Engineering topics

Leduc, Henry G.

Publications and source records attributed to Leduc, Henry G..

23 records · Page 2

NASA NTRS1992

Onset of dispersion in Nb microstrip transmission lines at submillimeter wave frequencies

We have measured the dispersion in phase velocity of a Nb-SiO(x)-Nb microstrip transmission line resonator over a frequency range from 50 GHz to 800 GHz. A submicron Nb/Al-AlO(x)/Nb Josephson junction was used as a voltage-controlled oscillator to excite the high order modes in the resonator. The same junction is used as a direct detector resulting in a series of step-like structures in the DC current-voltage characteristic at the position of each mode frequency. The transmission line is dispersionless up to about 500 GHz where the phase velocity begins to decrease. This is well below the gap frequency f(sub g) approx. equals 700 GHz. Results agree qualitatively with the expected theoretical behavior near f(sub g). This onset of dispersion and loss in Nb transmission lines will have a significant impact on the design of submillimeter wave RF circuits.

Javadi, H. H. S.↗

NASA NTRS1992

Sub micron area Nb/AlO(x)/Nb tunnel junctions for submillimeter mixer applications

In this paper, we report on a fabrication process developed for submicron area tunnel junctions. We have fabricated Nb/AlO(x)/Nb tunnel junctions with areas down to 0.1 sq micron using these techniques. The devices have shown excellent performance in receiver systems up to 500 GHz and are currently in use in radio astronomy observatories at 115, 230, and 500 GHz.

Leduc, Henry G.↗

NASA NTRS1992

Fabrication and characterization of high current-density, submicron, NbN/MgO/NbN tunnel junctions

At near-millimeter wavelengths, heterodyne receivers based on SIS tunnel junctions are the most sensitive available. However, in order to scale these results to submillimeter wavelengths, certain device properties should be scaled. The tunnel-junction's current density should be increased to reduce the RC product. The device's area should be reduced to efficiently couple power from the antenna to the mixer. Finally, the superconductor used should have a large energy gap to minimize RF losses. Most SIS mixers use Nb or Pb-alloy tunnel junctions; the gap frequency for these materials is approximately 725 GHz. Above the gap frequency, these materials exhibit losses similar to those in a normal metal. The gap frequency in NbN films is as-large-as 1440 GHz. Therefore, we have developed a process to fabricate small area (down to 0.13 sq microns), high current density, NbN/MgO/NbN tunnel junctions.

Stern, J. A.↗

NASA NTRS1991

Edge-Geometry NbN/MgO/NbN Tunnel Junctions

Superconductor/insulator/superconductor (SIS) tunnel junctions fabricated with base and counter electrodes of NbN separated by thin layers of MgO. Useful as submillimeter-wave mixers and fast switches. Use of edge geometry to define small junction makes possible to fabricate junction by process including conventional photolithography.

Hunt, Brian D.↗

NASA NTRS1989

Edge geometry superconducting tunnel junctions utilizing an NbN/MgO/NbN thin film structure

An edge defined geometry is used to produce very small area tunnel junctions in a structure with niobium nitride superconducting electrodes and a magnesium oxide tunnel barrier. The incorporation of an MgO tunnel barrier with two NbN electrodes results in improved current-voltage characteristics, and may lead to better junction noise characteristics. The NbN electrodes are preferably sputter-deposited, with the first NbN electrode deposited on an insulating substrate maintained at about 250 to 500 C for improved quality of the electrode.

Hunt, Brian D.↗