Search NASA⌕ Search

Engineering topics

Lee, J. H.

Publications and source records attributed to Lee, J. H..

At least 55 records · Page 3
All sourcesNASA NTRSDOE OSTI
NASA NTRS1987

System implications of aperture-shade design for the SIRTF Observatory

The 1-m-aperture Space Infrared Telescope Facility (SIRTF) will operate with a sensitivity limited only by the zodiacal background. This sensitivity requirement places severe restrictions on the amount of stray light which can reach the focal plane from off-axis sources such as the sun or earth limb. In addition, radiation from these sources can degrade the lifetime of the telescope and instrument cryogenic system which is now planned for two years before the first servicing. Since the aperture of the telescope represents a break in the telescope insulation system and is effectively the first element in the optical train, the aperture shade is a key system component. The mass, length, and temperature of the shade should be minimized to reduce system cost while maximizing the telescope lifetime and stray light performance. The independent geometric parameters that characterize an asymmetrical shade for a 600 km, 28 deg orbit were identified, and the system sensitivity to the three most important shade parameters were explored. Despite the higher heat loads compared to previously studied polar orbit missions, the analysis determined that passive radiators of a reasonable size are sufficient to meet the system requirements. An optimized design for the SIRTF mission, based on the sensitivity analysis, is proposed.

Lee, J. H.↗
NASA NTRS1986

Detector arrays for low-background space infrared astronomy

The status of development and characterization tests of integrated infrared detector array technology for astronomy applications is described. The devices under development include intrinsic, extrinsic silicon, and extrinsic germanium detectors, with hybrid silicon multiplexers. Laboratory test results and successful astronomy imagery have established the usefulness of integrated arrays in low-background astronomy applications.

Mccreight, C. R.↗
NASA NTRS1986

A long-pulse amplifier for solar-pumped iodine lasers

The characteristics of a photodissociation iodine-laser amplifier pumped with a solar-simulating radiation were studied. Under long-pulse energy extraction, an energy amplification of about three and an energy storage time of longer than 500 microseconds were observed for a one meter long, 10 mm i.d. amplifier tube. The effects of elevated temperatures resulted in little reduction of the amplifier gain. These results confirm that developing an efficient chain of oscillator-amplifiers for a high-power solar-pumped iodine laser is indeed feasible.

Hwang, I. H.↗
NASA NTRS1986

Space Infrared Telescope Facility (SIRTF) observatory design

The NASA Space IR Telescope Facility (SIRTF) is a 1-m aperture, cryogenically cooled IR observatory scheduled for launch into orbit in the mid-1990s. SIRTF will operate in the 2-700 micron range and yield a 1000-fold increase in sensitivity over NASA's IRAS observatory. A low inclination orbit compatible with Space Shuttle operations will be used. Results from comparisons of a system error budget allocation for the f/24 optical configuration with recent test data indicate that a figured fused silica mirror and a blade flexure mounting system can be cooled to cryogenic temperature while meeting required wavefront tolerances for substrate deformation. An all-He cooling system will be used in the low inclination orbit.

Brooks, W. F.↗
NASA NTRS1986

Cryogenic implications of orbit selection of the Space Infrared Telescope Facility (SIRTF)

An investigation has been conducted to determine how the choice of orbit for NASA's prospective Space IR Telescope Facility (SIRTF), between polar (99-deg) and low inclination (28.5-deg) alternatives, will affect the performance of the all-superfluid He-cooled IR optics employed. While the dewar design met both the service life and 200-micron background-limited performance criteria in the case of the polar orbit mission, the alternative orbit allowed the background-limited criteria to be met only 50 percent of the time. It is accordingly recommended that the 200-micron background-limited observations be made only for a limited portion of the mission, while meeting the 100-micron limit at all times.

Lee, J. H.↗
NASA NTRS1986

Detector arrays for low-background space infrared astronomy

The status of development and characterization tests of integrated infrared detector array technology for astronomy applications is described. The devices under development include intrinsic, extrinsic silicon, and extrinsic germanium detectors, with hybrid silicon multiplexers. Laboratary test results and successful astronomy imagery have established the usefulness of integrated arrays in low-background astronomy applications.

Mccreight, C. R.↗
NASA NTRS1986

Solar-pumped photodissociation iodine laser

The scientific feasibility of a solar-pumped iodine photodissociation laser for space applications is under investigation. Recently, a 2-W CW output for more than one hour was achieved using n-C3F7I vapor as the laser material and a vortex-stabilized argon arc as the light source.

Lee, J. H.↗
NASA NTRS1985

An experimental investigation of pulsed multichannel discharge across solid insulators

An experimental study of pulsed surface flashover across a solid insulator in a vacuum is reported, with application of fast impulse voltages of a few tens of ns rise time and a few microsec tail time. Following the flashover voltage experiments, no visible degradation of the surface was found for the BaTiO3 sample, whereas for the TiO2 sample a distinct track mark could be seen where the flashover occurred. Three schemes for obtaining multichannel discharges were studied for plexiglass specimens, and results showed the number of shots to decrease as the number of channels increased.

Lakdawala, V. K.↗
NASA NTRS1985

Threshold kinetic processes for t-C4F9I

To determine the relative threshold of the lasant gas t-C4F9I in comparison to n-C3F7I, the pump energy to reach threshold for photodissociation iodine lasing is measured in a common aparatus. The comparison is made for the threshold energies in the iodide pressure range up to 50 Torr when 64-J electric input into a flashlamp is used for pumping. It is shown from the results that qualitative differences between the thresholds of the two gases result from the degree to which steady state is achieved by the time threshold is reached. The estimated recombination rate for t-C4F9I is found to be much larger than the value given by Ershov et al (1978).

