Search NASA⌕ Search

Engineering topics

Krieger, A. S.

Publications and source records attributed to Krieger, A. S..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1989

The design and evaluation of grazing incidence relay optics

X-ray astronomy, both solar and celestial, has many needs for high spatial resolution observations which have to be performed with electronic detectors. If the resolution is not to be detector limited, plate scales in excess of 25 microns arc/sec, corresponding to focal lengths greater than 5 m, are required. In situations where the physical size is restricted, the problem can be solved by the use of grazing incidence relay optics. A system was developed which employs externally polished hyperboloid-hyperboloid surfaces to be used in conjunction with a Wolter-Schwarzschild primary. The secondary is located in front of the primary focus and provides a magnification of 4, while the system has a plate scale of 28 microns arc/sec and a length of 1.9 m. The design, tolerance specification, fabrication and performance at visible and X-ray wavelengths of this optical system are described.

Davis, John M.↗
NASA NTRS1985

SAROS: Solar Active Region Observations from Spacelab

A definition study of the SAROS investigation was conducted. An instrument design and mode of operation was established which was consistent with the capabilities of the Space Transportation System. Upon completion of the definition phase study the program was placed on hold for approximately five years before being terminated. Consequently, the promise which this investigation held for understanding the heating processes in coronal loops remains unfulfilled.

Krieger, A. S.↗
NASA NTRS1982

The growth of filaments by the condensation of coronal arches

A model of filament formation based on the condensation of coronal arches is described. The condensation results from initiating the radiative instability within an arch by superimposing a transient energy supply upon the steady state heating mechanism. The transient energy supply increases the density within the arch so that when it is removed the radiative losses are sufficient to lead to cooling below the minimum in the power loss curve. Times from the initial formation of the condensation to its temperature stabilization as a cool filament have been calculated for various initial conditions. They lie in the range 10,000-100,000 s with the majority of the time spent above a temperature of 1 x 10 to the 6th K. Under the assumption that the condensation of a single arch forms an element of the filament, a complete filament requires the condensation of an arcade of loops. Using experimentally derived parameters, filament densities of 10 to the 11th to 10 to the 12th per cu cm can be obtained.

Davis, J. M.↗
NASA NTRS1982

Properties of coronal arches

The properties of coronal arches located on the peripheries of active regions, observed during a sounding rocket flight on March 8, 1973, are discussed. The arches are found to overlie filament channels and their footpoints are traced on locations on the perimeters of supergranulation cells. The arches have a wide range of lengths although their widths are well approximated by the value 2.2 x 10 to the 9th cm. Comparison of the size of the chromospheric footprint with the arc width indicates that arches do not always expand as they ascend into the corona. The electron temperatures and densities of the plasma contained in the arches were measured and the pressure calculated; typical values are 2-million K, 1 x 10 to the 9th/cu cm, and 0.2 dyne/sq cm, respectively. The variation of these parameters with position along the length of the arch indicates that the arches are not in hydrostatic equilibrium.

Davis, J. M.↗
NASA NTRS1982

Grazing incidence relay optics

The necessity to work in the focal plane of the primary mirrors has been one of the factors limiting the utility of grazing incidence telescopes in X-ray astronomy. In connection with the reported investigation, computer ray tracing programs have been used to study the performance of several grazing incidence relay optics (GIRO) systems used together with a large nested solar X-ray telescope. It was found that GIRO magnifiers are useful to map appropriate sized regions of the sun onto available CCD detectors. GIRO collimators can be used together with an X-ray spectrometer to study the X-ray spectrum from very small regions on the sun. Attention is given to the stationary mode, the tracking mode, and the size of GIRO elements. It is found that for a given GIRO size and magnification a use of the diverging system has the advantage of reducing the overall length of the main telescope-GIRO combination. However, the resolution provided by the diverging GIRO may not be as good as that obtained with the corresponding converging GIRO.

