Search NASASearch

Engineering topics

Kubiak, E. T.

Publications and source records attributed to Kubiak, E. T..

Linear-quadratic stationkeeping for the STS Orbiter

An automatic controller for Space Shuttle Orbiter stationkeeping or formationkeeping is presented. The controller uses a feed-forward loop for precise control at non-equilibrium set points, and a discrete-time linear quadratic regulator for disturbance rejection. Selection of sample time and quadratic cost matrices is done to provide good limit cycling performance in the presence of sensor noise and a control threshold nonlinearity. Large position changes are effected by feed-forward of a minimum fuel or straightline maneuver path. Results show that 20 ft precision can be achieved using current sensors, and that 2 ft precision would be possible with enhanced sensors.

Redding, D. C.

A frequency domain stability analysis of a phase plane control system

A describing function is used to model a phase plane controller which is part of the Space Shuttle on-orbit Reaction Control System autopilot. A frequency domain stability analysis of the closed-loop control system is applied to a study of potential flight control system interaction with the Orbiter and a class of payloads deployed from a tilt table. Phase-gain plot techniques are used to show that expansion of phase plane angular rate limits and stiffening of the tilt table pivot do not always enhance system stability. Instability region approximations are mapped as a function of rate limit, payload geometry, jet used, and natural frequency of the pivot. Comparison of the describing function analysis with simulation results shows excellent correlation.

Hattis, P. D.

A new design approach to achieve a minimum impulse limit cycle in the presence of significant measurement uncertainties

A new design was developed for the Space Shuttle Transition Phase Digital Autopilot to reduce the impact of large measurement uncertainties in the rate signal during attitude control. The signal source, which was dictated by early computer constraints, is characterized by large quantization, noise, bias, and transport lag which produce a measurement uncertainty larger than the minimum impulse rate change. To ensure convergence to a minimum impulse limit cycle, the design employed bias and transport lag compensation and a switching logic with hysteresis, rate deadzone, and 'walking' switching line. The design background, the rate measurement uncertainties, and the design solution are documented.

Martin, M. W.

Space Shuttle flight control system

The Space Shuttle is a control stabilized vehicle with control provided by an all digital, fly-by-wire flight control system. This paper gives a description of the several modes of flight control which correspond to the Shuttle mission phases. These modes are ascent flight control (including open loop first stage steering, the use of four computers operating in parallel and inertial guidance sensors), on-orbit flight control (with a discussion of reaction control, phase plane switching logic, jet selection logic, state estimator logic and OMS thrust vector control), entry flight control and TAEM (terminal area energy management to landing). Also discussed are redundancy management and backup flight control.

Klinar, W. J.