Search NASA⌕ Search

Engineering topics

Kuszynski, Jason E.

Publications and source records attributed to Kuszynski, Jason E..

Cooling Mixed A-Site Halide Perovskites: Impact of Temperature on Optical and Structural Properties

The widespread utilization of perovskite-based photovoltaics requires probing both the structural and optical properties under extreme operating conditions to gain a holistic understanding of the material behavior under stressors. Here, in this study, we investigate the temperature-dependent behavior of mixed A-site cation lead triiodide perovskite thin films (85% methylammonium and 15% formamidinium) in the range from 300 to 20 K. Through a combination of optical and structural techniques, we find that the tetragonal-to-orthorhombic phase transition occurs at similar to 110 K for this perovskite composition, as indicated by the change in the diffraction pattern. With decreasing temperature, the quantum yield increases with a concurrent elongation of the carrier lifetimes, indicating suppression of nonradiative recombination pathways. Interestingly, in contrast to single A-site cation perovskites, an additional optical transition appears in the absorption spectrum when the phase transition is approached, which is also reflected in the emission spectrum. We propose that the splitting of the optical absorption and emission is due to local segregation of the mixed cation perovskite during the phase transition.

36 MATERIALS SCIENCE↗

Plasmon-Induced Hot-Carrier Excited-State Dynamics in Plasmonic Semiconductor Nanocrystals

The variance of carrier relaxation pathways for WO 3–x plasmonic semiconductor nanocrystals (PSNCs) is monitored by transient absorption spectroscopy following excitation of the localized surface plasmon resonance (LSPR) versus the optical band gap (E g,opt ). Excitation of the LSPR leads to efficient hot carrier population above the Fermi level in WO 3–x via Landau damping, in analogy to noble metal LSPR relaxation mechanisms. Hot carrier depopulation occurs on the femtosecond timescale, observed as the concomitant recovery of an LSPR bleach with the appearance of discrete interband and intraband photoinduced absorption features. Further, by comparison, the direct excitation of E g,opt results in trion recombination at donor–acceptor sites within the WO 3–x NC, consistent with exciton decay dynamics observed for typical wide-band-gap semiconductor NCs. From the analysis of pump power dependency data, a hot-carrier electron–phonon coupling constant of 1.47 × 10 11 J K –1 s –1 cm –3 is extracted. The direct comparison of the decay dynamics following E g,opt versus LSPR excitation confirms that the observed plasmon in trioctylphosphine oxide passivated, spherical WO 3–x is a resonance state in which hot carriers are generated only from excitation on resonance with the LSPR frequency. This study on WO 3–x PSNCs provides a toolset that can be used to evaluate the role of hot carriers following LSPR excitation of n-type, plasmonic transparent conducting oxide NCs, where enhancement of photocatalysis, photovoltaic performance, and optical enhancement has been reported.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Cool carriers: triplet diffusion dominates upconversion yield

Perovskites have gained popularity both as the active material in photovoltaics and as bulk triplet sensitizers for solid-state triplet–triplet annihilation upconversion (TTA-UC). Prior to widespread implementation into commercial photovoltaics, an in-depth understanding of the environmental influences on device performance is required. To this point, the temperature-dependent structure–function properties of TTA-UC within methylammonium formamidinium lead triiodide (MAFA)/rubrene UC devices are explored. A strong temperature dependence of the underlying UC dynamics is observed, where the maximum UC efficiency is achieved at 170 K, reflecting the competition between triplet diffusion length, diffusion rate, and triplet–triplet encounter events. Furthermore, a combination of spectroscopic and structural methods and theoretical modelling illustrates that despite the significantly increased carrier lifetime of the perovskite at low temperatures, the TTA-UC dynamics are not governed by the underlying sensitizer properties but rather limited by the underlying triplet diffusion.

Sullivan, Colette M.↗

Surface Doping Boosts Triplet Generation Yield in Perovskite-Sensitized Upconversion

Triplet–triplet annihilation-based photon upconversion (TTA-UC) can efficiently generate higher energy photons at low relative fluences. Bulk metal halide perovskites have offered promise in efficiently sensitizing molecular triplet states in the solid state, necessary for the integration of TTA-UC into device-based applications. Recent work focused on TTA-UC from a rubrene triplet annihilator sensitized by perovskite thin films has established relatively efficient charge extraction from the perovskite, forming the triplet exciton in rubrene. Yet, the specifics underpinning charge transfer at the perovskite/rubrene interface are not fully elucidated. Here, to improve device performance and study the properties governing charge transfer at the interface, various organic solvents are explored to treat the perovskite surface. Scanning tunneling microscopy and spectroscopy show a difference in the electronic band structure, where both n- and p-type terminated perovskite surfaces are observed depending on the solvent used. Supported by optical spectroscopy, the impact of the perovskite electronic structure is monitored, indicating that n-type perovskite sensitizers feature higher TTA-UC efficiencies due to favorable band bending resulting in efficient hole-mediated triplet formation. Overall, the tuning of the electronic structure of the perovskite sensitizer through solvent treatment is shown to be a key force in tuning the mechanism of efficient triplet generation.

