Search NASA⌕ Search

Engineering topics

LeBlanc, B. P.

Publications and source records attributed to LeBlanc, B. P..

7 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Real-Time Ethernet Interface for NSTX-U’s Thomson Scattering Diagnostic (2023)

Here, the multipoint Thomson scattering (MPTS) diagnostic system at the National Spherical Torus Experiment Upgrade (NSTX-U) facility is undergoing an upgrade to operate in real-time and interface with the plasma control system (PCS) for NSTX-U. Previous prototyping efforts have shown that spectral analysis and rapid calculations of electron temperature and density are possible on a real-time Linux machine when using up to a 100-Hz laser pulse repetition rate. A remaining challenge was transferring the real-time data to NSTX-U’s PCS, which utilizes the front panel data port (FPDP) protocol. The original proposed method was to convert the real-time data into analog values, but a new solution was developed to keep the output format digital by using an Ethernet controller with a field-programmable gate array (FPGA). This article focuses on a new input module that has been developed to accept incoming user datagram protocol (UDP) packets sent over Ethernet, convert into FPDP format, and integrate into the existing data stream under NSTX-U’s real-time framework.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗
DOE OSTI2024

NSTX-U research advancing the physics of spherical tokamaks

Abstract The objectives of NSTX-U research are to reinforce the advantages of STs while addressing the challenges. To extend confinement physics of low- A , high beta plasmas to lower collisionality levels, understanding of the transport mechanisms that set confinement performance and pedestal profiles is being advanced through gyrokinetic simulations, reduced model development, and comparison to NSTX experiment, as well as improved simulation of RF heating. To develop stable non-inductive scenarios needed for steady-state operation, various performance-limiting modes of instability were studied, including MHD, tearing modes, and energetic particle instabilities. Predictive tools were developed, covering disruptions, runaway electrons, equilibrium reconstruction, and control tools. To develop power and particle handling techniques to optimize plasma exhaust in high performance scenarios, innovative lithium-based solutions are being developed to handle the very high heat flux levels that the increased heating power and compact geometry of NSTX-U will produce, and will be seen in future STs. Predictive capabilities accounting for plasma phenomena, like edge harmonic oscillations, ELMs, and blobs, are being tested and improved. In these ways, NSTX-U researchers are advancing the physics understanding of ST plasmas to maximize the benefit that will be gained from further NSTX-U experiments and to increase confidence in projections to future devices.

74 ATOMIC AND MOLECULAR PHYSICS↗
DOE OSTI2024

Predictive modeling of NSTX discharges with the updated multi-mode anomalous transport module

Abstract The objective of this study is twofold: firstly, to demonstrate the consistency between the anomalous transport results produced by updated Multi-Mode Model (MMM) version 9.0.4 and those obtained through gyrokinetic simulations; and secondly, to showcase MMM’s ability to predict electron and ion temperature profiles in low aspect ratio, high beta NSTX discharges. MMM encompasses a range of transport mechanisms driven by electron and ion temperature gradients, trapped electrons, kinetic ballooning, peeling, microtearing, and drift resistive inertial ballooning modes. These modes within MMM are being verified through corresponding gyrokinetic results. The modes that potentially contribute to ion thermal transport are stable in MMM, aligning with both experimental data and findings from linear CGYRO simulations. The isotope effects on these modes are also studied and higher mass is found to be stabilizing, consistent with the experimental trend. The electron thermal power across the flux surface is computed within MMM and compared to experimental measurements and nonlinear CGYRO simulation results. Specifically, the electron temperature gradient modes (ETGM) within MMM account for 2.0 MW of thermal power, consistent with experimental findings. It is noteworthy that the ETGM model requires approximately 5.0 ms of computation time on a standard desktop, while nonlinear CGYRO simulations necessitate 8.0 h on 8 K cores. MMM proves to be highly computationally efficient, a crucial attribute for various applications, including real-time control, tokamak scenario optimization, and uncertainty quantification of experimental data.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2023

