Engineering topics

Kroo, I.

Publications and source records attributed to Kroo, I..

5 records

NASA NTRS1992

Development of the quasi-procedural method for use in aircraft configuration optimization

The performance of the quasi-procedural analysis system in optimization tasks is investigated. In particular, the quasi-procedural method is applied to the complete mission optimization of a medium-sized transport aircraft using a vortex-lattice aerodynamic model and finite element structural analysis of the wing and the tail. Some modifications and improvements to the system, required in order to complete this task, are described. The performance of the system is compared with that of the standard procedural system, and it is shown that the quasi-procedural approach reduces the analysis required to reach the optimum. The overall cost is shown to be strongly dependent on the analysis architecture and data structure.

Gage, P.↗

NASA NTRS1992

Structural and aerodynamic considerations for an oblique all-wing aircraft

A key design issue for the Oblique All-Wing aircraft is the packaging of the payload compartment, the fuel tanks, and the other internal components within the airfoil. The internal arrangement of such vehicles is strongly coupled to the exterior vehicle geometry. For example, the height requirements of a passenger cabin directly influence the aircraft thickness and span. As a result, the internal arrangement strongly affects aerodynamic performance and structural weight. Configuration criteria are defined and/or discussed, and a baseline aircraft is developed. Also, some of the major tradeoffs that affect structural weight and aerodynamic performance are presented.

Waters, M. H.↗

NASA NTRS1991

Forebody tangential blowing for control at high angles of attack

A feasibility study to determine if the use of tangential leading edge blowing over the forebody could produce effective and practical control of the F-18 HARV aircraft at high angles of attack was conducted. A simplified model of the F-18 configuration using a vortex-lattice model was developed to obtain a better understanding of basic aerodynamic coupling effects and the influence of forebody circulation on lifting surface behavior. The effect of tangential blowing was estimated using existing wind tunnel data on normal forebody blowing and analytical studies of tangential blowing over conical forebodies. Incorporation of forebody blowing into the flight control system was investigated by adding this additional yaw control and sideforce generating actuator into the existing F-18 HARV simulation model. A control law was synthesized using LQG design methods that would schedule blowing rates as a function of vehicle sideslip, angle of attack, and roll and yaw rates.

Kroo, I.↗

NASA NTRS1983

A fundamental comparison of canard and conventional configurations

This paper examines the relative efficiency of canard, tandem, and aft-tailed aircraft configurations through analysis of an elementary lifting system. Stability and trim requirements are imposed upon the system and its C sub L(max), drag, and structural weight are studied as its geometry varies over a wide range of possible configurations. During the course of the analysis, two general solutions emerge for minimum induced drag as a function of the geometry and the division of lift between the surfaces of such a system - one for fixed span and the other for fixed weight. The conclusion is that the pre-eminence of the conventional aft-tailed configuration has a sound fundamental basis, but that there may be some room for improvement.

Mcgeer, T.↗

NASA NTRS1979

Analytical and scale model research aimed at improved hangglider design

Research consisted of a theoretical analysis which attempts to predict aerodynamic characteristics using lifting surface theory and finite-element structural analysis as well as an experimental investigation using 1/5 scale elastically similar models in the NASA Ames 2m x 3m (7' x 10') wind tunnel. Experimental data were compared with theoretical results in the development of a computer program which may be used in the design and evaluation of ultralight gliders.

Kroo, I.↗