Engineering topics
Koga, T
Publications and source records attributed to Koga, T.
Directed Self-assembly of Nanoparticles at the Polymer Surface by Highly Compressible Supercritical Carbon Dioxide
We report a versatile route for self-assembly of polymer-soluble nanoparticles at the polymer surface using highly compressible supercritical carbon dioxide (scCO{sub 2}). Polystyrene and poly(methyl methacrylate)-based nanocomposite thin films with functionalized polyhedral oligomeric silsesquioxane and phenyl C{sub 61} butyric acid methyl ester nanoparticles were prepared on Si substrates and exposed to scCO{sub 2} at different pressures under the isothermal condition of 36 C. The resultant structures could be then preserved by the vitrification process of the glassy polymers via quick pressure quench to atmospheric pressure and subsequently characterized by using various surface sensitive experimental techniques in air. We found that the surface segregation of these nanoparticles is induced in the close vicinity of P = 8.2 MPa where the excess absorption of the fluid into the polymers maximizes. However, when the film thickness becomes less than about 4R{sub g} thick (where R{sub g} is the radius of polymer gyration), the uniform dispersion of the nanoparticles is favorable instead even at the same CO{sub 2} conditions. We clarify that the phase transition is correlated with the emergence of a concentration gradient of the fluid at the polymer/CO{sub 2} interface and is a general phenomenon for different polymer-nanoparticle interactions.
Encapsulation of Polythiophene by Glycopolymer for Water Soluble Nano-wire
A water-soluble polythiophene (PT) was prepared by the self-assembling complex with a glycopolymer. The glycopolymer of poly(N-p-vinylbenzyl-D-lactonamide) (PVLA) formed self-assembling cylindrical structure based on the amphiphilicity even after the complexation with PT. We confirmed the improved optical functionality of PT due to the longer conjugated {pi}-orbital. It suggested that PT behaved like molecular nanowire with the self-assembled structure in the hydrophobic core of PVLA. PVLA-PT also showed specific biorecognition against corresponding lectin. These results suggested that the bioactive nanowire formation of PT with the glycopolymer was developed.
Weak localization/antilocalization in a nearly symmetric In{sub 0.53}Ga{sub 0.47}As/In{sub 0.52}Al{sub 0.48}As quantum well
We report weak antilocalization (WAL) measurements in a nearly symmetric In{sub 0.53}Ga{sub 0.47}As/In{sub 0.52}Al{sub 0.48}As quantum well. In this system, an enhancement of the spin-orbit scattering time, equivalently the weakening of the WAL effect, is expected at carrier densities N{sub s} where equal magnitudes between the Rashba and Dresselhaus parameters ({alpha} = {+-}{beta}) are realized. Our magnetotransport measurements indeed exhibited a weakening of the WAL effect as a function of N{sub s}, though the weakening took place at only one carrier density. Our interpretation is that the value of {beta} is so small that the two carrier densities corresponding to {alpha} = {beta} and {alpha} = -{beta} are very close to each other. It turned out that the deduced values for the bulk Dresselhaus parameter {gamma} in In{sub 0.53}Ga{sub 0.47}As/In{sub 0.52}Al{sub 0.48}As quantum wells is considerably smaller than the k{center_dot}p value of 27 eVA{sup 3}.
Impact of an Irreversibly Adsorbed Layer on Local Viscosity of Nanoconfined Polymer Melts
Not Available
Immobilized Polymer Layers on Spherical Nanoparticles
Polymer properties, such as their mechanical strength, barrier properties, and dielectric response, can be dramatically improved by the addition of nanoparticles. This improvement is thought to be because the surface area per unit mass of particles increases with decreasing particle size, R, as 1/R. This favorable effect has to be reconciled with the expectation that at small enough R the nanoparticles must behave akin to a solvent and cause a deterioration of properties. How does this transition in behavior from large solutes to the solvent limit occur? We conjecture that for small enough particles the layer of polymer affected by the particles ('bound' polymer layer) must be much smaller than that for large particles: the favorable effect of increasing particle surface area can thus be overcome and lead to the small solvent limit with unfavorable mechanical properties, for example. To substantiate this picture requires that we measure and compare the 'bound polymer layer' formed on nanoparticles with those near large particles with equivalent chemistry. We have implemented a novel strategy to obtain uniform nanoparticle dispersion in polymers, a problem for many previous works. Then, by combining theory and a suite of experimental techniques, including differential scanning calorimetry and positron annihilation lifetime spectroscopy, we show that the immobilized poly(2-vinylpyridine) layer near 15 nm diameter silica particles ({approx}1 nm) is considerably thinner than that at flat silica surfaces ({approx}4 to 5 nm), which is the limit of an infinitely large particle. We have also determined that the changes in the polymer's glass-transition temperature due to the presence of this strongly interacting surface are very small in both well-dispersed nanocomposites and thin films (<100 nm). Similarly, the polymer's fragility, as determined by dielectric spectroscopy, is also found to be little affected in the nanocomposites relative to the pure polymer. While a systematic study of the dependence of the bound polymer layer thickness on particle size remains an outstanding challenge, this first study provides conclusive evidence for the hypothesis that the bound polymer layer can be significantly smaller around nanoparticles than at chemically similar flat surfaces.