Lee, J. H.↗
NASA NTRS1985

Temperature control of silica mirrors for cryogenically-cooled telescopes in space

The SIRTF (Space Infrared Telescope Facility) optical subsystem, including the primary mirror, has been modeled using lumped-parameter techniques and a thermal and cryogenic transient analysis program developed previously. Since silica mirrors have been shown to have significantly less distortion due to cryogenic cooldown, a silica primary mirror of approximately 1 m diameter is being considered. Thermal responses to variations in aperture heat load and heat sink temperature have been explored. Calculations have been made of system noise components from primary mirror spatial and temporal temperature variations. Background-limited infrared observations can be made at wavelengths out to 200 micrometers. Mirror thermal performance with and without copper wires for cooling is also considered.

Melugin, R. K.↗
NASA NTRS1984

Cryogenic and thermal design for the Space Infrared Telescope Facility (SIRTF)

The 1-meter class cryogenically cooled Space Infrared Telescope Facility (SIRTF) planned by NASA, is scheduled for a 1992 launch. SIRTF would be deployed from the Shuttle, and placed into a sun synchronous polar orbit of 700 km. The facility has been defined for a mission with a minimum initial lifetime of one year in orbit with mission extension that could be made possible through in-orbit servicing of the superfluid helium cryogenic system, and use of a thermal control system. The superfluid dewar would use an orbital disconnect system for the tank supports, and vapor cooling of the barrel baffle. The transient analysis of the design shows that the superfluid helium tank with no active feedback comes within temperature requirements for the nominal orbital aperture heat load, quiescent instrument, and chopper conditions.

Lee, J. H.↗
NASA NTRS1984

Threshold kinetics of a solar-simulator-pumped iodine laser

A model of the chemical kinetics of the n-C3F7I solar-simulator-pumped iodine laser is utilized to study the major kinetic processes associated with the threshold behavior of this experimental system. Excited-state diffusion to the cell wall is the dominant limiting factor below 5 torr. Excited-state diffusion to the cell wall is the dominant limiting factor below 5 torr. Excited-state recombination with the alkyl radical and quenching by the parent gas control threshold at higher pressures. Treatment of the hyperfine splitting and uncertainty in the pressure broadening are important factors in fixing the threshold level. In spite of scatter in the experimental data caused by instabilities in the simulator high-pressure high-pressure arc, reasonable agreement is achieved between the model and experiment. Model parameters arrived at are within the uncertainty range of values found in the literature.

Wilson, J. W.↗
NASA NTRS1984

Solar pumped laser

A solar pumped laser is described in which the lasant is a gas that will photodissociate and lase when subjected to sunrays. Sunrays are collected and directed onto the gas lasant to cause it to lase. Applications to laser propulsion and laser power transmission are discussed.

Lee, J. H.↗
NASA NTRS1984

Integrated detector array technology for infrared astronomy

The status of laboratory and telescope tests of integrated infrared detector array technology for astronomical applications is described. The devices tested represent a number of extrinsic and intrinsic detector materials and various multiplexer designs. Infrared arrays have now been used in successful astronomical applications. These have shown that device sensitivities can be comparable to those of discrete detector systems and excellent astronomical imagery can be produced.

Mccreight, c. R.↗
NASA NTRS1983

Low background IR detector and detector array evaluations

A technology program has been underway at Ames since 1978 to develop and evaluate detectors and integrated detector arrays for low-background astronomical applications. The approach is to evaluate existing (less than 24 micron) array technology under low-background conditions, with the aim of adapting and optimizing existing devices. For longer wavelengths, where the technology is much less mature, development is sponsored and devices are evaluated, in both discrete and array formats, for eventual applications. The status of this program has been reported previously. We rely on industrial and university sources for the detectors. Typically, after a brief functionality check in the supplier's laboratory, we work with the device at Ames to characterize its low-background performance. In the case of promising arrays or detectors, we conduct ground-based telescope testing to face the problems associated with real applications. A list of devices tested at Ames is given. In the array category, accumulation-mode charge-injection-devices (AMCIDs) appear repeatedly; this reflects our recent experience with the 2 x 64 and 16 x 16 arrays. Results from the 1 x 16 CID and InSb CCD have been reported. The status of our tests of the discrete Ge:x detectors from Lawrence Berkeley Laboratory are described below. Tests of a 1 x 2 switched sample photoconductor array are just beginning. A 32-channel CMOS multiplexer has been tested at 10 K. Low-temperature silicon MOSFETs and germanium JFETs have also been tested, primarily at Ball Aerospace. This paper describes results to date on three elements of this program: AMCID array, discrete Ge:Ga detectors, and Ge JFET preamplifiers.

Goebel, J. H.↗
NASA NTRS1983

Ambient and cryogenic temperature testing of a 32-channel CMOS multiplexer

A 32 channel CMOS multiplexer was tested at room temperature and at liquid helium temperature (4.9 K). Voltage gain of the FET input stage, leakage current, electrical crosstalk, and noise as a function of clock frequency were measured. The voltage gain measured at 4.9 K was slightly higher than that measured at 300 K and was independent of clock frequency at both operating temperatures. The off channel leakage current was 0.23 pA/channel at 4.9 K. Electrical crosstalk between adjacent channels (one on, one off) was quite low. The spot noise at 10 Hz, of the CMOS multiplexer operating in the static mode did not vary significantly with operating temperature. In the dynamic mode (3.2 kHz clock) at room temperature, the spot noise at 10 Hz was substantially higher than that measured in the static mode.

Lee, J. H.↗