Search NASA⌕ Search

Engineering topics

Kodama, Ryosuke

Publications and source records attributed to Kodama, Ryosuke.

Observation of high-pressure polymorphs in bulk silicon formed at relativistic laser intensities

Silicon polymorphs with exotic electronic and optical properties have recently attracted significant attention due to their wide range of useful band gap characteristics. They are typically formed by static high-pressure techniques, which limits the crystal structures that can be made. This constitutes a major obstacle to study these polymorphs and their incorporation into existing technology. Approaches have attempted to address this shortcoming through using dynamic conditions and chemical precursor materials. Here, we report on an approach to create unusual crystal structures deep in the bulk of a silicon crystal by irradiating it with a laser pulse at ultrarelativistic intensity of up to 7.5 × 10 19 W/ c m 2 . Laser-generated electrons with MeV energy swiftly penetrate the target with speed close to the speed of light and deposit their energy into a large volume across the whole thickness of the sample. The relativistic electron current creates, via branching propagation and ionization, high-energy-density conditions for thermodynamically nonequilibrium phase transformation paths into new crystal polymorphs. X-ray microdiffraction and synchrotron x-ray diffraction analyses indicate, along with conventional dc-Si, the presence of exotic silicon structures in the bulk of the laser intact target volume. These structures are identified as body-centered bc8-Si, rhombohedral r8-Si, hexagonal-diamond hd-Si, and the tetragonal Si-VIII, all phases of Si that have previously been made through static techniques. Additionally, simple-tetragonal st12-Si and body-centered tetragonal bt8-Si were observed along with signatures of not yet identified diffraction spots. Both st12-Si and bt8-Si have only been observed in ultrafast laser microexplosion conditions at much lower laser intensity ∼ 10 14 W/ c m 2 and within a micron-thin surface layer. The findings here are supported by direct observation of nanoparticles with high-resolution transmission electron microscopy and corresponding fast Fourier transform analysis of their interatomic distances. The presented analyses of absorbed laser energy, generation of the MeV electron current, and deposition of energy across the whole target thickness provide a solid basis for drawing the conclusion that the observed silicon polymorphs were produced because of laser-generated high-energy electrons fast-penetrating deeply into the bulk of silicon. In contrast to solid-solid transformations, the plasma-solid transitions offer a paradigm for the creation of exotic, high-energy density materials inside the bulk of the sample by using laser pulses at relativistic intensities. Published by the American Physical Society 2024

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Static and shock compression studies of eutectic high-entropy alloy AlCoCrFeNi 2.1 to ultrahigh pressures

The high-entropy alloy with composition AlCoCrFeNi 2.1 , additively manufactured with the laser powder-bed fusion technique, has a far-from-equilibrium BCC/FCC eutectic nanolamellar structure. We studied the high-pressure response of this alloy under both static compression and high-strain rate shock compression. The response to static compression using a diamond anvil cell was studied at pressures up to 302 GPa with synchrotron x-ray diffraction at the advanced photon source. The high-pressure FCC-only phase of the EHEA previously observed by Pope et al. [AIP Adv. 13, 035124 (2023)] is found to be stable up to the highest pressure achieved in this study with a volume compression of V/V 0 = 0.587 at ambient temperature. The shock experiments were performed by using GEKKO XII lasers at the Institute of Laser Engineering, Osaka University. The principal Hugoniot equation-of-state of the EHEA was measured up to a pressure of 515 GPa and a compression of V/V 0 = 0.613. Additionally, the thermal equation of state of the EHEA was measured up to 6.2 GPa and 1623 K using a large-volume Paris–Edinburgh cell to obtain the temperature dependence of bulk modulus and thermal expansion coefficients. The melting temperature for EHEA AlCoCrFeNi 2.1 at a pressure of 5.6 GPa was measured to be 1648 ± 25 K. These results can be used to refine stochastic (or special) quasi-random structure (SQS) models for high-pressure high-temperature behavior of high-entropy alloys.

36 MATERIALS SCIENCE↗

Transonic dislocation propagation in diamond

Here, the motion of line defects (dislocations) has been studied for more than 60 years, but the maximum speed at which they can move is unresolved. Recent models and atomistic simulations predict the existence of a limiting velocity of dislocation motion between the transonic and subsonic ranges at which the self-energy of dislocation diverges, though they do not deny the possibility of the transonic dislocations. We used femtosecond x-ray radiography to track ultrafast dislocation motion in shock-compressed single-crystal diamond. By visualizing stacking faults extending faster than the slowest sound wave speed of diamond, we show the evidence of partial dislocations at their leading edge moving transonically. Understanding the upper limit of dislocation mobility in crystals is essential to accurately model, predict, and control the mechanical properties of materials under extreme conditions.

36 MATERIALS SCIENCE↗