Engineering topics

Laforce, Soren

Publications and source records attributed to Laforce, Soren.

4 records

NASA NTRS2001

Pilot-Induced Oscillation Prediction With Three Levels of Simulation Motion Displacement

Simulator motion platform characteristics were examined to determine if the amount of motion affects pilot-induced oscillation (PIO) prediction. Five test pilots evaluated how susceptible 18 different sets of pitch dynamics were to PIOs with three different levels of simulation motion platform displacement: large, small, and none. The pitch dynamics were those of a previous in-flight experiment, some of which elicited PIOs These in-flight results served as truth data for the simulation. As such, the in-flight experiment was replicated as much as possible. Objective and subjective data were collected and analyzed With large motion, PIO and handling qualities ratings matched the flight data more closely than did small motion or no motion. Also, regardless of the aircraft dynamics, large motion increased pilot confidence in assigning handling qualifies ratings, reduced safety pilot trips, and lowered touchdown velocities. While both large and small motion provided a pitch rate cue of high fidelity, only large motion presented the pilot with a high fidelity vertical acceleration cue.

Schroeder, Jeffery A.↗

NASA NTRS1996

An Initial Examination of Roll-Lateral Coordination Motion Requirements in Flight Simulation

A piloted simulation that examined the effects of uncoordinated roll-lateral motion cues from a coordinated math model was conducted. The vehicle model represented a typical helicopter with satisfactory handling qualities in the roll-lateral axes. The task was a two-degree-of-freedom horizontal sidestep, where the pilot controlled lateral position through roll angle. The motion platform commands were varied via two motion control system gains. One gain reduced the ratio between platform roll angle to math model (and thus visual) roll angle. The other gain was placed on how much lateral platform movement would result from platform roll attitude in an attempt to align the apparent gravity vector vertically relative to the pilot. Gains from one to zero were examined in both axes. Thus, the true 1:1 motion case, where the motion cues matched the visual cues was evaluated. Pilots subjective ratings of motion fidelity matched well against an earlier developed motion fidelity criteria. Significant differences were noted in the fixed-base versus motion base configurations.

Schroeder, Jeffery A.↗

NASA NTRS1992

A demonstration of motion base design alternatives for the National Advanced Driving Simulator

A demonstration of the capability of NASA's Vertical Motion Simulator to simulate two alternative motion base designs for the National Advanced Driving simulator (NADS) is reported. The VMS is located at ARC. The motion base conditions used in this demonstration were as follows: (1) a large translational motion base; and (2) a motion base design with limited translational capability. The latter had translational capability representative of a typical synergistic motion platform. These alternatives were selected to test the prediction that large amplitude translational motion would result in a lower incidence or severity of simulator induced sickness (SIS) than would a limited translational motion base. A total of 10 drivers performed two tasks, slaloms and quick-stops, using each of the motion bases. Physiological, objective, and subjective measures were collected. No reliable differences in SIS between the motion base conditions was found in this demonstration. However, in light of the cost considerations and engineering challenges associated with implementing a large translation motion base, performance of a formal study is recommended.

Mccauley, Michael E.↗

NASA NTRS1992

Algorithmic improvements for simulator motion drive

Contemporary simulator motion drive algorithms typically are designed in an analog (continuous) environment, but are implemented in a digital (discrete) environment. The intended continuous system, specified as frequency domain (Laplace transform) transfer functions, may not be represented properly by the algorithms used for digital implementation. The motion drive software in use with the Vertical Motion Simulator at Ames Research Center was investigated recently; the original algorithms (Euler) were changed to a state transition method. Comparison of the frequency responses of the original and new implementations showed that the state transition method more closely approximates the desired analog responses. In addition, test pilots who evaluated both implementations preferred the motions generated with the state transition method over those generated with the Euler integration method.

Laforce, Soren↗