Search NASA⌕ Search

Engineering topics

Kumar, R.

Publications and source records attributed to Kumar, R..

At least 163 records · Page 9

Frequency Estimation Techniques For High Dynamic Trajectories

Report presents comparative study of four techniques for estimating frequency of sinusoidal signal received in presence of noise when transmitter and/or receiver experiencing very high dynamics. Four techniques involve approximate-maximum-likelihood estimator, extended Kalman filter, cross-product automatic frequency control loop, and digital phase locked loop, respectively. In numerical simulations, each technique applied to signal from transmitter maneuvering along common trajectory; performance of each examined to determine its useful operating range, and performances compared.

Vilnrotter, V. A.↗

Application of adaptive least-squares algorithm to multi-element array signal reconstruction

Results are presented in terms of the performance improvement of a multi-feed array configuration over the usual single feed system when an adaptive least-squares algorithm is applied for the signal reconstruction. Two versions of the least-squares algorithm are presented, one of which is based on the maximization of the signal-to-noise ratio while the other is based on the deconvolution of received signal field. These algorithms were developed for the purpose of minimizing degradations arising from various sources, which can severely limit the performance (gain) of a single-feed system.

Kumar, R.↗

Efficient detection and signal parameter estimation with applications to high dynamic GPS receivers

A novel technique for simultaneously detecting data and estimating the parameters of a received carrier signal phase modulated by unknown data and experiencing very high Doppler, Doppler rate, etc. is discussed. Such a situation arises, for example, in the case of Global Positioning Systems (DPS) where the signal parameters are directly related to the position, velocity and acceleration of the GPS receiver. The proposed scheme is based upon first estimating the received signal local (data dependent) parameters over two consecutive bit periods, followed by the detection of a possible jump in these parameters. The presence of a detected jump signifies a data transition which is then removed from the received signal. This effectively demodulated signal is then processed to provide the estimates of global (data independent) parameters of the signal related to the position, velocity, etc. of the receiver. One of the key features of the proposed algorithm is the introduction of two different schemes which can provide an improvement of up to 3 dB over the conventional implementation of Kalman filter as applied to phase and frequency estimation, under low to medium signal-to-noise ratio conditions.

Kumar, R.↗

A comparison of frequency estimation techniques for high-dynamic trajectories

A comparison is presented for four different estimation techniques applied to the problem of continuously estimating the parameters of a sinusoidal Global Positioning System (GPS) signal, observed in the presence of additive noise, under extremely high-dynamic conditions. Frequency estimates are emphasized, although phase and/or frequency rate are also estimated by some of the algorithms. These parameters are related to the velocity, position, and acceleration of the maneuvering transmitter. Estimated performance at low carrier-to-noise ratios and high dynamics is investigated for the purpose of determining the useful operating range of an approximate Maximum Likelihood (ML) estimator, an Extended Kalman Filter (EKF), a Cross-Product Automatic Frequency Control (CPAFC) loop, and a digital phase-locked loop (PPL). Numerical simulations are used to evaluate performance while tracking a common trajectory exhibiting high dynamics.

Vilnrotter, V. A.↗

Fixed lag smoothers for carrier phase and frequency tracking

The application of fixed lag smoothing algorithms are presented for the problem of estimation of the phase and frequency of a sinusoidal carrier received in the presence of process noise and additive observation noise. A suboptimal structure consists of a phase-locked loop (PLL) followed by a post loop correction to the phase and frequency estimates. When the PLL is operating under a high signal-to-noise ratio, the phase detector is approximately linear, and the smoother equations then correspond to the optimal linear equations for an equivalent linear signal model. The performance of such a smoother can be predicted by the linear filtering theory. However, if the PLL is operating near the threshold region of the signal to noise ratio, the phase detector cannot be assumed to be linear. Then the actual performance of the smoother can significantly differ from that predicted by linear filtering theory. Both the theoretical and simulated performance of such smoothers derived on the basis of various models for the phase of frequency processes are presented.

Kumar, R.↗

Improvement of cloud cover assessment of Landsat Thematic Mapper data

Various methods for cloud cover assessment of Landsat TM data are compared and evaluated. A total of 3906 TM 241-mm black-and-white photo prints of different seasons and regions were assessed manually. These images were mostly in band 4 (0.76-0.90 microns) for daytime data and band 6 (10.4-12.5 microns) for nighttime data. The results of this manual assessment are compared to available automated and manual assessments, and the differences between results obtained by various methods are discussed.

Ludwig, R.↗

A comparison of methods for DPLL loop filter design

Four design methodologies for loop filters for a class of digital phase-locked loops (DPLLs) are presented. The first design maps an optimum analog filter into the digital domain; the second approach designs a filter that minimizes in discrete time weighted combination of the variance of the phase error due to noise and the sum square of the deterministic phase error component; the third method uses Kalman filter estimation theory to design a filter composed of a least squares fading memory estimator and a predictor. The last design relies on classical theory, including rules for the design of compensators. Linear analysis is used throughout the article to compare different designs, and includes stability, steady state performance and transient behavior of the loops. Design methodology is not critical when the loop update rate can be made high relative to loop bandwidth, as the performance approaches that of continuous time. For low update rates, however, the miminization method is significantly superior to the other methods.