Disruption event characterization and forecasting in tokamaks

Disruption prediction and avoidance is a critical need for next-step tokamaks, such as ITER. Disruption Event Characterization and Forecasting (DECAF) research fully automates analysis of tokamak data to determine chains of events that lead to disruptions and to forecast their evolution allowing sufficient time for mitigation or complete avoidance of the disruption. Disruption event chains related to local rotating or global magnetohydrodynamic (MHD) modes and vertical instability are examined with warnings issued for many off-normal physics events, including density limits, plasma dynamics, confinement transitions, and profile variations. Along with Greenwald density limit evaluation, a local radiative island power balance theory is evaluated and compared to the observation of island growth. Automated decomposition and analysis of rotating tearing modes produce physical event chains leading to disruptions. A total MHD state warning model comprised of 15 separate criteria produces a disruption forecast about 180 ms before a standard locked mode detector warning. Single DECAF event analyses have begun on KSTAR, MAST, and NSTX/-U databases with thousands of shot seconds of device operation using from 0.5 to 1 × 10 6 tested sample times per device. An initial multi-device database comparison illustrates a highly important result that plasma disruptivity does not need to increase as βN increases. Global MHD instabilities, such as resistive wall modes (RWMs), can give the briefest time period of warning before disruption compared to other physics events. In an NSTX database with unstable RWMs, the mode onset, loss of boundary and current control, and disruption event warnings are found in all cases and vertical displacement events are found in 91% of cases. An initial time-dependent reduced physics model of kinetic RWM stabilization created to forecast the disruption chain predicts instability 84% of the time for experimentally unstable cases with a relatively low false positive rate. Instances of the disruption event chain analysis illustrate dynamics including H–L back transitions for rotating MHD and global RWM triggering events. Furthermore, disruption warnings are issued with sufficient time before the disruption (on transport timescales) to potentially allow active profile control for disruption avoidance, active mode control, or mitigation.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2021

Chirping ion cyclotron emission (ICE) on NSTX-U

In this work, we report on the discovery on NSTX-U of a qualitatively new type of non-thermal emission from plasmas in the ion-cyclotron frequency range (ICE). This new type of ICE is weakly damped, γ damp /ω ICE ≈ 0.14%, low order eigenmodes, excited by a fast ion population radially located near an internal transport barrier. The ICE appears as repetitive bursts with durations of ≈1 ms, and the bursts exhibit frequency chirps upwards and/or downwards with maximum δf/f ≈ 1%. We refer to this chirping ICE as ch-ICE. The bursts are longer than the typical ICE bursts of ≈100 μs reported previously for NSTX and NSTX-U, for simplicity, NSTX(-U). The chirping resembles that seen in modeling of weakly unstable fast particle driven instabilities (cf, Berk et al 1997 Phys. Lett. A 234 213). These data also provide some preliminary indications of non-linear coupling between the ch-ICE harmonics. Despite extensive experimental and theoretical studies of ICE, theoretical understanding of ICE remains qualitative at best. The detailed experimental observations of ICE from NSTX(-U) find a wide variation in the ICE characteristics. The new observations of ch-ICE presented here, combined with the characteristics of ICE on NSTX(-U) previously reported (Fredrickson et al 2019 Phys. Plasmas 26 032111), could guide the development of more complete theoretical models of ICE.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2021

Outer midplane neutral density measurements and H-mode fueling studies in NSTX-U

Neutral density profiles are measured on the outboard midplane of the National Spherical Torus Experiment Upgrade (NSTX-U) using a two dimensional camera (ENDD, edge neutral density diagnostic) filtered for deuterium Balmer α (D α ) emission interpreted via simulations using the Monte Carlo neutral transport code DEGAS 2. Deuterium atomic densities n D are calculated by inverting the line-integrated D α brightness and using local measurements of electron density ne and temperature T e to determine atomic rate coefficients. The assumptions used in the derivation of n D from D α emissivity are validated using DEGAS 2 to estimate contributions to emissivity due to electron impact excitation and molecular processes. In this work, experimental measurements and DEGAS 2 simulations are compared over a database of L- and H-mode discharges, showing good agreement in D α emissivity profiles. Residual disagreement between experiment and simulations is suggestive of the possible role of intermittent transport and uncertainties in the molecular data. DEGAS 2 simulations are further used to complement the ENDD diagnostic, extracting neutral (atomic and molecular) densities at locations where the ENDD measurement are not made or where the assumptions used in the ENDD analysis are not valid. Deuterium atomic densities and ionization profiles on the outer midplane are compared for L-mode and H-mode discharges in NSTX-U. One-way coupling of DEGAS 2 to UEDGE multi-fluid simulations constrained by experimental data is used to study edge fueling and neutral penetration in NSTX-U discharges.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