Search NASA⌕ Search

Engineering topics

Lee, Y Y

Publications and source records attributed to Lee, Y Y.

Column density and temperature effects on narrow resonance structures in atomic photoionization and photoabsorption

We present a joint experimental and theoretical investigation to resolve the discrepancy in the ratio of relative peak cross sections for narrow atomic resonances among various experimental spectra and also between theory and experiment. Our study includes an effort to measure both the absorption and ionization spectra in a single experimental setup. We also present a careful analysis of the effect on the resonance structure due to the Doppler broadening at finite temperature when the Doppler width is greater than the natural linewidth of the resonance. In addition, we demonstrate that the column density strongly affects not only the absorption structure profile of a narrow atomic resonance but also the ionization spectra measured in an ionization chamber. From the good agreement reported in this article between the observed and the theoretically simulated spectra for the pressure-dependent peak cross sections and the effective asymmetry parameter for the lowest resonance of the He (1,0){sub 2}{sup -} series, we are able to characterize the monochromator (i.e., slit) function of a given light source, including its estimated energy resolution.

74 ATOMIC AND MOLECULAR PHYSICS↗

Nonlinear Analysis of Forced Responses of an Axially Moving Beam by Incremental Harmonic Balance Method

This paper analyzes nonlinear vibration of an axially moving beam subject to periodic lateral forces by Incremental Harmonic Balance (IHB) method. Attention is paid to the fundamental resonance as the force frequency is close to the first frequencies omega{sub 1} of the system. Galerkin method is used to discretize the governing equations and the IHB method is used to illustrate the nonlinear dynamic behavior of the axially moving beam. The stable and unstable periodic solutions for given parameters are determined by the multivariable Floquet theory. Hsu's method is applied for computing the transition matrix at the end of one period. The effects of internal resonance on the beam responses are discussed. The periodic solutions obtained from the IHB method are in good agreement with the results obtained from numerical integration.

97 MATHEMATICS AND COMPUTING↗

Analysis of Mode III Elastodynamic Cracked Plane using the Fractal Two-Level Finite Element Method

In this study, the fractal two-level finite element method, which has mainly been used for static cracked plane problems, is applied to the cracked plane problem. Using the transformation process in the proposed method, the infinite dimension of the finite element matrices that are assembled for a singular region is made finite in terms of the dynamics stress intensity factors directly, and thus the computational time can be reduced significantly. The Newmark time integration scheme is then used to obtain the dynamic stress intensity factors. The results from the proposed method are in reasonable agreement with those of classical methods. The main drawback of the time integration scheme is that numerical oscillations are induced in some cases.

97 MATHEMATICS AND COMPUTING↗

Enhanced polarization and mechanisms in optically pumped hyperpolarized {sup 3}He in the presence of {sup 4}He

This work reports an enhanced polarization and mechanisms in optically pumped (OP) hyperpolarized {sup 3}He in the presence of {sup 4}He. The cells contain Rb metal, 60-torr N{sub 2}, and different pressures of {sup 3}He and {sup 4}He. In the absence of {sup 4}He, the polarization of {sup 3}He increases monotonically from 4.5% to 8% when the pressure of {sup 3}He is increased from 300 to 1500 torr. In the presence of 1850-torr {sup 4}He gas, the polarization of {sup 3}He is enhanced from 7% to 30% for a cell containing 600-torr {sup 3}He and 60-torr N{sub 2}. The wall relaxation factors X for OP cells with and without buffering {sup 4}He gas were derived. It was found that the {sup 4}He gas confines the {sup 3}He atoms to a diffusion-limited region which effectively reduces the wall relaxation factor X. Mechanisms contributed to relaxation are addressed and discussed.