Chase, R. C.↗
NASA NTRS1980

A two-temperature model for the flare of 5 September, 1973

A study of the energetics and mass transfer during the X-ray flare on Sept. 5, 1973, using the observations in the objective grating mode of the spectrographic telescope on Skylab is presented. The data are approximately monochromatic images of a small X-ray source which show a continued rise in the emission for several minutes followed by a decline. The observations are analyzed using a two-temperature model to determine the changes in the distribution of emission measure and of the amount of material as a function of temperature. The development of the flare can be divided into three periods comprising evaporation which drives mass into the entire emitting region, cessation of evaporation, and decline in the emission measure.

Little-Marenin, I. R.↗
NASA NTRS1980

The thermal X-ray flare plasma

Following a review of current observational and theoretical knowledge of the approximately 10 to the 7th K plasma emitting the thermal soft X-ray bursts accompanying every H alpha solar flare, the fundamental physical problem of the plasma, namely the formation and evolution of the observed X-ray arches, is examined. Extensive Skylab observations of the thermal X-ray plasmas in two large flares, a large subflare and several compact subflares are analyzed to determine plasma physical properties, deduce the dominant physical processes governing the plasma and compare large and small flare characteristics. Results indicate the density of the thermal X-ray plasma to be higher than previously thought (from 10 to the 10th to 10 to the 12th/cu cm for large to small flares), cooling to occur radiatively as much as conductively, heating to continue into the decay phase of large flares, and the mass of the thermal X-ray plasma to be supplied primarily through chromospheric evaporation. Implications of the results for the basic flare mechanism are indicated.

Moore, R.↗
NASA NTRS1979

Anticorrelation of X-ray bright points with sunspot number, 1970-1978

Soft X-ray observations of the solar corona over the period 1970-1978 show that the number of small short-lived bipolar magnetic features (X-ray bright points) varies inversely with the sunspot index. During the entire period from 1973 to 1978 most of the magnetic flux emerging at the solar surface appeared in the form of bright points. In 1970, near the peak of solar cycle 20, the contributions from bright points and from active regions appear to be approximately equal. These observations strongly support an earlier suggestion that the solar cycle may be characterized as an oscillator in wave-number space with relatively little variation in the average total rate of flux emergence.

Golub, L.↗
NASA NTRS1979

Study of the post-flare loops on 29 July 1973. I - Dynamics of the X-ray loops

We derive an empirical model of the X-ray emitting post-flare loops observed during the decay phase of the 29 July 1973 flare. We find that the loops are elliptical, with the brightest emitting region at the tops. We determine the height, velocity of growth, and ratio of height to width of the loops at times from 3 to 12 hr after the flare onset.

Nolte, J. T.↗
NASA NTRS1979

Study of the post-flare loops on 29 July 1973. II - Physical parameters in the X-ray loops

We use the filter ratio method of analysis to determine spatially resolved values of plasma parameters in the X-ray emitting post-flare loop system which developed on 29 and 30 July 1973. We find that the loops were hotter and had higher plasma pressure at their tops than near their footpoints. The loop tops were at nearly the same temperature at different places 3 hr after the flare maximum and were also at nearly this same temperature 3 and 8 hr later. Variations in brightness transverse to the loops were due to variations in emission measure. We show by consideration of radiative losses alone that energy must have been added to the hottest part of the flare, at the tops of the loops, late in the decay phase of the flare.

Petrasso, R. D.↗
NASA NTRS1979

Quest for ultrahigh resolution in X-ray optics

A program of solar X-ray astronomy using grazing incidence optics has culminated in X-ray images of the corona having one arc second spatial resolution. These images have demonstrated that, in general, X-ray optics can be fabricated to their specifications and can provide the level of resolution for which they are designed. Several aspects of these programs relating to the performance of X-ray optics in regard to resolution, including the point response function, the variation of resolution with off-axis position and the recognition that nearly all solar X-ray images have been film limited, are discussed. By extending the experience gained on this and other programs it is clearly possible to design and fabricate X-ray optics with sub arc sec resolution. The performance required to meet the scientific objectives for the remainder of the century are discussed in relation to AXIO, an Advanced X-Ray Imaging Observatory for solar observations which is proposed for flight on the Space Shuttle. Several configurations of AXIO are described, each of which would be a major step in the quest for ultrahigh-resolution observations.

