Search NASA⌕ Search

Engineering topics

Kudrolli, Arshad

Publications and source records attributed to Kudrolli, Arshad.

Bendability parameter for twisted ribbons to describe longitudinal wrinkling and delineate the near-threshold regime

We propose a dimensionless bendability parameter, ε -1 =[(h/W) 2 ⁢T -1 ] -1 , for wrinkling of thin, twisted ribbons with thickness h, width W, and tensional strain T. Bendability permits efficient collapse of data for wrinkle onset, wavelength, critical stress, and residual stress, demonstrating longitudinal wrinkling's primary dependence on this parameter. This parameter also allows us to distinguish the highly bendable range (ε -1 >20) from moderately bendable samples (ε -1 ϵ(0,20]). We identify scaling relations to describe longitudinal wrinkles that are valid across our entire set of simulated ribbons. When restricted to the highly bendable regime, simulations confirm theoretical near-threshold (NT) predictions for wrinkle onset and wavelength.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Internal erosion, particle transport, and channelization driven by fluid flow

The investigations summarized in this final technical report were accomplished under Department of Energy, Basic Energy Sciences research grant number DE-SC0010274 titled Internal erosion, particle transport, and channelization driven by fluid flow, $196,683 from 07/15/13 to 12/31/17, and $149,999 from 01/01/18 to 12/31/21. The work focused on developing physical models of fluid driven evolution of sediment beds as a result of dissolution and erosion of embedded particles that lead to channelization and fracture networks in porous rock. The grant work has resulted in seven peer reviewed publications, with another one currently under review, all of which are listed at the end of the report. These publications can be freely accessed through a technical library or directly from the publisher for a nominal fee. The main results obtained during the last grant cycle are described in brief in the following.

58 GEOSCIENCES↗

Alcove formation in dissolving cliffs driven by density inversion instability

We demonstrate conditions that give rise to cave-like features commonly found in dissolving cliffsides with a minimal two-phase physical model. Alcoves that are wider at the top and tapered at the bottom, with sharp-edged ceilings and sloping floors, are shown to develop on vertical solid surfaces dissolving in aqueous solvents. As evident from descending plumes, sufficiently large indentations evolve into alcoves as a result of the faster dissolution of the ceiling due to a solutal Rayleigh–Bénard density inversion instability. In contrast, defects of size below the boundary layer thickness set by the critical Rayleigh number smooth out, leading to stable planar interfaces. Furthermore, the ceiling recession rate and the alcove opening area evolution are shown to be given to first-order by the critical Rayleigh number. By tracking passive tracers in the fluid phase, we show that the alcoves are shaped by the detachment of the boundary layer flow and the appearance of a pinned vortex at the leading edge of the indentations. The attached boundary layer past the developing alcove is then found to lead to rounding of the other sides and the gradual sloping of the floor.

58 GEOSCIENCES↗

Unstable Invasion of Sedimenting Granular Suspensions

Here we investigate the development of mobility inversion and fingering when a granular suspension is injected radially between horizontal parallel plates of a cell filled with a miscible fluid. While the suspension spreads uniformly when the suspension and the displaced fluid densities are exactly matched, even a small density difference is found to result in a dense granular front which develops fingers with angular spacing that increase with granular volume fraction and decrease with injection rate. We show that the timescale over which the instability develops is given by the volume fraction dependent settling timescale of the grains in the cell. We then show that the mobility inversion and the nonequilibrium Korteweg surface tension due to granular volume fraction gradients determine the number of fingers at the onset of the instability in these miscible suspensions.

02 PETROLEUM↗

Granular bed consolidation, creep, and armoring under subcritical fluid flow

In this work, we show that a freshly sedimented granular bed settles and creeps forward over extended periods of time under an applied hydrodynamic shear stress which is below the critical value for bedload transport. The rearrangements are found to last over a timescale which is millions of times the sedimentation timescale of a grain in the fluid. Compaction occurs uniformly throughout the bed, but creep is observed to decay exponentially with depth and decreases over time. The granular volume fraction in the bed is found to increase logarithmically, saturating at the random close packing value Φ rcp ≈ 0.64, while the surface roughness is observed to remain essentially unchanged. We demonstrate that an increasingly higher shear stress is required to erode the bed, after a subcritical shear is applied, which results in an increase in its volume fraction. Thus, we find that bed armoring occurs due to a deep shear-induced relaxation of the bed toward the volume fraction associated with the glass transition.

