Engineering topics

Kuether, R. J.

Publications and source records attributed to Kuether, R. J..

3 records

DOE OSTI2023

Nonlinear dynamics, bifurcations, and multi-stability in a vibro-impact system with geometric and multi-segmented freeplay nonlinearities

Freeplay is a common type of piecewise-smooth nonlinearity in dynamical systems, and it can cause discontinuity-induced bifurcations and other behaviors that may bring about undesirable and potentially damaging responses. Prior research has focused on piecewise-smooth systems with two or three distinct regions, but less attention is devoted to systems with more regions (i.e., multi-segmented systems). In this work, numerical analysis is performed on a dynamical system with multi-segmented freeplay, in which there are four stiffness transitions and five distinct regions in the phase space. Here, the effects of the multi-segmented parameters are studied through bifurcation diagram evolution along with induced multi-stable behavior and different bifurcations. These phenomena are interrogated through various tools, such as harmonic balance, basins of attraction, phase planes, and Poincaré section analysis. Results show that among the three multi-segmented parameters, the asymmetry has the strongest effect on the response of the system.

42 ENGINEERING↗

DOE OSTI2022

Measuring nonlinearities of a cantilever beam using a low-cost efficient wireless intelligent sensor for strain (LEWIS-S)

In the context of experimental vibration data, strain gauges can obtain linear and nonlinear dynamic measurements. However, measuring strain can be disincentivizing and expensive due to the complexity of data acquisition systems, lack of portability, and high costs. This research introduces the use of a low-cost efficient wireless intelligent sensor for strain (LEWIS-S) that is based on a portable-sensor-design platform that streamlines strain sensing. Additionally, the softening behavior of a cantilever beam with geometric and inertial nonlinearities is characterized by the LEWIS-S based on high force level inputs. Two experiments were performed on a nonlinear cantilever beam with measurements obtained by the LEWIS-S sensor and an accelerometer. First, a sine sweep test was performed through the fundamental resonance of the system, then a ring-down test was performed from a large initial static deformation. Good agreement was revealed in quantities of interest such as frequency response functions, the continuous wavelet transforms, and softening behavior in the backbone curves.

42 ENGINEERING↗

DOE OSTI2021

Insights on the continuous representations of piecewise-smooth nonlinear systems: limits of applicability and effectiveness

Dynamical systems subject to intermittent contact are often modeled with piecewise-smooth contact forces. However, the discontinuous nature of the contact can cause inaccuracies in numerical results or failure in numerical solvers. Representing the piecewise contact force with a continuous and smooth function can mitigate these problems, but not all continuous representations may be appropriate for this use. Here, five representations used by previous researchers (polynomial, rational polynomial, hyperbolic tangent, arctangent, and logarithm-arctangent functions) are studied to determine which ones most accurately capture nonlinear behaviors including super- and subharmonic resonances, multiple solutions, and chaos. The test case is a single-DOF forced Duffing oscillator with freeplay nonlinearity, solved using direct time integration. This work intends to expand on past studies by determining the limits of applicability for each representation and what numerical problems may occur.

42 ENGINEERING↗