Engineering topics

Lebrón-Rodríguez, Edgard A.

Publications and source records attributed to Lebrón-Rodríguez, Edgard A..

4 records

DOE OSTI2024

Recommendations for improving rigor and reproducibility in site specific characterization

Heterogeneous catalysis is driven by the interaction of reactant molecules and the catalyst surface. The locus of this interaction as well as the surrounding ensemble of atoms is referred to as the catalyst active site. Active site characterization attempts to distinguish active catalytic sites from inactive surface sites, to elucidate the structural and chemical nature of active sites, and to quantify active site concentration. Numerous techniques have been demonstrated to provide compositional and structural information about the active sites within a catalyst. However, each technique has its own limitations and experimental pitfalls that can lead to data misinterpretation or irreproducible results. Further, this work aims to provide an overview of the types of data that can be collected, to outline common experimental challenges and how to avoid them, and to assemble relevant references for the most used active site characterization techniques. More broadly, we aim to outline best practices for researchers to collect, interpret, and report active site characterization data in a way that provides the most benefit to the broader catalysis community. Increasing the rigor and reproducibility of active site characterization offers a strategy to better link properties with catalytic performance and to enable the community to develop consensus concerning these relationships.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2024

Catalytic conversion of post-consumer recycled high-density polyethylene oil over Zn-impregnated ZSM-5 catalysts

The catalytic conversion of post-consumer recycled high-density polyethylene (PCR-HDPE) pyrolysis oil was investigated using modified ZSM-5 zeolites, prepared under different conditions. The PCR-HDPE oil, obtained through pyrolysis at 500 °C followed by distillation at 165 °C, contained a naphtha fraction hydrocarbons suitable for catalytic upgrading. H/ZSM-5 converts PCR-HDPE naphtha fraction oil primarily into BTX, along with light paraffins and olefins. Introducing mesoporosity led to increased propylene yield at the expense of BTX. Zn impregnation onto H/ZSM-5 and H-meso/ZSM-5 enhanced BTX yield by up to 13 %. However, Zn-meso/ZSM-5 exhibited a lower BTX yield than Zn/ZSM-5 with the same Zn loadings, especially after additional steam treatment at 700 °C. Spent catalysts revealed no noticeable increase in metal contaminants such as calcium and aluminum that were present in the PCR-HDPE. Here, the Zn/ZSM-5 catalyst was stable for more than 50 h time on stream and showed promising potential for upgrading PCR-HDPE naphtha fraction oils.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2022

Catalytic Conversion of Model Compounds of Plastic Pyrolysis Oil over ZSM-5

Mechanistic investigation of the catalytic conversion of model compounds for plastic pyrolysis oil (1-octene, octadiene, octane, and toluene) over ZSM-5 in a fixed-bed reactor was studied. 1-Octene breaks down into smaller olefins, which undergo further cracking, oligomerization, cyclization, and hydrogen transfer to eventually produce benzene, toluene, xylene (BTX), coke, and hydrogen. The effect of contact time on 1-octene conversion was further investigated and compared with thermodynamics analyses to elucidate the reaction network. Under the reaction conditions (500 oC, 1 atm), octadiene undergoes thermal coking, significantly contributing to reactor fouling. The products from octane cracking are similar to the products from 1-octene conversion whereas toluene undergoes disproportionation, dealkylation and coking. The analysis of spent catalyst showed long-chain hydrocarbons created by oligomerization reactions filled the pores and covered the surface of the catalyst. As a result, when mesoporous ZSM-5 is used instead of conventional, product selectivity is maintained for 70 hours in time-on-stream experiments.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2022

Identifying hydroxylated copper dimers in SSZ-13 via UV-vis-NIR spectroscopy

Cu-Exchanged zeolites are promising materials for the selective conversion of methane to methanol. Their activity is attributed to the presence of small Cu-oxo and Cu-hydroxy clusters, but the nature of active centers in various zeolite structures is still under debate. In this contribution, we combine time dependent density functional theory with spin–orbit coupling to predict the optical spectra of various Cu monomers and dimers in SSZ-13. As a result, we furthermore compare theoretical results to experimental measurements and find that the presence of Cu-hydroxy dimers and Cu monomers could potentially explain the experimentally observed UV-vis-NIR spectra.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