Engineering topics

Lee, Cynthia C.

Publications and source records attributed to Lee, Cynthia C..

8 records

NASA NTRS1993

Measuring Tollmien-Schlichting Instabilities In Laminar Flow

NASA flight experiment conducted to evaluate surface-mounted hot-film sensors designed to detect Tollmien-Schlichting (T-S) instability in boundary layer in flight. New technique has considerable value in applied research aimed at extending regions of natural laminar flow on aircraft. Aids research into mechanisms leading to transition from laminar to turbulent boundary layers. Makes it practical to take measurements in many locations on wing surface for tests in flight. Useful in studying transitions in such flow as those in pipes, ducts, channels, compressors, and diffusers.

Lee, Cynthia C.↗

NASA NTRS1992

Flight evaluation of a stagnation detection hot-film sensor

Results are presented of flight evaluation tests of a stagnation detection hot-film sensor. Experiments were conducted at steady level-flight conditions over a range of altitudes, angles of attack, and air speeds, as well as quasi-steady conditions during level-flight velocity acceleration and deceleration maneuvers. The results demonstrate the ability of a hot-film sensor to provide an accurate, reliable, and relatively nonintrusive measurement of the stagnation region in a flight environment. Stagnation could be identified within 0.1 inches.

Scott, Michael A.↗

NASA NTRS1991

Analysis of flight-measured boundary-layer stability and transition data

The paper concentrates on the computational analysis of both the Tollmien-Schlichting and crossflow-type instabilities using the results of a boundary-layer transition flight experiment on a smooth swept test surface. In addition, the effect of nonadiabatic wall conditions is analyzed using the measured surface temperature distribution on the boundary-layer development and stability growth. The computational methods utilized in analyzing the boundary-layer stability characteristics are discussed: one approach analyzes the Tollmien-Schlichting and crossflow instabilities independently with maximum Tollmien-Schlichting n-factors near nine and maximum crossflow n-factors near six at transition onset for separate cases, while the second approach analyzes the instabilities for maximum growth regardless of the type. As much as a 27-percent increase in n-factor is found at transition onset due to an increased Tollmien-Schlichting instability.

Obara, Clifford J.↗

NASA NTRS1991

Flight experiments measuring boundary-layer disturbances in laminar flow and correlation with stability analysis

Flight test results are reported from an experiment designed to study the detailed growth of disturbances in the laminar boundary layer. A gloved wing section incorporating closely-spaced flush-mounted streamwise-located instrumentation for measuring instability frequencies and amplitude growths as well as pressure distributions was used. The growth of Tollmien-Schlichting (T-S) and crossflow instabilities is predicted by the linear e exp n method and compared to the measured boundary-layer disturbance frequencies. The predictions showed good agreement with the measured data. The results exhibited fair agreement with previous n(T-S) and n(CF) flight correlations for several of the conditions analyzed. It is inferred from the high n(T-S) values for these data that moderately swept wings at compressible speeds can withstand higher combinations of n(T-S) and n(CF) values and still remain laminar than previously thought.

Lee, Cynthia C.↗

NASA NTRS1990

Flight experiments studying the growth of the disturbances in the laminar boundary layer

Results are presented from flight experiments conducted on a gloved aircraft wing surface, incorporating closely-spaced flush-mounted and streamwise-located instrumentation for instability frequencies and pressure distributions, which studied the growth of disturbances in the laminar boundary layer. Mach numbers up to 0.81 were encountered in order to obtain compressible-condition measurements; this exploration therefore encompassed chord Reynolds number conditions of the order of 10-20 million, as well as the introduction of sweep via sideslip maneuvers, and the effects of cloud particles.

Lee, Cynthia C.↗

NASA NTRS1990

Boundary-layer stability analysis of flight-measured transition data

Correlation of in-flight boundary-layer transition experiments with linear boundary-layer stability theory contributes both to the validation of the numerical methods as well as the analysis of the measured transition process. Transition results obtained in a recent flight experiment, in which the extent of laminar flow and the transition process on the wing of a business-jet fitted with an instrumented glove section were determined, are analyzed. The experiment was conducted at freestream Mach numbers from 0.55 to 0.82, chord Reynolds numbers from 10 to 20 x 10 to the 6th, and leading-edge sweep angles 17 deg to 20 deg. The growth of both Tollmien-Schlichting and crossflow instabilities are predicted using the e exp n method for several flight conditions and the calculated n-factors at transition onset are correlated. Comparison of the measured dominant boundary-layer disturbance frequencies and the predicted unstable frequencies shows fair agreement for several of the flight conditions studied.

Obara, Clifford J.↗

NASA NTRS1990

Flight-measured streamwise disturbance instabilities in laminar flow

NASA is presently conducting laminar-flow flight research to explore the limits of practical applications of laminar-flow drag reduction technology. An important aspect of this research involves studies of the dominant instability or instabilities responsible for initiating the transition process from laminar to turbulent flow. Recent subsonic flight experiments using an instrumented wing glove on a Lear 28/29 airplane measured the growth of the two-dimensional, viscous Tollmien-Schlichting (T-S) instability. The gloved wing section incorporated closely-spaced, flush-mounted, streamwise-located instrumentation for measuring the instability frequencies, surface temperatures, and pressure distributions. Flight conditions of the experiment includeed Mach numbers from 0.70 to 0.79 and chord Reynolds numbers from 10 to 20 million. An onboard engineer's station allowed for real-time analysis of the instability frequency data. In addition to a sample of results on the streamwise growth of instabilities, details of the glove and sensor installation and the onboard real-time data analysis system are given.

Lee, Cynthia C.↗

NASA NTRS1990

Developments in flow visualization methods for flight research

With the introduction of modern airplanes utilizing laminar flow, flow visualization has become an important diagnostic tool in determining aerodynamic characteristics such as surface flow direction and boundary-layer state. A refinement of the sublimating chemical technique has been developed to define both the boundary-layer transition location and the transition mode. In response to the need for flow visualization at subsonic and transonic speeds and altitudes above 20,000 feet, the liquid crystal technique has been developed. A third flow visualization technique that has been used is infrared imaging, which offers non-intrusive testing over a wide range of test conditions. A review of these flow visualization methods and recent flight results is presented for a variety of modern aircraft and flight conditions.

Holmes, Bruce J.↗