Engineering topics

Lansing, F. L.

Publications and source records attributed to Lansing, F. L..

At least 19 records

NASA NTRS1990

An Optimal Design For Steerable Dish Antenna With BWG

New design proposed for highly-efficient 34-m-diameter millimeter-wavelength antennas of NASA's Deep Space Network. Incorporates axial beam waveguide, BWG, and improved structure to maintain shape and alignment of reflecting surfaces. General approach to conceptual construction of structure to modularize overall system so critical constraint conditions pertaining to microwave optics and structural performance satisfied. Design retrofitted to existing NASA Deep Space Network 34-m antennas, or used as basis to build large ground-based steerable antennas. Engineering concepts involved in design adapted to design of other large, steerable antennas for telecommunications, radio astronomy, and military uses.

Chuang, K. L.↗

NASA NTRS1990

Disturbance-Accommodating Controller Would Aim Antenna

Proposed system for aiming large paraboloidal-dish antenna based on theory of disturbance-accommodating control. Existing methods of control combined to suppress systematic errors. Approach is to cancel static errors for precise pointing of antenna by treating systematic misalignment errors, as well as servo-commands, as disturbances to controlled system. In controller, another vector estimated simultaneously with estimation of state vector. Other vector represents disturbance state, used in determining more-complete control strategy. Aiming improved through sequence of modifications solely in existing software.

Gresham, L. L.↗

NASA NTRS1988

Photogrammetry Of A Parabolic Antenna

Surface measured with accuracy better than 10 to the negative fifth power times diameter. Report describes use of advanced close-range photogrammetry to determine deviations of 34-m-diameter antenna main reflector and subreflector from nominal paraboloidal shapes. Measurements enable removal of linear offsets and angular misalignments of subreflector, with consequent increase of 4 percent in aperture efficiency.

Merrick, W. D.↗

NASA NTRS1988

The Feasibility of the Disturbance Accommodating Controller for Precision Antenna Pointing

The objective of this study is to investigate the feasibility of a pointing (position loop) controller for the NASA-JPL Deep Space Network (DSN) antennas using the Disturbance Accommodating Control (DAC) theory. A model that includes state dependent disturbances was developed, and an example demonstrating the noise estimator is presented as an initial phase in the controller design. The goal is to improve pointing accuracy by the removal of the systematic errors caused by the antenna misalignment as well as sensor noise and random wind and thermal disturbances. Preliminary simulation results show that the DAC technique is successful in both cancelling the imposed errors and maintaining an optimal control policy.

Gresham, L. L.↗

NASA NTRS1987

Antenna pointing systematic error model derivations

The pointing model used to represent and correct systematic errors for the Deep Space Network (DSN) antennas is presented. Analytical expressions are given in both azimuth-elevation (az-el) and hour angle-declination (ha-dec) mounts for RF axis collimation error, encoder offset, nonorthogonality of axes, axis plane tilt, and structural flexure due to gravity loading. While the residual pointing errors (rms) after correction appear to be within the ten percent of the half-power beamwidth criterion commonly set for good pointing accuracy, the DSN has embarked on an extensive pointing improvement and modeling program aiming toward an order of magnitude higher pointing precision.

Guiar, C. N.↗

NASA NTRS1987

Structural design options for the new 34 meter beam waveguide antenna

In addition to the successful network of 34 m High Efficiency antennas recently built by JPL, the Deep Space Network (DSN) is embarking on the construction of a 34 m high performance, research and development antenna with beam waveguide optics at the Venus site. The construction of this antenna presents many engineering challenges in the area of structural, mechanical, RF, and pointing system design. A set of functional and structural design requirements is outlined to guide analysts in the final configuration selection. Five design concepts are presented covering both the conventional center-fed beam optics as well as the nonconventional, by-pass beam configuration. The merits of each concept are discussed with an emphasis on obtaining a homologous design. The preliminary results of structural optimization efforts, currently in progress, are promising, indicating the feasibility of meeting, as a minimum, all X-band (8.4 GHz) requirements, with a goal towards meeting Ka-band (32 GHz) quality performance, at the present budget constraints.

Katow, S.↗

NASA NTRS1986

Rivited panel surface measurement using photogrammetry

Two riveted antenna panels on rings number 3 and 9 were removed from the 34m antenna at DSS-15, fixed in the leveled position and the surface was photographed indoors. The results from this pilot photogrammetric demonstration and diagnostics of panel surface contours, are presented. The photogrammetric network for each panel incorporated eight photographs, two from each of four camera stations and observed over 200 targets. The accuracy (1 sigma) of the XYZ coordinates for the error ellipsoids was + or - 0.013 mm (0.0005 inch). This level of precision relative to the object size corresponds roughly to 1 part in 250,000 which is superior to conventional dial sweep-arm template techniques by at least a factor of 4.

Merrick, W. D.↗

NASA NTRS1985

Stable density stratification solar pond

A stable density-stratification solar pond for use in the collection and storage of solar thermal energy including a container having a first section characterized by an internal wall of a substantially cylindrical configuration and a second section having an internal wall of a substantially truncated conical configuration surmounting the first section in coaxial alignment therewith, the second section of said container being characterized by a base of a diameter substantially equal to the diameter of the first section and a truncated apex defining a solar energy acceptance opening is discussed. A body of immiscible liquids is disposed within the container and comprises a lower portion substantially filling the first section of the container and an upper portion substantially filling the second section of the container, said lower portion being an aqueous based liquid of a darker color than the upper portion and of a greater density. A protective cover plate is removably provided for covering the acceptance opening.

