Engineering topics

Krothapalli, A.

Publications and source records attributed to Krothapalli, A..

34 records · Page 2

NASA NTRS1986

Observations on the structure of an edge-tone flowfield

The unsteady flowfield in the region in which a rectangular jet interacts with the leading edge of a 20-deg wedge is investigated experimentally. Edge-tone flowfields at Mach 0.8 in the blowdown facility at Stanford University are recorded by phase-locked Schlieren photography using the apparatus and techniques described by Krothapalli and Horne (1984); detailed surface-pressure and velocity measurements are obtained at Mach 0.23 in the NASA Ames anechoic-chamber facility and presented graphically. It is shown that the jet-edge interaction produces a secondary vortex at the leading edge when an established shear layer or primary vortex is present, and that the primary and secondary vortices then evolve from a counterrotating vortex pair to a large single vortex which migrates along the wedge surface (in agreement with the observations of Rockwell et al., 1986). From a comparison with data on airfoil-trailing-edge flows (Satyanarayana, 1977) it is inferred that an instantaneous zero pressure differential is present at the leading edge of the wedge.

Krothapalli, A.↗

NASA NTRS1986

The development of laser speckle velocimetry for the measurement of vortical flow fields

A new velocity measurement technique is described that provides the simultaneous visualization of a two-dimensional streamline pattern and the quantification of the velocity field. The main advantage of this technique is that the velocity field can be measured with sufficient accuracy and spatial resolution so that the vorticity field can be readily obtained. This technique is ideally suited for the study of unsteady vortical flows, which occur in rotorcraft and in high-angle-of-attack aerodynamics. The technique, some of the important parameters that affect its use, and some recent examples are described.

Smith, C. A.↗

NASA NTRS1986

Recent advances in aeroacoustics

The state of the art in theoretical and numerical models and experimentation on broadband noise propagation from high speed aircraft components such as jets and helicopter blades is detailed. Attention is given to noise produced by jets, shear layers and turbulence and to the acoustic properties of rotors. The generation and propagation of acoustic noise are discussed in terms of the evolution of concepts for flow-tone generation to include hydrodynamic instabilities. Consideration is also given to techniques for experimental studies and theoretical models for nonlinear features of acoustic propagation of broadband noise and acoustic propagation in partially-choked or soft-walled ducts.

Krothapalli, A.↗

NASA NTRS1986

Recent advances in aerodynamics

Papers are presented on unsteady transonic aerodynamics and aeroelasticity, the unsteady separation phenomenon, and a wind tunnel method for V/STOL testing. Also considered are vortex-edge interactions, jet instability theory, large-scale organized motions in jets and shear layers, and the evolution of adaptive-wall wind tunnels. Other topics include advances in ejector thrust augmentation, multiple jet impingement flowfields, and recent advances in prediction methods for jet-induced effects on V/STOL aircraft.

Krothapalli, A.↗

NASA NTRS1984

Recent observations on the structure of an edge-tone flow field

An experimental investigation of the flow field generated with a subsonic air jet (M = 0.18-0.8) issuing from a rectangular nozzle having a top hat mean exit velocity profile impinging on a 20 deg wedge has been carried out. The interaction of the jet with an edge involves formation of primary vorticies in the shear layer surrounding the jet and secondary vorticies near the tip of the wedge. These vorticies form vortex pairs and eventually merge to form a single large vortex, and moves downstream along the surface of the wedge. Phase averaged flow survey measurements also depict the counter-rotating vortex pair moving along the surface of the wedge. The instantaneous pressure distribution on the surface of the wedge shows that the unsteady pressure remains zero at the leading edge for the entire motion cycle. For a given edge height, the narrow band spectrum of the near field pressure signals indicate the simultaneous existence of several frequencies, which are not harmonically related.

Krothapalli, A.↗

NASA NTRS1984

Effects of Mach number on the development of a subsonic multiple jet

Results of an experimental study of the flow structure of a subsonic jet issuing from an array of rectangular lobes, equally spaced with their small dimensions in a line, are presented. The tests determined the affect of jet exit Mach number variations (0.3 to 0.8) on the flow field. Measurements of the mean velocity field and centerline rms velocity, along with schlieren flow visualization, were made. It was found that Mach number had no significant affect on the general flow field characteristics; and, that the flow field far downstream resembles that of a jet exiting from a two-dimensional nozzle with its short dimension being the long dimension of the lobe.

