Engineering topics

Korinko, P. S.

Publications and source records attributed to Korinko, P. S..

3 records

DOE OSTI2018

Wire Arc Additive Manufacturing

Project highlight. This project designs and implements a new additive manufacturing capability at Savannah River National Laboratory. Wire Arc Additive Manufacturing is an Advanced Manufacturing technology that enables materials and energy savings by producing materials that are in near net shapes to minimize material losses compared to conventional forging and machining techniques. Wire arc additive manufacturing is an evolving technology that can be used to fabricate large components with significantly less materials waste than conventional processing. This project includes an engineering model, an aspect that is largely overlooked in the Additive Manufacturing modeling work where the emphasis has been on mechanistic and microscopic modeling, to estimate the residual stresses and distortions. The Abaqus Weld Interface software coupled with user subroutines in Fortran enable the local cooling rates to be estimated to provide a coarse scale model for the secondary dendrite arm spacing, a parameter useful to estimate mechanical properties.

36 MATERIALS SCIENCE↗

DOE OSTI2018

Defense Waste Processing Facility Canister Closure Weld Current Validation Testing

Two closure welds on filled Defense Waste Processing Facility (DWPF) canisters failed to be within the acceptance criteria in the DWPF operating procedure SW4-15.80-2.3 (1). In one case, the weld heat setting was inadvertently provided to the canister at the value used for test welds (i.e., 72%) and this oversight produced a weld at a current of nominally 210 kA compared to the operating procedure range (i.e., 82%) of 240 kA to 263 kA. The second weld appeared to experience an instrumentation and data acquisition upset. The current for this weld was reported as 191 kA. Review of the data from the Data Acquisition System (DAS) indicated that three of the four current legs were reading the expected values, approximately 62 kA each, and the fourth leg read zero current. Since there is no feasible way by further examination of the process data to ascertain if this weld was actually welded at either the target current or the lower current, a test plan was executed to provide assurance that these Nonconforming Welds (NCWs) meet the requirements for strength and leak tightness. Acceptance of the welds is based on evaluation of Test Nozzle Welds (TNW) made specifically for comparison. The TNW were nondestructively and destructively evaluated for plug height, heat tint, ultrasonic testing (UT) for bond length and ultrasonic volumetric examination for weld defects, burst pressure, fractography, and metallography. The testing was conducted in agreement with a Task Technical and Quality Assurance Plan (TTQAP) (2) and applicable procedures.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

DOE OSTI2017

Evaluation of korzincalloy prepared by Hohman Plating

A commercial vendor, Hohman Plating performed contract engineering work to determine the feasibility of producing pin hole free KorZincAlloy bronze material used for zinc gettering. Samples were tested for Sn plating thickness, heat treatability, and chemistry prior to being subjected to a standardized zinc exposure. The samples absorbed zinc and were examined using visual and scanning electron microscopy. Hohman Plating successfully produced KZA that met the target composition, was pin hole free, and was an effective zinc getter.

36 MATERIALS SCIENCE↗