Search NASA⌕ Search

Engineering topics

Krejsa, E. A.

Publications and source records attributed to Krejsa, E. A..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1993

Propagation of high frequency jet noise using geometric acoustics

Spherical directivity of noise radiated from a convecting quadrupole source embedded in an arbitrary spreading jet is obtained by ray-tracing methods of geometrical acoustics. The six propagation equations are solved in their general form in a rectangular coordinate system. The noise directivity in the far field is calculated by applying an iteration scheme that finds the required radiation angles at the source resulting in propagation through a given observer point. Factors influencing the zone of silence are investigated. The caustics of geometrical acoustics and the exact locations where it forms is demonstrated by studying the variation in ray tube area obtained from transport equation. For a ring source convecting along the center-axis of an axisymmetric jet, the polar directivity of the radiated noise is obtained by an integration with respect to azimuthal directivity of compact quadrupole sources distributed on the ring. The Doppler factor is shown to vary slightly from point to point on the ring. Finally the scaling of the directivity pattern with power -3 of Doppler factor is investigated and compared with experimental data.

Khavaran, A.↗
NASA NTRS1993

Propagation of high frequency jet noise using geometric acoustics

Spherical directivity of noise radiated from a convecting quadrupole source embedded in an arbitrary spreading jet is obtained by ray-tracing methods of geometrical acoustics. The six propagation equations are solved in their general form in a rectangular coordinate system. The noise directivity in the far field is calculated by applying an iteration scheme that finds the required radiation angles at the source resulting in propagation through a given observer point. Factors influencing the zone of silence are investigated. The caustics of geometrical acoustics and the exact locations where it forms is demonstrated by studying the variation in ray tube area obtained from transport equation. For a ring source convecting along the center-axis of an axisymmetric jet, the polar directivity of the radiated noise is obtained by an integration with respect to azimuthal directivity of compact quadrupole sources distributed on the ring. The Doppler factor is shown to vary slightly from point to point on the ring. Finally the scaling of the directivity pattern with power -3 of Doppler factor is investigated and compared with experimental data.

Khavaran, A.↗
NASA NTRS1992

Computation of supersonic jet mixing noise for an axisymmetric CD nozzle using k-epsilon turbulence model

The turbulent mixing noise of a supersonic jet is calculated for a round convergent-divergent nozzle at the design pressure ratio. Aerodynamic computations are performed using the PARC code with a k-epsilon turbulence model. Lighthill's acoustic analogy combined with Ribner's assumption is adopted. The acoustics solution is based upon the methodology followed by GE in the MGB code. The source correlation function is expressed as a linear combination of second-order tensors. Assuming separable second-order correlations and incorporating Batchelor's isotropic turbulence model, the source term was calculated from the kinetic energy of turbulence. A Gaussian distribution for the time-delay of correlation was introduced. The computational fluid dynamics (CFD) solution was used to obtain the source strength as well as the characteristic time-delay of correlation. The effect of sound/flow interaction was incorporated using the high frequency asymptotic solution to Lilley's equation for axisymmetric geometries. Acoustic results include sound pressure level directivity and spectra at different polar angles. The aerodynamic and acoustic results demonstrate favorable agreement with experimental data.

Khavaran, A.↗
NASA NTRS1990

Mixer-ejector nozzle for jet noise suppression

An aero/acoustic model test of a mixer-ejector nozzle was conducted at the 9 x 15 foot low-speed acoustic wind tunnel at NASA Lewis Research Center. The objective of the test was to get a preliminary assessment of ejector pumping and noise reduction potential of this device for possible application in the exhaust system of an advanced supersonic civil transport. The results of the test showed that goal levels of pumping were achieved. Exit pressure/temperature traverse data showed that there was good mixing between the primary and secondary streams. Acoustics data were dominated by shock noise; jet mixing noise levels were low because of a facility limit on primary temperature. The mixer-ejector did significantly reduce shock noise relative to the baseline conic nozzle. Because the relative magnitudes of jet mixing noise and shock noise were not in the correct proportion to properly model engine noise, an Effective Perceived Noise Level (EPNL) assessment was precluded.