Mclachlan, B. G.↗

NASA NTRS1984

A study of flow past an airfoil with a jet issuing from its lower surface

The aerodynamics of a NACA 0018 airfoil with a rectangular jet of finite aspect ratio exiting from its lower surface at 90 deg to the chord were investigated. The jet was located at 50% of the wing chord. Measurements include static pressures on the airfoil surface, total pressures in the near wake, and local velocity vectors in different planes of the wake. The effects of jet cross flow interaction on the aerodynamics of the airfoil are studied. It is indicated that at all values of momentum coefficients, the jet cross flow interaction produces a strong contra-rotating vortex structure in the near wake. The flow behind the jet forms a closed recirculation region which extends up to a chord length down stream of the trailing edge which results in the flow field to become highly three dimensional. The various aerodynamic force coefficients vary significantly along the span of the wing. The results are compared with a jet flap configuration.

Krothapalli, A.↗

NASA NTRS1984

Flow structure within a heated rectangular jet ejector

Preliminary results of an experimental study of the flow field structure within a rectangular jet ejector are presented. The tests determined the effect of primary jet heating and ejector duct width on the flow field at a fixed jet exit Mach number of 0.3. For comparison the rectangular jet without the presence of the ejector shroud was also studied. Measurements of the mean velocity field, total temperature field, and ejector shroud surface pressure distribution, along with schlieren flow visualization, were made. It was found that: the ejector did not enhance centerline temperature decay in comparison to the free jet; the presence of the ejector shroud significantly reduced jet growth; and, the ejector centerline velocity/temperature decay was not sensitive to duct width variations.

Mclachlan, B. G.↗

NASA NTRS1983

Some observations on the aerodynamics of an airfoil with a jet exhausting from the lower surface

A preliminary investigation was carried out to study the aerodynamics of an 18% symmetrical airfoil with a rectangular jet exhausting from the lower surface. Static pressures on the airfoil surface and total pressures in the near wake were measured at jet momentum coefficients ranging from 0 to 2. Results from these measurements were used to study the effects of a jet-cross flow interaction on the aerodynamics of an airfoil. These results were also compared with those obtained from a two-dimensional inviscid theoretical model. Measurements indicate positive and negative pressure regions in front of and behind the jet respectively. The intensity of the pressure in these regions increases with increasing jet strength. Upper surface pressures also decrease due to an effective angle of attack induced by the jet-cross flow interaction. The pressure variations on the upper and lower surfaces induce a positive sectional lift coefficient on the airfoil. The magnitude of the lift coefficient for a given momentum coefficient decreases with decreasing aspect ratio of the nozzle.

Leopold, D.↗

NASA NTRS1982

On the structure of an underexpanded rectangular jet

An underexpanded jet of air issuing from a converging rectangular nozzle of moderate aspect ratio was investigated. Schileren pictures of the flow field along with hot-wire measurements in the jet were obtained at different pressure ratios. At the pressure ratio corresponding to the maximum screeching sound, Schlieren photographs show a very strong organized cylindrical wave pattern on either side of the jet, with their respective sources being located at the end of the third shock cell. Associated with this wave pattern is a large increase in the angle of spread of the jet. It is shown that the self excitation helps to induce large-scale vortical motions in the jet both in the plane containing the small dimension of the nozzle and in the plane containing the long dimension of the nozzle. However, the locations of these structures are different in the two planes. Nevertheless, the characteristic Strouhal number corresponding to these large-scale structures in both planes is the same and equal to 0.12. The influence of the self excitation on the mean velocities and rms intensities was also investigated. For the full range of pressure ratios studied, similarity was found in the mean velocity and rms intensity profiles in the two central planes beyond 80 widths downstream of the nozzle exit. However, the shapes of the similarity profiles are different in the two planes.

Krothapalli, A.↗

NASA NTRS1982

An experimental investigation of flow surrounding an airfoil with a jet exhausting from the lower surface

The aerodynamics of an airfoil with a rectangular jet issuing from the lower surface at seventy percent of the chord, with and without a ground plane was studied. Measurements include surface pressure on the airfoil and the total pressure profiles in the near wake. These measurements were made at jet to free stream velocity ratios ranging from 0.5 to 5.0. The measurements indicated a significant positive and negative pressure regions on the lower surface of the airfoil ahead and after the nozzle exit respectively. The extent and intensity of these regions increase with increase in velocity ratio for the range covered here. The upper surface pressure distribution with velocity ratio show no significant variation. The presence of the ground plane, for height h, greater than one chord seem to have little influence on the overall pressure distribution of the airfoil. The airfoil wake centerline moves up with velocity ratio as compared to that of the free airfoil (without the jet).

