Search NASA⌕ Search

Engineering topics

Larson, B C

Publications and source records attributed to Larson, B C.

X-ray Microbeam Diffraction Measurements in Polycrystalline Aluminum and Copper Thin Films

Thermally induced residual strains in polycrystalline Cu and Al films on single crystal Si and glass substrates, respectively, have been examined on a grain-by-grain basis by x-ray microbeam diffraction. The crystallographic orientation and the deviatoric strain tensor, {var_epsilon}{sub ij}*, are determined for each grain by white beam Laue diffraction. From grain orientation mapping and strain tensor measurements, information is obtained about the distributions of strains for similarly oriented grains, about strain variations within single grains, and about grain-to-grain correlations of strains. This type of information may be useful in developing and testing theories for intergrain effects in strain evolution in polycrystals.

36 MATERIALS SCIENCE↗

Long-range internal stresses in monotonically and cyclically deformed metallic single crystals

Selected experimental measurements and theoretical predictions for the magnitude of long-range internal stress in monotonically and cyclically deformed metals are assessed and recently developed, spatially-resolved X-ray micro-beam techniques for direct measurements of long-range internal stress are discussed. The results of previously reported differential-aperture X-ray microscopy spatially-resolved measurements of long-range internal stress in dislocation-cell interiors in monotonically deformed copper are compared with predictions and analyses associated with the composite model of deformation. In addition, the results of volume-integrating X-ray line-profile measurements and spatially-resolved differential-aperture X-ray microscopy measurements of strains in <100> oriented copper single crystals that were cyclically deformed to pre-saturation (without persistent slip bands) are presented.

36 MATERIALS SCIENCE↗

Dislocation density tensor characterization of deformation using 3D x-ray microscopy.

Three-dimensional (3D) X-ray microscopy with submicron resolution has been used to make spatially resolved measurements of lattice curvature and elastic strain over two-dimensional slices in thin deformed Si plates. The techniques and capabilities associated with white-beam 3D X-ray microscopy are discussed, and both theoretical and experimental considerations associated with the measurement of Nye dislocation density tensors in deformed materials are presented. The ability to determine the local geometrically necessary dislocation (GND) density in the form of a dislocation density tensor, with micron spatial resolution over mesoscopic length scales, is demonstrated. Results are shown for the special case of an elastically bent (dislocation free) thin Si plate and for a similar thin Si plate that was bent plastically, above the brittle-to-ductile transition temperature, to introduce dislocations. Within the uncertainties of the measurements, the known result that GND density is zero for elastic bending is obtained, and well-defined GND distributions are observed in the plastically deformed Si plate. The direct and absolute connection between experimental measurements of GND density and multiscale modeling and computer simulations of deformation microstructures is discussed to highlight the importance of submicron-resolution 3D X-ray microscopy for mesoscale characterization of material defects and to achieve a fundamental understanding of deformation in ductile materials.

36 MATERIALS SCIENCE↗