Davis, J. M.↗
NASA NTRS1978

The relationship between solar activity and coronal hole evolution

The relationship between coronal hole evolution and solar active regions during the Skylab period is examined. A tendency is found for holes to grow or remain stable when the activity nearby, seen as calcium plages and bright regions in X-rays, is predominantly large, long-lived regions. It is also found that there is a significantly higher number of small, short-lived active regions, as indicated by X-ray bright points, in the vicinity of decaying holes than there is near other holes. This is interpreted to mean that holes disappear at least in part because they become filled with many small scale, magnetically closed, X-ray emitting features. This interpretation, together with the observation that the number of X-ray bright points was much larger near solar minimum than it was during the Skylab period, provides a possible explanation for the disappearance of the large, near-equatorial coronal holes at the time of solar minimum.

Nolte, J. T.↗
NASA NTRS1978

Determination of the structure and heating mechanisms of coronal loops from soft X-ray observations with the solar probe

High resolution soft X-ray imaging from the solar probe is justified in terms of the expected scientific returns which include the determination of the temperature and density structure of a coronal loop. The advantages of the grazing incidence telescope over the multiple pinhole camera are discussed. An instrument package is described which includes a grazing incidence mirror, a thermal prefilter, a three position filter wheel and a focal plane detector baselined as an 800 by 800 back-illuminated charge coupled device. The structural assembly together with the data processing equipment would draw heavily on the designs being developed for the Solar Polar Mission.

Davis, J. M.↗
NASA NTRS1978

An atlas of soft X-ray images of the solar corona from Skylab

An atlas is presented which contains daily full-sun photographs of the soft X-ray solar corona taken in two filters with an X-ray telescope on the Apollo telescope mount of Skylab for the period from May 29 to November 27, 1973. The passband of the first filter covers the wavelength regions from 2 to 32 A and 44 to 54 A; the second filter covers the region from 2 to 17 A. Characteristics of the instrument, the wavelength response, and sensitivity are described along with the total data base, of which the atlas represents only 1%. Comparisons are made with observations of the white-light corona, photospheric magnetic field, H-alpha radiation from the chromosphere, and 284-A Fe XV emission from the corona. A complete bibliography of scientific papers that have used the data base and a bibliography of catalogs and atlases containing related data for the same observational period are provided.

Zombeck, M. V.↗
NASA NTRS1978

Short term evolution of coronal hole boundaries

The evolution of coronal hole boundary positions on a time scale of approximately 1 day is studied on the basis of an examination of all coronal holes observed by Skylab from May to November 1973. It is found that a substantial fraction (an average of 38%) of all coronal hole boundaries shifted by at least 1 deg heliocentric in the course of a day. Most (70%) of these changes were on a relatively small scale (less than 3 times the supergranulation cell size), but a significant fraction occurred as discrete events on a much larger scale. The large-scale shifts in the boundary locations involved changes in X-ray emission from these areas of the sun. There were generally more changes in the boundaries of the most rapidly evolving holes, but no simple relationship between the amount of change and the rate of hole growth or decay.

Nolte, J. T.↗
NASA NTRS1978

A physical parameter method for the design of broad-band X-ray imaging systems to do coronal plasma diagnostics

The technique commonly used for the analysis of data from broad-band X-ray imaging systems for plasma diagnostics is the filter ratio method. This requires the use of two or more broad-band filters to derive temperatures and line-of-sight emission integrals or emission measure distributions as a function of temperature. Here an alternative analytical approach is proposed in which the temperature response of the imaging system is matched to the physical parameter being investigated. The temperature response of a system designed to measure the total radiated power along the line of sight of any coronal structure is calculated. Other examples are discussed.

Kahler, S.↗
NASA NTRS1978

The decay of coronal loops brightened by flares and transients

Observations of X-ray emitting loops derived from Skylab S-054 photographs, and combined with temperature and brightness estimates from Solrad data, are used to determine brightness decay times resulting from various coronal energy loss mechanisms. Conductive losses are found to be more rapid than radiative losses. Attention is given to the role of geometrical inhibition of conduction as a possible mechanism of brightness decay. Soft X-ray observations are consistent with the continuation of the 'evaporation' driven by thermal conduction late into the decay phase of the event.

Krieger, A. S.↗