Krothapalli, A.↗

NASA NTRS1981

On the mixing of a rectangular jet

Hot-wire measurements in an incompressible rectangular jet, issuing into a quiet environment at ambient conditions, are presented. A blow-down-type air supply system was used to provide the airflow to a cylindrical settling chamber 1.75 m in length and 0.6 m in diameter. The measurements were made with constant-temperature anemometers in conjunction with linearizers. The two signals from the linearizers were sent through a sum and difference unit which was calibrated from dc to 100 kHz. The distributions of mean velocity and the turbulence shear stresses were measured in the two central planes of the jet stations up to 115 widths downstream of the nozzle exit. Three distinct regions characterized the jet flow field: a potential core origin, a two-dimensional-type region, and an axisymmetric type region. The onset of the second region appeared to be at a location where the shear layers separated by the short dimension of the nozzle meet; and the third region occurred at a downstream location where the two shear layers from the short edges of the nozzle meet. In the central plane, similarity was found both in the mean velocity and shear stress profiles beyond 30 widths downstream of the nozzle exit; profiles of rms velocity showed similarity in the second, but not the third region.

Krothapalli, A.↗

NASA NTRS1981

Partially confined multiple jet mixing

Results of hot-wire measurements in an incompressible partially confined jet issuing from an array of rectangular nozzles, equally spaced with their small dimensions aligned are presented. The quantities measured include mean velocity and the Reynolds stress in the two central planes of the jet at stations covering up to 115 widths (small dimension of a nozzle) downstream of the nozzle exit. For downstream distances greater than 60 widths, the flowfield is observed to be nearly homogenous and the turbulence appears to be quite similar to that of a grid generated turbulence.

Krothapalli, A.↗

NASA NTRS1980

Development and structure of a rectangular jet in a multiple jet configuration

Results of hot-wire measurements in an incompressible jet issuing from an array of rectangular lobes, equally spaced with their small dimensions in a line, are presented. The quantities measured include mean velocity and the Reynolds stress in the two central planes of the jet at stations covering up to 115 widths (small dimension of the lobe) downstream of the nozzle exit. Measurements are carried out on a single rectangular free jet and on the same jet in a multiple jet configuration. In the case of a multiple jet, the flowfield for downstream distance X greater than 60D (D = width of the lobe) resembles that of a jet exiting from a two-dimensional nozzle with its short dimension being the long dimension of the lobe. The field of turbulence is found to be nearly isotropic in the plane containing the small dimension of the lobes for X greater than 60D.

Krothapalli, A.↗

NASA NTRS1979

Some observations of flow structure in multiple jet mixing

Results of hot wire measurements in an incompressible jet issuing from an array of rectangular lobes, equally spaced with their small dimensions in a line, both as a free jet, and as a confined jet, are presented. In the case of a multiple free jet, the flow field for downstream distance x greater than 60D (D = width of a lobe) resembles that of a jet exiting from a two-dimensional nozzle with its short dimension being the long dimension of the lobe. The field of turbulence is found to be nearly isotropic in the plane containing the small dimension of the lobes for x greater than 60D. In the case of a confined multiple jet, the flow field is observed to be nearly homogeneous and isotropic for x greater than 60D.

Krothapalli, A.↗

NASA NTRS1979

Turbulence measurements in a rectangular jet

The paper deals with hot-wire measurements in a rectangular incompressible jet issuing into a medium at rest. The flow field of the jet was found to be characterized by the presence of three distinct regions with respect to the mean axial velocity on the center line, referred to as potential core region, two-dimensional type region, and axisymmetric type region. The onset of the second region appears to be at downstream locations where the shear layers from the short dimension of the nozzle meet. Similarly, the center line velocity decay is first of axisymmetric nature at a downstream location where the two shear layers from the long dimension of the nozzle meet. The conditions for the existence of a rectangular jet of an aspect ratio of 16.7 with the laminar tophat profile at the exit are identified.

Krothapalli, A.↗