Engineering topics

Le Vine, David

Publications and source records attributed to Le Vine, David.

7 records

NASA NTRS2019

Detection of Residual “Hot Spots” in RFI-Filtered SMAP Data

Radio frequency interference (RFI) is a well-documented problem for passive remote sensing of the Earth at L-band even though the measurements are made in the protected band at 1.413 GHz. Consequently, filtering for RFI is an important early step in the processing of measurements made by the SMAP (Soil Moisture Active/Passive) radiometer. However, the filtered data still include regions with suspiciously high antenna temperatures. One possible cause of these “hot spots” is interference not fully detected during RFI filtering. This paper presents evidence supporting this hypothesis and describes an algorithm to identify these “hot spots” so that they can be removed from the measurements. The impact of removing these “hot spots” is generally small, but evidence is presented that the brightness temperature and soil moisture improve when the hot spots are removed.

Soldo, Yan↗

NASA NTRS2018

Seawater Dielectric Measurements at L-Band with Latest Improvements

Recently, the dielectric constant of seawater at L-band was determined by employing a resonant cavity technique. A dielectric model function has been developed based on the measurement data and the model function has been used for retrieving the ocean salinity. The results indicate that additional accuracy is still needed to resolve the bias correlated with sea surface temperature. This paper reports the improvements that have been made recently for the development of a more accurate seawater dielectric model function. The additional measurements for the open ocean will be addressed in the paper.

L-band↗

NASA NTRS2016

L-band Radiometer Calibration Consistency Assessment for the SMOS, SMAP, and Aquarius Instruments

Three L-band radiometers have been observing the Earth in order to retrieve soil moisture and ocean salinity. They use different instrument configurations and calibration and retrieval algorithms. In any case, the brightness temperature retrieved at the Earth surface should be consistent between all instruments. One reason for inconsistency would be the use of different approaches for the instrument calibration or the use of different models to retrieve surface brightness temperature. We report on the different approaches used for the SMOS, SMAP and Aquarius instruments and their impact on the observations consistency.

Aquarius↗

NASA NTRS2016

Accurate Measurements of the Dielectric Constant of Seawater at L Band

This paper describes measurements of the dielectric constant of seawater at a frequency of 1.413 GHz, the center of the protected band (i.e., passive use only) used in the measurement of sea surface salinity from space. The objective of the measurements is to accurately determine the complex dielectric constant of seawater as a function of salinity and temperature. A resonant cylindrical microwave cavity in transmission mode has been employed to make the measurements. The measurements are made using standard seawater at salinities of 30, 33, 35, and 38 practical salinity units over a range of temperatures from 0 degree C to 35 degree C in 5 degree C intervals. Repeated measurements have been made at each temperature and salinity. Mean values and standard deviations are then computed. The total error budget indicates that the real and imaginary parts of the dielectric constant have a combined standard uncertainty of about 0.3 over the range of salinities and temperatures considered. The measurements are compared with the dielectric constants obtained from the model functions of Klein and Swift and those of Meissner and Wentz. The biggest differences occur at low and high temperatures.

Measurements↗

NASA NTRS2016

SMAP Faraday Rotation

Faraday rotation is a change in the polarization as signal propagates through the ionosphere. At L-band it is necessary to correct for this change and measurements are made on the spacecraft of the rotation angle. These figures show that there is good agreement between the SMAP measurements (blue) and predictions based on models (red).

Faraday Rotation↗

NASA NTRS2012

The Aquarius Salinity Retrieval Algorithm

The first part of this presentation gives an overview over the Aquarius salinity retrieval algorithm. The instrument calibration [2] converts Aquarius radiometer counts into antenna temperatures (TA). The salinity retrieval algorithm converts those TA into brightness temperatures (TB) at a flat ocean surface. As a first step, contributions arising from the intrusion of solar, lunar and galactic radiation are subtracted. The antenna pattern correction (APC) removes the effects of cross-polarization contamination and spillover. The Aquarius radiometer measures the 3rd Stokes parameter in addition to vertical (v) and horizontal (h) polarizations, which allows for an easy removal of ionospheric Faraday rotation. The atmospheric absorption at L-band is almost entirely due to molecular oxygen, which can be calculated based on auxiliary input fields from numerical weather prediction models and then successively removed from the TB. The final step in the TA to TB conversion is the correction for the roughness of the sea surface due to wind, which is addressed in more detail in section 3. The TB of the flat ocean surface can now be matched to a salinity value using a surface emission model that is based on a model for the dielectric constant of sea water [3], [4] and an auxiliary field for the sea surface temperature. In the current processing only v-pol TB are used for this last step.

Meissner, Thomas↗

NASA NTRS2012

Aquarius Radiometer RFI Detection, Mitigation, and Impact Assessment

The Aquarius/SAC-D satellite was launched on 10 June 2011 into a sun-synchronous polar orbit and the Aquarius microwave radiometers [1] became operational on 25 August 2011. Since that time, it has been measuring brightness temperatures at 1.4 GHz with vertical, horizontal and 3rd Stokes polarizations . Beginning well before the launch, there has been the concern that Radio Frequency Interference (RFI) could have an appreciable presence. This concern was initiated by, among other things, its prevalence in both early [2] and more recent [3,4] aircraft field experiments using 1.4 GHz radiometers, as well as by the strong RFI environment encountered during the recent ESA SMOS mission, also at 1.4 GHz [5]. As a result, a number of methods for RFI detection and mitigation have been developed and tested. One in particular, "glitch detection" and "pulse blanking" mitigation has been adapted for use by Aquarius [6, 7]. The early on-orbit performance of the Aquarius RFI detection and mitigation algorithm is presented here, together with an assessment of the global RFI environment at 1.4 GHz which can be derived from the Aquarius results.

Ruf, Christopher↗