58 GEOSCIENCES↗

Headward growth and branching in subterranean channels

We investigate the erosive growth of channels in a thin subsurface sedimentary layer driven by hydrodynamic drag toward understanding subterranean networks and their relation to river networks charged by ground water. Building on a model based on experimental observations of fluid-driven evolution of bed porosity, we focus on the characteristics of the channel growth and their bifurcations in a horizontal rectangular domain subject to various fluid source and sink distributions. We find that the erosion front between low- and high-porosity regions becomes unstable, giving rise to branched channel networks, depending on the spatial fluctuations of the fluid flow near the front and the degree to which the flow is above the erodibility threshold of the medium. Focusing on the growth of a network starting from a single channel, and by identifying the channel heads and their branch points, we find that the number of branches increases sublinearly and is affected by the source distribution. The mean angles between branches are found to be systematically lower than river networks in humid climates and depend on the domain geometry.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Critical shear rate and torque stability condition for a particle resting on a surface in a fluid flow

In this work, we advance a quantitative description of the critical shear rate $\dot{\gamma}_{c}$ needed to dislodge a spherical particle resting on a surface with a model asperity in laminar and turbulent fluid flows. We have built a cone-plane experimental apparatus which enables measurement of $\dot{\gamma}_{c}$ over a wide range of particle Reynolds number Re p from 10–3 to 1.5 × 10 3 . The condition to dislodge the particle is found to be consistent with the torque balance condition after including the torque component due to drag about the particle center. The data for Re p < 0.5 is in good agreement with analytical calculations of the drag and lift coefficients in the Re p → 0 limit. For higher Rep, where analytical results are unavailable, the hydrodynamic coefficients are found to approach a constant for Re p > 1000. We show that a linear combination of the hydrodynamic coefficients found in the viscous and inertial limits can describe the observed $\dot{\gamma}_{c}$ as a function of the particle and fluid properties.

02 PETROLEUM↗

Report on Physics of Channelization: Theory, Experiment, and Observation

The project involved a study of physical processes that create eroded channel and drainage networks. A particular focus was on how the shape of the channels and the network depended on the nature of the fluid flow. Our approach was to combine theoretical, experimental, and observational studies in close collaboration with Professor Daniel Rothman of the Massachusetts Institute of Technology. Laboratory -scaled experiments were developed and quantitative data on the shape of the pattern and erosion dynamics are obtained with a laser-aided topography technique and fluorescent optical imaging techniques.

58 GEOSCIENCES↗

Shape and dynamics of seepage erosion in a horizontal granular bed

We examine erosion patterns observed in a horizontal granular bed resulting from seepage of water motivated by observation of beach rills and channel growth in larger scale land forms. Our experimental apparatus consists of a wide rectangular box filled with glass beads with a narrow opening in one of the side walls from which eroded grains can exit. Quantitative data on the shape of the pattern and erosion dynamics are obtained with a laser-aided topography technique.We report that the spatial distribution of the source of groundwater can significantly impact the shape of observed patterns. An elongated channel is observed to grow upstream when groundwater is injected at a boundary adjacent to a reservoir held at constant height. An amphitheater (semicircular) shape is observed when uniform rainfall infiltrates the granular bed to maintain a water table. Bifurcations are observed as the channels grow in response to the groundwater. We further find that the channels grow by discrete avalanches as the height of the granular bed is increased above the capillary rise, causing the deeper channels to have rougher fronts. The spatiotemporal distribution of avalanches increase with bed height when partial saturation of the bed leads to cohesion between grains. Yet, the overall shape of the channels is observed to remain unaffected indicating that seepage erosion is robust to perturbation of the erosion front.

58 GEOSCIENCES↗

Physical test of a particle simulation model in a sheared granular system

We report a detailed comparison of a slow gravity driven sheared granular flow with a computational model performed with the Large-scale Atomic/Molecular Massively Parallel Simulator (LAMMPS). To our knowledge, this is the first thorough test of the LAMMPS model with a laboratory granular flow. In the experiments, grains flow inside a silo with a rectangular cross-section, and are sheared by a rough boundary on one side and smooth boundaries on the other sides. Individual grain position and motion are measured using a particle index matching imaging technique where a fluorescent dye is added to the interstitial liquid which has the same refractive index as the glass beads. The boundary imposes a packing order, and the grains are observed to flow in layers which get progressively more disordered with distance from the walls. The computations use a Cundall--Strack contact model between the grains, using contact parameters that have been used in many other previous studies, and ignore the hydrodynamic effects of the interstitial liquid. Computations are performed to understand the effect of particle coefficient of friction, elasticity, contact model, and polydispersity on mean flow properties. After appropriate scaling, we find that the mean velocity of the grains and the number density as a function of flow cross-section observed in the experiments and the simulations are in excellent agreement. The mean flow profile is observed to be unchanged over a broad range of coefficient of friction, except near the smooth wall. We show that the flow profile is not sensitive to atleast 10\percent polydispersity in particle size. Because the grain elasticity used is smaller in the computations as compared with glass grains, wave-like features can be noted over short time scales in the mean velocity and the velocity auto-correlations measured in the simulations. These wave features occur over an intermediate timescale larger than the particle interaction but smaller than the timescale of the macroscopic flow features. The wave features become more prominent as grain elasticity is further reduced. We then perform a detailed comparison of the particle fluctuation properties as measured by the displacement probability distribution function and the mean square displacement. Excellent agreement is observed over a time interval over which particles can be tracked effectively in the experiments. Using the longer tracking intervals possible in the simulations, we find that the diffusion inthe layers is greater in the flow direction, than in the perpendicular direction. Further signatures of confinement and hopping between layers is observed. All in all, our study provides strong support for the LAMMPS model of granular flow, and further supports the hypothesis that the interstitial liquid has negligible effects on granular fluctuations provided the flow is slow.

36 MATERIALS SCIENCE↗