Search NASASearch

Engineering topics

Kufeld, Robert M.

Publications and source records attributed to Kufeld, Robert M..

UH-60A Airloads Flight Test Program: Data Counter 8534

During the period between July 1993 and February 1994 the data collection portion of the UH-60A Airloads Program was conducted. At the time, UH-60A Airloads Program was the most comprehensive and data rich rotorcraft flight test program that NASA and the Army had ever attempted. It was part of the Modern Technology Rotor Program, where several different rotors were to be tested in small and full-scale wind tunnels combined with flight testing. This would allow for comparison between the various tests and comprehensive analyses. Results were to be stored in a comprehensive, easily accessed, database know as Tilt Rotor Engineering Database System, TRENDS. With over 30 years of rotor testing experience, the goal of NASA and the Army was to collect a wide and extensive amount of data to improve the understanding of rotors and prediction codes.

Kufeld, Robert M.

UH-60A Airloads Flight Test Program: Data Counter 8513

The data collection portion of the UH-60A Airloads Flight Test Program was conducted between July 1993 and February 1994. At the time, the UH-60A Airloads Program was the most comprehensive and data-rich rotorcraft flight test program that NASA and the U.S. Army had ever attempted. It was part of the Modern Technology Rotors Program, where several different rotors were tested in small- and full-scale wind tunnels combined with flight testing. The UH-60A portion of this program allowed for comparison between other tests performed and served as a scientific quality database for validating current and new computational and simulation models. The UH-60A flight test data was stored in a comprehensive, easily accessed database known as the Tilt Rotor Engineering Database System, or TRENDS. With over 30 years of rotor testing experience, NASA and the Army’s goal of the Airloads Flight Test Program was to collect data for a wide range of operating conditions and provide an extensive amount of data to improve the understanding of rotors and validate and improve prediction codes. This report presents the entire archived data set from Counter 8513 (Run 85, point 13) from the UH-60A Airloads Flight Test Program. There were 1,078 total data set counters acquired and archived during 57 accumulated flight hours and 31 research flights. Over 900 counters were research flight data acquisition data points. Counter 8513 is a low-speed, level-flight test condition.

Kufeld, Robert M.

UH-60A Airloads Flight Test Program: Data Counter 9017

Aeromechanics Branch interns at Ames Research Center have been directly contributing to the data quality analysis and reporting of the UH-60A Airloads Flight Test Program for many years. In chronological order (together with the semester and year): Caroline Edwards (Summer 2011); Joni DeGuzman and Carson Turner (Fall 2011); Eric Fritz (Spring 2012); Connor Beierle (Fall 2012); Christopher Olinger (Spring and Summer 2013); Needa Lin, Anatole Levkoff, Maxwell Loebig, Jose Orejel, Megan Prout, and Albert Sue (Summer 2014); Jared Archey (Fall 2014); Alexander Crone (Summer 2015); Jeffrey Diament, Austin Djang, and Jessica Swan (Summer 2016); Makenzie Allen (Summer 2017); Colin Lauzon (Fall 2017); Eric Gilkey (Spring 2018); and Nicholas Masso (Summer 2019). These interns have spent their internships reviewing flight logs, extracting the data out of TRENDS, formatting the data into spreadsheets, writing code to automate the process, and plotting results. Without their efforts, much of the work would be unfinished. The authors appreciate the achievements of the UH-60A Airloads Working Group during its 20-year lifetime, as well the contributions of Randy Peterson, Tom Norman, and William Warmbrodt to the data processing and assistance with the report preparation. Lastly, this report is dedicated to William Bousman for his efforts preceding, during, and subsequent to the UH-60A Airloads Flight Test Program.

Kufeld, Robert M.

UH-60A Airloads Flight Test Program: Data Counter 9505

The data collection portion of the UH-60A Airloads Flight Test Program (ref. 1) was conducted between July 1993 and February 1994. At the time, the UH-60A Airloads Program was the most comprehensive and data-rich rotorcraft flight test program that NASA and the U.S. Army had ever attempted. It was part of the Modern Technology Rotors Program (ref. 2), where several different rotors were tested in small- and full-scale wind tunnels combined with flight testing. The UH-60A portion of this program allowed for comparison between other tests performed and served as a scientific quality database for validating current and new computational and simulation models. The UH-60A flight test data was stored in a comprehensive, easily accessed database known as the Tilt Rotor Engineering Database System, or TRENDS (ref. 3). With over 30 years of rotor testing experience (ref. 4), NASA and the Army’s goal of the Airloads Flight Test Program was to collect data for a wide range of operating conditions, and to provide an extensive amount of data to improve the understanding of rotors and validate and improve prediction codes. This report presents the entire archived data set from Counter 9505 (Run 95, point 5) from the UH-60A Airloads Flight Test Program. There were 1,078 total data set counters acquired and archived during 57 accumulated flight hours and 31 research flights. Over 900 counters were research flight data acquisition data points. Counter 9505 is a low altitude, moderate airspeed, level-flight test condition. Ground acoustic microphone data was acquired for this counter but the acoustic data is not included in this report.