Lord, W. K.↗
NASA NTRS1984

A theoretical model for the cross spectra between pressure and temperature downstream of a combustor

A theoretical model developed to calculate pressure-temperature cross spectra, pressure spectra, temperature spectra and pressure cross spectra in a ducted combustion system is presented. The model assumes the presence of a fluctuating-volumetric-heat-release-rate disk source and takes into account the spatial distribution of the steady-state volumetric-heat flux. Using the model, pressure, velocity, and temperature perturbation relationships can be obtained. The theoretical results show that, at a given air mass flow rate, the calculated pressure-temperature cross spectra phase angle at the combustor exit depends on the model selected for the steady-state volumetric-heat flux in the combustor. Using measurements of the phase angle, an appropriate source region model was selected. The model calculations are compared with the data. The comparison shows good agreement and indicates that with the use of this model the pressure-temperature cross spectra measurements provide useful information on the physical mechanisms active at the combustion noise source.

Miles, J. H.↗
NASA NTRS1983

Cross spectra between pressure and temperature in a constant-area duct downstream of a hydrogen-fueled combustor

Pressure temperature cross spectra are necessary in predicting noise propagation in regions of velocity gradients downstream of combustors if the effect of convective entropy disturbances is included. Pressure temperature cross spectra and coherences were measured at spatially separated points in a combustion rig fueled with hydrogen. Temperature-temperature and pressure-pressure cross spectra and coherences between the spatially separated points as well as temperature and pressure autospectra were measured. These test results were compared with previous results obtained in the same combustion rig using Jet A fuel in order to investigate their dependence on the type of combustion process. The phase relationships are not consistent with a simple source model that assumes that pressure and temperature are in phase at a point in the combustor and at all other points downstream are related to one another by only a time delay due to convection of temperature disturbances. Thus these test results indicate that a more complex model of the source is required.

Miles, J. H.↗
NASA NTRS1983

Acoustical modal analysis of the pressure field in the tailpipe of a turbofan engine

The results of a modal analysis of the pressure field in the tailpipe of a turbofan engine are presented. Modal amplitudes, at the tailpipe inlet and exit, are presented, as a function of frequency, for several operating conditions. The modal amplitudes were obtained using an optimization routine to obtain a best fit between measured cross spectra and an analytical expression for the cross spectra between pressures at circumferentially spaced locations. The measured pressure field was decomposed into a set of five modal amplitudes corresponding to the (0,0), (1,0), (2,0), (3,0), and (4,0) modes. The analysis was limited to frequencies below 1500 Hz where higher order modes are cutoff. The results of the analysis showed that at low frequencies, up to the cuton frequency of the (1,0) mode, the (0,0) mode (plane wave) dominated the pressure field. The frequency range from the cuton of the (1,0) mode to the cuton of the (2,0) mode was dominated by the (1,0) mode. The (2,0) mode dominated from its cuton frequency to the upper limit of the analysis, i.e., 1500 Hz. The contribution of modes other than the dominant mode was usually small.

Krejsa, E. A.↗
NASA NTRS1983

Application of 3-signal coherence to core noise transmission

A method for determining transfer functions across turbofan engine components and from the engine to the far-field is developed. The method is based on the 3-signal coherence technique used previously to obtain far-field core noise levels. This method eliminates the bias error in transfer function measurements due to contamination of measured pressures by nonpropagating pressure fluctuations. Measured transfer functions from the engine to the far-field, across the tailpipe, and across the turbine are presented for three turbofan engines.

Krejsa, E. A.↗
NASA NTRS1983

Cross spectra between temperature and pressure in a constant area duct downstream of a combustor

The feasibility of measuring pressure temperature cross spectra and coherence and temperature-temperature cross spectra and coherence at spatially separated points along with pressure and temperature auto-spectra in a combustion rig was investigated. The measurements were made near the inlet and exit of a 6.44 m long duct attached to a J-47 combustor. The fuel used was Jet A. The cross spectra and coherence measurements show the pressure and temperature fluctuations correlate best at low frequencies. At the inlet the phenomena controlling the phase relationship between pressure and temperature could not be identified. However, at the duct exit the phase angle of the pressure is related to the phase angle of the temperature by the convected flow time delay. Previously announced in STAR as N83-23116

Miles, J. H.↗
NASA NTRS1983

Application of 3-signal coherence to core noise transmission

A method for determining transfer functions across turbofan engine components and from the engine to the far-field is developed. The method is based on the three-signal coherence technique used previously to obtain far-field core noise levels. This method eliminates the bias error in transfer function measurements due to contamination of measured pressures by nonpropagating pressure fluctuations. Measured transfer functions from the engine to the far-field, across the tailpipe, and across the turbine are presented for three turbofan engines.

