Search NASA⌕ Search

Engineering topics

Korotkov, A

Publications and source records attributed to Korotkov, A.

Upgrade of the lithium beam diagnostic at JET

A 60 kV neutral Li beam is injected into the edge plasma of JET to measure the electron density. The beam observation system has been improved by replacing a Czerny-Turner spectrometer with a high-resolution transmission-grating spectrometer and a fast back-illuminated frame-transfer camera. The larger throughput of the spectrometer, the increased sensitivity, and the faster readout of the new camera allow inter-ELM (edge localized mode) measurements (frame rate of 100 Hz). The calibration of the setup, as well as an improved spectral fitting technique in the presence of carbon background radiation, is discussed in detail. The density calculation is based on a statistical analysis method. Results are presented for different plasma scenarios.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Characterization of the Li beam probe with a beam profile monitor on JET

The lithium beam probe (LBP) is widely used for measurements of the electron density in the edge plasma of magnetically confined fusion experiments. The quality of LBP data strongly depends on the stability and profile shape of the beam. The main beam parameters are as follows: beam energy, beam intensity, beam profile, beam divergence, and the neutralization efficiency. For improved monitoring of the beam parameters, a beam profile monitor (BPM) from the National Electrostatics Corporation (NEC) has been installed in the Li beam line at JET. In the NEC BPM, a single grounded wire formed into a 45 deg. segment of a helix is rotated by a motor about the axis of the helix. During each full revolution, the wire sweeps twice across the beam to give X and Y profiles. In this paper, we will describe the properties of the JET Li beam as measured with the BPM and demonstrate that it facilitates rapid optimization of the gun performance.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Observation of Confined Current Ribbon in JET Plasmas

We report the identification of a localized current structure inside the JET plasma. It is a field-aligned closed helical ribbon, carrying current in the same direction as the background current profile (cocurrent), rotating toroidally with the ion velocity (corotating). It appears to be located at a flat spot in the plasma pressure profile, at the top of the pedestal. The structure appears spontaneously in low density, high rotation plasmas, and can last up to 1.4 s, a time comparable to a local resistive time. It considerably delays the appearance of the first edge localized mode.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

H-mode access on JET and Implications for ITER

One of the critical issues for ITER is access to an H-mode regime with good confinement, H98 = 1. The most basic scaling laws for power threshold for the L H transition, Pth, take the variation with plasma density, magnetic field and plasma size into account. However, the large variations in the Pth data from the values estimated with such simple scaling laws indicate other underlying dependencies. Another important consideration for ITER is that H-modes with higher values of energy confinement factors are often obtained with input power values much greater than Pth. This paper presents results from recent studies on JET to assess possible hidden variables for H-mode access over a wide range of plasma conditions. Experimental results demonstrate that sensitivity to the magnetic shaping and divertor geometry could account for some of the scatter in the international power threshold database. Hysteresis in the L H transition Pth has been studied in detail for the first time on JET by comparing values of Pth at the forward and back H-mode transitions over a range of densities. The impact of the edge plasma rotation on H-mode access has also been considered on JET with a toroidal field ripple scan across the L H and H L transitions. Finally, the total input power required relative to the measured value of Pth for access to a steady-state H-mode with H98 = 1 has been examined for a highly shaped magnetic configuration. The implications of these results for the attainment of H-mode with good confinement on ITER are discussed.

plasma h-mode↗