and mineral and water resources investigations in western Colorado using ERTS-1 data

The author has identified the following significant results. Most of the geologic information in ERTS-1 imagery can be extracted from bulk processed black and white transparencies by a skilled interpreter using standard photogeologic techniques. In central and western Colorado, the detectability of lithologic contacts on ERTS-1 imagery is closely related to the time of year the imagery was acquired. Geologic structures are the most readily extractable type of geologic information contained in ERTS images. Major tectonic features and associated minor structures can be rapidly mapped, allowing the geologic setting of a large region to be quickly accessed. Trends of geologic structures in younger sedimentary appear to strongly parallel linear trends in older metamorphic and igneous basement terrain. Linears and color anomalies mapped from ERTS imagery are closely related to loci of known mineralization in the Colorado mineral belt.

Knepper, D. H.↗
NASA NTRS1974

Geologic information from satellite images

Extracting geologic information from ERTS and Skylab/EREP images is best done by a geologist trained in photo-interpretation. The information is at a regional scale, and three basic types are available: rock and soil, geologic structures, and landforms. Discrimination between alluvium and sedimentary or crystalline bedrock, and between units in thick sedimentary sequences is best, primarily because of topographic expression and vegetation differences. Discrimination between crystalline rock types is poor. Folds and fractures are the best displayed geologic features. They are recognizable by topographic expression, drainage patterns, and rock or vegetation tonal patterns. Landforms are easily discriminated by their familiar shapes and patterns. Several examples demonstrate the applicability of satellite images to tectonic analysis and petroleum and mineral exploration.

Lee, K.↗