36 MATERIALS SCIENCE↗

Photoinduced reversible phase transition in a phenothiazine-based metal-organic framework

Photoinduced phase transitions in metal-organic frameworks are provoked by structural changes of photoresponsive linkers within the framework under light irradiation. These transitions are rare but fundamentally important as they can bring about light-switchability on a variety of properties of the materials. In this work, phenothiazine as a photoresponsive unit with distinctive photochemical properties is incorporated into a Zn-based metal-organic framework, PCN-401. The structural characterization of PCN-401 revealed a reversible structural transition upon light irradiation. The mechanisms behind the photoinduced phase transition are studied systematically by spectrometric methods and structural stability characterization. Our mechanistic studies successfully showcased how the phenothiazine unit in the framework undergoes structural transformation under light irradiation and how the reversible phase transition leads to the property changes. The findings have emphasized the significance of phenothiazine in photoresponsive materials and can serve as inspiration for the design and understandings of next-generation photoresponsive metal-organic materials.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Influence of Metal Identity on Light-Induced Switchable Adsorption in Azobenzene-Based Metal–Organic Frameworks

Energy-efficient capture and release of small gas molecules, particularly carbon dioxide (CO 2 ) and methane (CH 4 ), are of significant interest in academia and industry. Porous materials such as metal–organic frameworks (MOFs) have been extensively studied, as their ultrahigh porosities and tunability enable significant amounts of gas to be adsorbed while also allowing specific applications to be targeted. However, because of the microporous nature of MOFs, the gas adsorption performance is dominated by high uptake capacity at low pressures, limiting their application. Hence, methods involving stimuli-responsive materials, particularly light-induced switchable adsorption (LISA), offer a unique alternative to thermal methods. Here, we report the mechanism of a well-known LISA system, the azobenzene-based material PCN-250, for CO 2 and CH 4 adsorption. There is a noticeable difference in the LISA effect dependent on the metal cluster involved, with the most significant being PCN-250-Al, where the adsorption can change by 83.1% CH 4 and 56.1% CO 2 at 298 K and 1 bar and inducing volumetric storage changes of 36.2 and 33.9 cm 3 /cm 3 at 298 K between 5 and 85 bar (CH 4 ) and 2 and 9 bar (CO 2 ), respectively. Using UV light in both single-crystal X-ray diffraction and gas adsorption testing, we show that upon photoirradiation, the framework undergoes a “localized heating” phenomenon comparable to an increase of 130 K for PCN-250-Fe and improves the working capacity. Furthermore, this process functions because of the constrained nature of the ligand, preventing the typical trans-to-cis isomerization observed in free azobenzene. In addition, we observed that the degree of localized heating is highly dependent on the metal cluster involved, with the series of isostructural PCN-250 systems showing variable performance based upon the degree of interaction between the ligand and the metal center.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

The thermally induced decarboxylation mechanism of a mixed-oxidation state carboxylate-based iron metal–organic framework

Investigations into a thermally generated decarboxylation mechanism for metal site activation and the generation of mesopores in a carboxylate iron-based MOF, PCN-250, have been conducted. PCN-250 exhibits an interesting oxidation state change during thermal treatment under inert atmospheres or vacuum conditions, transitioning from an Fe(III)3 cluster to a Fe(II)Fe(III) 2 cluster. To probe this redox event and discern a mechanism of activation, a combination of thermogravimetric analysis, gas sorption, scanning electron microscopy, 57 Fe Mössbauer spectroscopy, gas chromatography-mass spectrometry, and X-ray diffraction studies were conducted. The results suggest that the iron-site activation occurs due to ligand decarboxylation above 200 °C. This is also consistent with the generation of a missing cluster mesoporous defect in the framework. The resulting mesoporous PCN-250 maintains high thermal stability, preserving crystallinity after multiple consecutive high-temperature regeneration cycles. Additionally, the thermally reduced PCN-250 shows improvements in the total uptake capacity of methane and CO 2 .

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