Search NASA⌕ Search

Engineering topics

Konopka, W.

Publications and source records attributed to Konopka, W..

4 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1979

Validation of scramjet exhaust simulation technique at Mach 6

Current design philosophy for hydrogen-fueled, scramjet-powered hypersonic aircraft results in configurations with strong couplings between the engine plume and vehicle aerodynamics. The experimental verification of the scramjet exhaust simulation is described. The scramjet exhaust was reproduced for the Mach 6 flight condition by the detonation tube simulator. The exhaust flow pressure profiles, and to a large extent the heat transfer rate profiles, were then duplicated by cool gas mixtures of Argon and Freon 13B1 or Freon 12. The results of these experiments indicate that a cool gas simulation of the hot scramjet exhaust is a viable simulation technique except for phenomena which are dependent on the wall temperature relative to flow temperature.

Hopkins, H. B.↗
NASA NTRS1976

Validation of scramjet exhaust simulation technique

Scramjet/airframe integration design philosophy for hypersonic aircraft results in configurations having lower aft surfaces that serve as exhaust nozzles. There is a strong coupling between the exhaust plume and the aerodynamics of the vehicle, making accurate simulation of the engine exhaust mandatory. The experimental verification of the simulation procedure is described. The detonation tube simulator was used to produce an exact simulation of the scramjet exhaust for a Mach 8 flight condition. The pressure distributions produced by the exact exhaust flow were then duplicated by a cool mixture Argon and Freon 13B1. Such a substitute gas mixture validated by the detonation tube technique could be used in conventional wind tunnel tests. The results presented show the substitute gas simulation technique to be valid for shockless expansions.

Hopkins, H. B.↗
NASA NTRS1972

The simulation of high pressure hydrogen/oxygen rocket engines.

Initial experiments have established the feasibility of using a backward running detonation wave in a shock tube to produce the correct enthalpy and chemistry of the simulated combustion chamber gases. This technique produces plume Reynolds numbers higher than those achievable by any other known technique. The practical pressure limitations are being explored and detailed surveys of both single and multiple engine plumes and impingement data on a cylindrical body are being obtained. Facility details to allow safe handling of the high pressure hydrogen and oxygen up to a design chamber pressure of 20,000 psi are described.

Hopkins, H.↗