Krejsa, E. A.↗
NASA NTRS1983

Cross spectra between temperature and pressure in a constant area duct downstream of a combustor

The feasibility of measuring pressure temperature cross spectra and coherence and temperature-temperature cross spectra and coherence at spatially separated points along with pressure and temperature auto-spectra in a combustion rig was investigated. The measurements were made near the inlet and exit of a 6.44 m long duct attached to a J-47 combustor. The fuel used was Jet A. The cross spectra and coherence measurements show the pressure and temperature fluctuations correlate best at low frequencies. At the inlet the phenomena controlling the phase relationship between pressure and temperature could not be identified. However, at the duct exit the phase angle of the pressure is related to the phase angle of the temperature by the convected flow time delay.

Miles, J. H.↗
NASA NTRS1982

Correlation of core noise obtained by three signal coherence techniques

The prediction of frequency content and noise levels of turbofan engine core noise is reexamined as a result of recent test data and a new diagnostic technique. The diagnostic technique, utilizing a three-signal coherence method, is used to obtain core noise spectra for several engines. Similarities and differences of the spectra are discussed. Finally, the three-signal coherence data are correlated, leading to an improved core noise prediction procedure.

Vonglahn, U.↗
NASA NTRS1981

New technique for the direct measurement of core noise from aircraft engines

A new technique is presented for directly measuring the core noise levels from gas turbine aircraft engines. The technique requires that fluctuating pressures be measured in the far-field and at two locations within the engine core. The cross-spectra of these measurements are used to determine the levels of the far-field noise that propagated from the engine core. The technique makes it possible to measure core noise levels even when other noise sources dominate. The technique was applied to signals measured from an AVCO Lycoming YF102 turbofan engine. Core noise levels as a function of frequency and radiation angle were measured and are presented over a range of power settings.

Krejsa, E. A.↗
NASA NTRS1981

New technique for the direct measurement of core noise from aircraft engines

The core noise levels from gas turbine aircraft engines were measured using a technique which requires that fluctuating pressures be measured in the far field and at two locations within the engine core. The cross spectra of these measurements are used to determine the levels of the far-field noise that propagated from the engine vore. The technique makes it possible to measure core noise levels even when other noise sources dominate. The technique was applied to signals measured from an Avco Lycoming YF102 turbofan engine. Core noise levels as a function of frequency and radiation angle were measured and are presented over a range of power settings.

Krejsa, E. A.↗
NASA NTRS1976

Interim prediction method for turbine noise

A turbine noise prediction method for interim use in the NASA Aircraft Noise Prediction Program is selected. The method predicts the level, directivity, and one-third octave band spectra of far field turbine noise as a function of engine parameters. The selection results from a review of turbine noise data and prediction methods available in the open literature. It is concluded that the state-of-the-art turbine noise prediction capability is primitive and that the selected method represents only a temporary interim approach. Recommendations are made on research requirements.

Krejsa, E. A.↗
NASA NTRS1972

Effect of duct shape, Mach number, and lining construction on measured suppressor attenuation and comparison with theory

Noise attenuation was measured for several types of cylindrical suppressors that use a duct lining composed of honeycomb cells covered with a perforated plate. The experimental technique used gave attenuation data that were repeatable and free of noise floors and other sources of error. The suppressor length, the effective acoustic diameter, suppressor shape and flow velocity were varied. The agreement among the attenuation data and two widely used analytical models was generally satisfactory. Changes were also made in the construction of the acoustic lining to measure their effect on attenuation. One of these produced a very broadband muffler.

Olsen, W. A.↗
NASA NTRS1972

Jet noise

The main conclusions reached are: (1) At low subsonic jet exhaust velocities, jet noise varies as the velocity to the eighth power; (2) at high subsonic exhaust velocities, jet noise approaches a variation with velocity to the third power; (3) use of the jet density squared overcorrects density effects on jet noise; (4) subsonic and supersonic jet noise levels can be predicted; and (6) use of multielement nozzles and acoustically lined ejectors significantly suppress jet noise at intermediate jet exhaust velocities.

Vonglahn, U. H.↗