Aguirre, S.↗

Fast frequency acquisition via adaptive least squares algorithm

A new least squares algorithm is proposed and investigated for fast frequency and phase acquisition of sinusoids in the presence of noise. This algorithm is a special case of more general, adaptive parameter-estimation techniques. The advantages of the algorithms are their conceptual simplicity, flexibility and applicability to general situations. For example, the frequency to be acquired can be time varying, and the noise can be nonGaussian, nonstationary and colored. As the proposed algorithm can be made recursive in the number of observations, it is not necessary to have a priori knowledge of the received signal-to-noise ratio or to specify the measurement time. This would be required for batch processing techniques, such as the fast Fourier transform (FFT). The proposed algorithm improves the frequency estimate on a recursive basis as more and more observations are obtained. When the algorithm is applied in real time, it has the extra advantage that the observations need not be stored. The algorithm also yields a real time confidence measure as to the accuracy of the estimator.

Kumar, R.↗

A class of optimum digital phase locked loops

This paper presents a class of optimum digital filters for digital phase locked loops, for the important case in which the maximum update rate of the loop filter and numerically controlled oscillator (NCO) is limited. This case is typical when the loop filter is implemented in a microprocessor. In these situations, pure delay is encountered in the loop transfer function and thus the stability and gain margin of the loop are of crucial interest. The optimum filters designed for such situations are evaluated in terms of their gain margin for stability, dynamic error, and steady-state error performance. For situations involving considerably high phase dynamics an adaptive and programmable implementation is also proposed to obtain an overall optimum strategy.

Kumar, R.↗

A class of optimum digital phase locked loops for the DSN advanced receiver

A class of optimum digital filters for digital phase locked loop of the deep space network advanced receiver is discussed. The filter minimizes a weighted combination of the variance of the random component of the phase error and the sum square of the deterministic dynamic component of phase error at the output of the numerically controlled oscillator (NCO). By varying the weighting coefficient over a suitable range of values, a wide set of filters are obtained such that, for any specified value of the equivalent loop-noise bandwidth, there corresponds a unique filter in this class. This filter thus has the property of having the best transient response over all possible filters of the same bandwidth and type. The optimum filters are also evaluated in terms of their gain margin for stability and their steady-state error performance.

Hurd, W. J.↗

Separability of agricultural cover types in spectral channels and wavelength regions

This study was a continuation of a more complete evaluation of the spectral channels as well as wavelength regions - visible, near infrared, middle infrared, and thermal infrared - with respect to their estimated probability of correct classification Pc in discriminating agricultural cover types reported previously by Kumar and Silva (1977). Multispectral scanner data in twelve spectral channels in the wavelength range of 0.4-11.7 microns acquired in the middle of July for three flightlines were analyzed by applying automatic pattern recognition techniques. The same analysis was performed for the data acquired in the middle of August 1971, over the same three flightlines, to investigate the effect of time on the results. The effect of deletion of each spectral channel as well as each wavelength region on Pc is given. Values of Pc for all possible combinations of wavelength regions in the subsets of one to twelve spectral channels are also given. The overall values of Pc were found to be greater for the data of the middle of August than the data of the middle of July.

Kumar, R.↗

Calibration of long wavelength Exotech model 20C spectroradiometer

A brief description of the Exotech model 20C field spectroradiometer, which measures the spectral radiance of a target in the wavelength ranges from 0.37 to 2.5 microns (short wavelength unit), 2.8 to 5.6 microns, and 7.0 to 14 microns (long wavelength unit) is given. It is a rugged field instrument which uses four circular-variable-filters to get wavelength scan. Wavelength calibration of the long wavelength unit was done by use of the strong, sharp, and accurately known absorption bands of polystyrene, atmospheric carbon dioxide, and methyl cyclohexane (liquid) in the IR wavelength region. The spectral radiance calibration was done by recording spectral scans of the hot and the cold blackbody targets and assuming that spectral radiance varies linearly with the signal.

Kumar, R.↗

Effect of the atmosphere on the classification of LANDSAT data

The author has identified the following significant results. In conjunction with Turner's model for the correction of satellite data for atmospheric interference, the LOWTRAN-3 computer was used to calculate the atmospheric interference. Use of the program improved the contrast between different natural targets in the MSS LANDSAT data of Brasilia, Brazil. The classification accuracy of sugar canes was improved by about 9% in the multispectral data of Ribeirao Preto, Sao Paulo.

Dejesusparada, N.↗

Calibration of longwavelength exotech model 20-C spectroradiometer

A brief description of the Exotech model 20-C field spectroradiometer which measures the spectral radiance of a target in the wavelength ranges 0.37 to 2.5 microns (short wavelength unit), 2.8 to 5.6 microns and 7.0 to 14 microns (long wavelength unit) is given. Wavelength calibration of long wavelength unit was done by knowing the strong, sharp and accurately known absorption bands of polystyrene, atmospheric carbon dioxide and methyl cyclohexane (liquid) in the infrared wavelength region. The spectral radiance calibration was done by recording spectral scans of the hot and the cold blackbodies and assuming that spectral radiance varies linearly with the signal.

Kumar, R.↗