Engineering topics

Lange, T.

Publications and source records attributed to Lange, T..

3 records

DOE OSTI2024

Technological developments and accelerator improvements for the FRIB beam power ramp-up

The Facility for Rare Isotope Beams (FRIB) began operation with 1 kW beam power for scientific users in May 2022 upon completion of 8 years of project construction. The ramp-up to the ultimate beam power of 400 kW, planned over a 6-year period, will enable the facility to reach its full potential for scientific discovery in isotope science and applications. In December 2023, a record-high beam power of 10.4 kW uranium was delivered to the target. Technological developments and accelerator improvements are being made over the entire facility and are key to completion of the power ramp-up. Major technological developments entail the phased deployment of high-power beam-intercepting systems, including the charge strippers, the charge selection systems, the production target, and the beam dump, along with support systems, including non-conventional utilities (NCU) and remote handling facilities. Major accelerator improvements include renovations to aging legacy systems associated with experimental beam lines and system automation for improved operational efficiency and better machine availability. Experience must be gained to safely handle the increased radiological impacts associated with high beam power; extensive machine studies and advanced beam tuning procedures are needed to minimize uncontrolled beam losses for the desired operating conditions. This paper discusses the technological developments and accelerator improvements with emphasis on major R&D efforts.

43 PARTICLE ACCELERATORS↗

DOE OSTI2022

XE-100 modeling and simulation for neutronic analysis in MCNP6.2

XE-100 is a generation IV helium-cooled, graphite-moderated, pebble-bed reactor (HTGR). As part of the pathway toward a conceptually designing and licensing this reactor, an independent Monte Carlo model was created in MCNP6.2, and several distinct neutronic analyses were then performed. The double heterogeneity of TRISO fuel within graphite pebbles introduces unique modeling challenges related to particle and pebble clipping. The results show that for neutron and photon heating of ex-core components such as the reflector, RCSS, core barrel (CB), the model that contains clipping produces higher heating values. It is therefore concluded that removing clipping via compression of the particles and pebbles within the model distributes the neutrons and gammas preferentially toward the core center, and reduces the heating that is experienced toward the reactor periphery. Thus, the most conservative model for ex-core heating contains particle and pebble clipping. Also presented are results on the impact of chamfers that exist on the corners of graphite reflector blocks. As these chamfers could potentially create streaming paths, the neutron and gamma flux from the core to the CB were analyzed. It was determined that the chamfers do not significantly impact the neutron or gamma signatures on the CB, in that the shape of the neutron and photon flux on a detector imposed on the CB shows no preferential streaming path. (authors)

21 SPECIFIC NUCLEAR REACTORS AND ASSOCIATED PLANTS↗

NASA NTRS1985

Rationale for an experimental test for flexible space structure attitude control

The problems of large flexible spacecraft control are characterized by the infinite bandwidth of structural vibrations, which cannot be accounted for in the dynamic design model. This may lead to instability even, if ideal control hardware is assumed, which can be concluded from preceding numerical investigations. Additional performance limitations are expected to occur due to hardware constraints. A laboratory experiment is proposed to investigate the key problems in more detail. The test setup requirements being defined by the idealized control system are extremely high demanding a high speed processor and special hardware component developments. The test element is a wire suspended plate being controlled by an array processor via high performance sensors and actuators. First tests on component level indicate the feasibility of the system presently being developed.

Lange, T.↗