Search NASA⌕ Search

Engineering topics

Laing, John Robert

Publications and source records attributed to Laing, John Robert.

Defect Characterization for Material Assurance in Metal Additive Manufacturing (FY15-0664)

No industry-wide standards yet exist for minimum properties in additively manufactured (AM) metals. While AM alloys such as 17-4 precipitation hardened stainless steel have been shown to have average properties that can be comparable to wrought or cast product, they suffer from inconsistent performance. Variability in the feedstock powder, feature sizes, thermal history, and laser performance can lead to unpredictable surface finish, chemistry, phase content, and defects. To address this issue, rapid, efficient, high-throughput mechanical testing and data analysis was developed, providing profound statistical insight into the stochastic variability in properties. With this new approach, 1000’s of comprehensive tensile tests can be performed for the cost of 10’s of conventional tests. This new high-throughput approach provides a material qualification pathway that is commensurate with the quick turn-around benefit of AM.

36 MATERIALS SCIENCE↗

High fidelity measurement of room temperature creep in NW alloys

The objective of this work was to assemble instrumentation to do the best resolution strain measurements with available equipment overa long (goal of 3 month) period of time on 304L samples. Two creep tests were performed on 304L samples for 10 6 seconds and instrumented with both strain gages and extensometers. The results of the test show the difficulty in accurately instrumenting creep tests for long periods of time. While the data from the strain gages at 10 6 seconds proved to be still discernable from the background noise caused by temperature and air fluctuations and instrument noise, lower creep rates will require enhanced measurement techniques. An additional one to two orders of magnitude of elapsed time appears feasible.

36 MATERIALS SCIENCE↗

Effect of numerical parameters on characterizing the hardening behavior of ductile uniaxial tension specimens.

Many problems of practical importance involve ductile materials that undergo very large strains, in many cases to the point of failure. Examples include structures subjected to impact or blast loads, energy absorbing devices subjected to significant crushing, cold-forming manufacturing processes and others. One of the most fundamental pieces of data that is required in the analysis of this kind of problems is the fit of the uniaxial stress-strain curve of the material. A series of experiments where mild steel plates were punctured with a conical indenter provided a motivation to characterize the true stress-strain curve until the point of failure of this material, which displayed significant ductility. The hardening curve was obtained using a finite element model of the tensile specimens that included a geometric imperfection in the form of a small reduction in the specimen width to initiate necking. An automated procedure iteratively adjusted the true stress-strain curve fit used as input until the predicted engineering stress-strain curve matched experimental measurements. Whereas the fitting is relatively trivial prior to reaching the ultimate engineering stress, the fit of the softening part of the engineering stress-stain curve is highly dependent on the finite element parameters such as element formulation and initial geometry. Results by two hexahedral elements are compared. The first is a standard, under-integrated, uniform-strain element with hourglass control. The second is a modified selectively-reduced-integration element. In addition, the effects of element size, aspect ratio and hourglass control characteristics are investigated. The effect of adaptively refining the mesh based on the aspect ratio of the deformed elements is also considered. The results of the study indicate that for the plate puncture problem, characterizing the material with the same element formulation and size as used in the plate models is beneficial. On the other hand, using different element formulations, sizes or initial aspect ratios can lead to unreliable results.

36 MATERIALS SCIENCE↗