Lansing, F. L.↗

NASA NTRS1985

Solar-Power System Produces High-Pressure Steam

Combination of three multistaged solar collectors produces highpressure steam for large-scale continuously operating turbines for generating mechanical or electrical energy. Superheated water vapor drives turbines, attaining an overall system efficiency about 22 percent.

Lansing, F. L.↗

NASA NTRS1984

Intermodulation Product Levels in Flame-sprayed Materials

A preliminary investigation on intermodulation product (IMP) levels of fiberglass-backed flame-sprayed surfaces was completed. The purpose was to demonstrate the use of modified techniques and materials in combustion flame spraying of formed surfaces in reducing intermodulation products. The approach used improved metal wire stock without impurities or with smaller droplet sizes, high-temperature release agents, wire stock with low electrical resistance, variations in spraying distances, and intense buffing processes which amalgamate the material gaps and droplets in an effort to fabricate IMP-free lightweight and low cost subreflectors. Positive material candidates were found with an IMP level around -150 dB, which is comparable to solid aluminum surfaces used as a reference.

Yung, C. S.↗

NASA NTRS1984

Two-Fluid Solar Pond

Plastic covered solar pond uses two immiscible liquids of different densities to collect and store solar energy.

Lansing, F. L.↗

NASA NTRS1983

Thermal Analysis of Antenna Structures. Part 2: Panel Temperature Distribution

This article is the second in a series that analyzes the temperature distribution in microwave antennas. An analytical solution in a series form is obtained for the temperature distribution in a flat plate analogous to an antenna surface panel under arbitrary temperature and boundary conditions. The solution includes the effects of radiation and air convection from the plate. Good agreement is obtained between the numerical and analytical solutions.

Schonfeld, D.↗

NASA NTRS1983

Performance simulation of the JPL solar-powered distiller. Part 1: Quasi-steady-state conditions

A 37.85 cu m (10,000 gallons) per year (nominal) passive solar powered water distillation system was installed and is operational in the Venus Deep Space Station. The system replaced an old, electrically powered water distiller. The distilled water produced with its high electrical resistivity is used to cool the sensitive microwave equipment. A detailed thermal model was developed to simulate the performance of the distiller and study its sensitivity under varying environment and load conditions. The quasi-steady state portion of the model is presented together with the formulas for heat and mass transfer coefficients used. Initial results indicated that a daily water evaporation efficiency of 30% can be achieved. A comparison made between a full day performance simulation and the actual field measurements gave good agreement between theory and experiment, which verified the model.

Yung, C. S.↗

NASA NTRS1983

Efficient computerized model for dynamic analysis of energy conversion systems

In searching for the optimum parameters that minimize the total life cycle cost of an energy conversion system, various combinations of components are examined and the resulting system performance and associated economics are studied. The systems performance and economics simulation computer program (SPECS) was developed to fill this need. The program simulates the fluid flow, thermal, and electrical characteristics of a system of components on a quasi-steady state basis for a variety of energy conversion systems. A unique approach is used in which the set of characteristic equations is solved by the Newton-Raphson technique. This approach eliminates the tedious iterative loops which are found in comparable programs such as TRNSYS or SOLTES-1. Several efficient features were also incorporated such as the centralized control and energy management scheme, and analogous treatment of energy flow in electrical and mechanical components, and the modeling of components of similar fundamental characteristics using generic subroutines. Initial tests indicate that this model can be used effectively with a relatively small number of time steps and low computer cost.

Hughes, R. D.↗

NASA NTRS1982

Heat-Energy Analysis for Solar Receivers

Heat-energy analysis program (HEAP) solves general heat-transfer problems, with some specific features that are "custom made" for analyzing solar receivers. Can be utilized not only to predict receiver performance under varying solar flux, ambient temperature and local heat-transfer rates but also to detect locations of hotspots and metallurgical difficulties and to predict performance sensitivity of neighboring component parameters.

Lansing, F. L.↗

NASA NTRS1982

Thermal analysis of antenna backup structure. Part 1. Methodology development

An analytic method was devised to predict the temperature distribution in typical antenna structural back-up members. The results are in agreement with those obtained by a numerical shooting method. The analytic method shows potential in simplifying the thermal analysis process for complex back-up antenna structures.

Schonfeld, D.↗

NASA NTRS1982

Rates of solar angles for two-axis concentrators

The Sun's position by the azimuth and elevation angles and its rate of change at any time of day are determined to design 2 axis tracking mechanisms of solar concentrators. The Sun's angles and their rates for selected months of the year (March, June, September and December) and for seven selected atitudes (0, + or - 30, + or - 60, + or - 90) covering both the northern and southern hemispheres were studied. The development of the angle and angle rate analytical expressions for any month, hour of day, and latitude provides the solar concentrator designer with a quantitative determination of the limiting Sun's position and angle rates for an accurate automatic tracking mechanism.

Yung, C. S.↗

NASA NTRS1981

An optimization model for energy generation and distribution in a dynamic facility

An analytical model is described using linear programming for the optimum generation and distribution of energy demands among competing energy resources and different economic criteria. The model, which will be used as a general engineering tool in the analysis of the Deep Space Network ground facility, considers several essential decisions for better design and operation. The decisions sought for the particular energy application include: the optimum time to build an assembly of elements, inclusion of a storage medium of some type, and the size or capacity of the elements that will minimize the total life-cycle cost over a given number of years. The model, which is structured in multiple time divisions, employ the decomposition principle for large-size matrices, the branch-and-bound method in mixed-integer programming, and the revised simplex technique for efficient and economic computer use.

Lansing, F. L.↗