Engineering topics

Kramer, Gerrit J.

Publications and source records attributed to Kramer, Gerrit J..

3 records

DOE OSTI2020

Simulation of the eigenmode spectrum below the Toroidicity-induced Alfvén Eigenmode gap generated by the coupling of Alfvén and slow-magnetosonic waves in tokamaks

The discrete Alfven Eigenmode spectrum below the TAE frequency is studied for hybrid and sawtooth scenarios in tokamaks whereby the full coupling between the Alfven and slow magnetosonic waves are taken into account. In this frequency regime the ususally applied slow-sound approximation is not valid and modes in this frequency regime were recently called Alfven-Slow Eigenmodes (ASE). For the hybrid scenarios (central q ≈ 2 up to ρ ≈ 0.6) a rich spectrum of eigenmodes was found that depend on the plasma pressure and magnetic shear. It was found that the number of modes below the TAE gap is the highest for weakly reversed q~profiles while the number of modes increases with pressure. For zero central shear q-profiles the number of modes is lower than in the reversed shear case while for the normal shear hybrid q-profiles the number of eigenmode first increased with increasing pressure followed by a decrease in the number of eigenmodes. For plasma scenarios with central q < 1 (sawtoothing plasmas) modes were found outside the q=1 surface that are consistent with observations in contrast to the conventional BAE which located at the q=1 surface. The frequency behaviour of the modes below the TAE gap was studied for a reversed shear q-profile in which q_min was varied and it was found that ASEs increase and/or decrease in frequency as function of q_min thereby emerging from and/or disappearing into the continuum.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2020

Full-orbit simulations of fast-ion charge-exchange losses induced by neutral particles outside the plasma last closed flux surface

The interaction between neutrals outside tokamak plasmas and fast ions that are generated by neutral beam injection and pass outside the plasma is studied. It is shown that at beam energies (up to ~100~keV) fast-ion losses are significant, up to 20% in the studied case, because of charge exchange reactions between the neutrals and the fast ions. About half of the fast ions that neutralize outside the plasma get lost to the wall while the other half re-enter the plasma and ionize again, often on better confined orbits which is visible as an enhanced beam power deposition in the plasma core (rho ~< 0.7). As a result, the the plasma performance as measured from the beam-thermal neutrons is hardly changed despite the significant fast-ion losses toward the plasma edge.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2020

Preliminary design overview and performance assessment of the ITER low-field side reflectometer

The design of the ITER low-field side reflectometer (LFSR) has matured to a complete end-to-end preliminary design. LFSR will supply three key plasma measurements: (1) electron density profile, (2) electron density fluctuations, and (3) poloidal rotation. Simultaneous measurements of the three quantities are enabled by an array of six monostatic antennas which inject from an equatorial port on the outboard side of the ITER vessel. Low-loss transmission lines, consisting of corrugated, overmoded waveguide and miter bends, transmit the 30–165 GHz, O- and X-mode signals to and from the ITER plasma. Integrated transmission-line components serve a range of purposes, such as protection from high-power stray radiofrequency radiation, accommodation of transmission-line displacement, and simultaneous measurement of reference and plasma phases during the discharge. Broadband transmission signals are realized by full-band microwave transceivers combined with quasi-optical multiplexing. A field-programmable gate array (FPGA) processor demodulates the profile reflectometer signals, enabling real-time density profile measurements for plasma control system feedback. A full-scale transmission line test facility provides an integrated environment to assess the performance of critical LFSR components. Theoretical modeling together with insertion loss measurements provide the basis for a comprehensive power budget, which accounts for transmitted output power, transmission-line losses, antenna coupling, and plasma effects. Results indicate that high signal-to-noise ratios are achievable with the current design. A synthetic reflectometer model, using real design parameters and baseline ITER profiles, has been developed to estimate the return signal. With evolving microwave and data acquisition technologies, full-band, ultrafast sweeps (<1 μs) will be realizable for ITER.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