Kufeld, Robert M.

Measurement of the UH-60A Hub Large Rotor Test Apparatus Control System Stiffness

This purpose of this report is to provides details of the measurement of the control system stiffness of the UH-60A rotor hub mounted on the Large Rotor Test Apparatus (UH-60A/LRTA). The UH-60A/LRTA was used in the 40- by 80-Foot Wind Tunnel to complete the full-scale wind tunnel test portion of the NASA / ARMY UH-60A Airloads Program. This report describes the LRTA control system and highlights the differences between the LRTA and UH-60A aircraft. The test hardware, test setup, and test procedures are also described. Sample results are shown, including the azimuthal variation of the measured control system stiffness for three different loadings and two different dynamic actuator settings. Finally, the azimuthal stiffness is converted to fixed system values using multi-blade transformations for input to comprehensive rotorcraft prediction codes.

Large Rotor Test Apparatus

Unsteady Aerodynamic Behavior Measured in Hovering Flight

A highly-instrumented UH-60A aircraft was tested at NASA-Ames Research Center from August 1993 to February 1994 obtaining an extensive data base for level flight, maneuvers, acoustics (both with respect to ground microphone arrays and inflight microphones), and flight dynamics. A majority of the data obtained are now in an electronic data base, however, only a small fraction of the data have been examined. The proposed paper will examine the issue of hovering steadiness in more detail. In particular, a single set of data obtained during ground acoustic testing may provide considerable insight as the wind speeds were measured at a hover height of 250 feet and the aircraft was positioned in 15 deg. steps in heading from 0 to 180 deg. Also, hover housekeeping data were obtained for many of the 31 flights and these will also allow a characterization of the unsteadiness. The variation in section lift will be examined in terms of the induced flow angle variation and this will be related to possible physical explanations.

Bousman, William G.

UH-60 Airloads Program - Status and plans

The present paper addresses the background of the UH-60 Airloads Program, the instrumentation, data requirements, and the development of the data collection and storage systems. An outline of the data points to be collected and detail of data access are presented. The Outside Experiment Program, in which researchers outside of NASA propose potential flight experiments, is described. Attention is given to the development of research systems necessary to conduct the program. Significant improvements in data acquisition, processing, and storage quality are stated as the primary objectives as dictated from lessons learned during past rotor airloads flight research programs.

Kufeld, Robert M.

Modal analysis of UH-60A instrumented rotor blades

The dynamic characteristics of instrumented and production UH-60A Black Hawk main rotor blades were measured, and the results were validated with NASTRAN finite element models. The blades tested included pressure and strain-gage instrumented blades, which are part of the NASA Airloads Flight Research Phase of the Modern Technology Rotor Program. The dynamic similarity of the blades was required for accurate data collection in this program. Therefore, a nonrotating blade modal analysis was performed on the first 10 free-free modes to measure blade similarities. The results showed small differences between the modal frequencies of instrumented and production blades and a close correlation with the NASTRAN models. This type of modal testing and analysis is recommended as a standard procedure for future instrumented blade flight testing.

Hamade, Karen S.

Modal analysis of UH 60A instrumented rotor blades

The dynamic characteristics of instrumented and production UH-60A Black Hawk main rotor blades were measured, and the results were validated with NASTRAN finite element models. The blades tested included pressure and strain-gage instrumented blades which are part of NASA's Airloads Flight Research Phase of the Modern Technology Rotor Program. The dynamic similarity of the blades was required for accurate data collection in this program. Therefore, a nonrotating blade modal analysis was performed on the first 10 free-free modes to measure blade similarities. The results showed small differences between the modal frequencies of instrumented and production blades and a close correlation with the NASTRAN models. This type of modal testing and analysis is recommended as a standard procedure for future instrumented blade flight testing.

Hamade, Karen S.

In-flight measurement of rotor hub drag using the RSRA - A feasibility demonstration

The Rotor Systems Research Aircraft (RSRA) is a compound helicopter that was test flown as a fixed-wing aircraft, with the main rotor blades removed and the rotor hub installed. An onboard rotor load-measurement system measured the resulting rotor hub drag and lift. Measured hub drag and lift are plotted for comparison to that predicted by full-scale and 1/6-scale model wind-tunnel tests. The success of the demonstration gives confidence that planned improvements to the RSRA will allow high-accuracy hub drag and lift measurements to be made in flight on a routine research basis.

Acree, C. W., Jr.