Engineering topics
Kurata-Nishimura, M.
Publications and source records attributed to Kurata-Nishimura, M..
Multiplicity trigger detector for the S π RIT experiment
A multiplicity trigger detector (MTD) was developed for the SπRIT experiment that aims to probe the high- density symmetry energy via heavy-ion collisions (HICs). The MTD is designed to measure the charged-particle multiplicity in HICs to provide a trigger signal that can be used to select high-multiplicity events induced by central collisions. The MTD consists of two side-walls segmented into 30 plastic scintillation paddles, each equipped with a multi-pixel photon counter. A custom board with EASIROC front-end ASIC is used as readout electronics. A multiplicity logic signal is generated by an on-board FPGA that processes the discriminated signals from EASIROCs. The overall latency of the whole detector system for outputting the trigger is less than 100 ns, including 52 ns of electronics latency for processing the signals. During the measurement of 112 Sn + 124 Sn reactions at an incident energy of 270 MeV/nucleon, the minimum multiplicity threshold of the MTD was set to 4, where the overall trigger efficiency was obtained to be about 39 % for inclusive nuclear reactions. Furthermore, a simulation study with a numerical calculation of HICs found that the central collisions of impact parameters of less than 4 fm can be triggered with a high efficiency of more than 95 % by the experimental trigger condition.
Rapidity distributions of Z = 1 isotopes and the nuclear symmetry energy from Sn+Sn collisions with radioactive beams at 270 MeV/nucleon
The rapidity distributions of hydrogen isotopes emitted from central collisions of neutron-rich 132 Sn+ 124 Sn and neutron-deficient 108 Sn+ 112 Sn systems at 270 MeV/nucleon were investigated at RIKEN-RIBF. The data are compared with antisymmetrized molecular dynamics (AMD) calculations and the rapidity distributions can be reproduced after adjusting the in-medium nucleon-nucleon cross sections. The double ratios between the two reaction systems taken for the relative yields of deuteron to proton (d/p) and triton to proton (t/p) are further examined in the midrapidity domain, where the adjustments in the AMD calculations do not affect much on them. The d/p and t/p double ratios at midrapidity agree well with the ratio of the system neutron numbers and its squared value, respectively, and the rapidity dependence of these double ratios is consistent with a picture of partial mixing of colliding nuclei. By comparing with the AMD model which shows a strong symmetry energy dependence of the t/p double ratio, the experimental result in the midrapidity domain favors the calculation with a symmetry-energy slope parameter around L = 46 MeV rather than L = 108 MeV.