74 ATOMIC AND MOLECULAR PHYSICS↗

Improved limit on the muon electric dipole moment

Three independent searches for an electric dipole moment (EDM) of the positive and negative muons have been performed, using spin precession data from the muon g-2 storage ring at Brookhaven National Laboratory. Details on the experimental apparatus and the three analyses are presented. Since the individual results on the positive and negative muons, as well as the combined result, d{sub {mu}}=(0.0{+-}0.9)x10{sup -19}e cm, are all consistent with zero, we set a new muon EDM limit, |d{sub {mu}}|<1.8x10{sup -19}e cm (95% C.L.). This represents a factor of 5 improvement over the previous best limit on the muon EDM.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Comparative Sugar Recovery and Fermentation Data Following Pretreatment of Poplar Wood by Leading Technologies

Through a Biomass Refining Consortium for Applied Fundamentals and Innovation among Auburn University, Dartmouth College, Michigan State University, the National Renewable Energy Laboratory, Purdue University, Texas A&M University, the University of British Columbia, and the University of California at Riverside, leading pretreatment technologies based on ammonia fiber expansion, aqueous ammonia recycle, dilute sulfuric acid, lime, neutral pH, and sulfur dioxide were applied to a single source of poplar wood, and the remaining solids from each technology were hydrolyzed to sugars using the same enzymes. Identical analytical methods and a consistent material balance methodology were employed to develop comparative performance data for each combination of pretreatment and enzymes. Overall, compared to data with corn stover employed previously, the results showed that poplar was more recalcitrant to conversion to sugars and that sugar yields from the combined operations of pretreatment and enzymatic hydrolysis varied more among pretreatments. However, application of more severe pretreatment conditions gave good yields from sulfur dioxide and lime, and a recombinant yeast strain fermented the mixed stream of glucose and xylose sugars released by enzymatic hydrolysis of water washed solids from all pretreatments to ethanol with similarly high yields. An Agricultural and Industrial Advisory Board followed progress and helped steer the research to meet scientific and commercial needs.

09 BIOMASS FUELS↗

Summary of Findings from the Biomass Refining Consortium for Applied Fundamentals and Innovation (CAFI): Corn Stover Pretreatment

The Biomass Refining Consortium for Applied Fundamentals and Innovation, with members from Auburn University, Dartmouth College, Michigan State University, the National Renewable Energy Laboratory, Purdue University, Texas A&M University, the University of British Columbia, and the University of California at Riverside, has developed comparative data on the conversion of corn stover to sugars by several leading pretreatment technologies. These technologies include ammonia fiber expansion pretreatment, ammonia recycle percolation pretreatment, dilute sulfuric acid pretreatment, flowthrough pretreatment (hot water or dilute acid), lime pretreatment, controlled pH hot water pretreatment, and sulfur dioxide steam explosion pretreatment. Over the course of two separate USDA- and DOE-funded projects, these pretreatment technologies were applied to two different corn stover batches, followed by enzymatic hydrolysis of the remaining solids from each pretreatment technology using identical enzyme preparations, enzyme loadings, and enzymatic hydrolysis assays. Identical analytical methods and a consistent material balance methodology were employed to develop comparative sugar yield data for each pretreatment and subsequent enzymatic hydrolysis. Although there were differences in the profiles of sugar release, with the more acidic pretreatments releasing more xylose directly in the pretreatment step than the alkaline pretreatments, the overall glucose and xylose yields (monomers + oligomers) from combined pretreatment and enzymatic hydrolysis process steps were very similar for all of these leading pretreatment technologies. Some of the water-only and alkaline pretreatment technologies resulted in significant amounts of residual xylose oligomers still remaining after enzymatic hydrolysis that may require specialized enzyme preparations to fully convert xylose oligomers to monomers.

09 BIOMASS FUELS↗

Electron Cloud Mitigation in the Spallation Neutron Source Ring

The Spallation Neutron Source (SNS) accumulator ring is designed to accumulate, via H{sup -} injection, protons of 2 MW beam power at 1 GeV kinetic energy at a repetition rate of 60 Hz [1]. At such beam intensity, electron-cloud is expected to be one of the intensity-limiting mechanisms that complicate ring operations. This paper summarizes mitigation strategy adopted in the design, both in suppressing electron-cloud formation and in enhancing Landau damping, including tapered magnetic field and monitoring system for the collection of stripped electrons at injection, TiN coated beam chamber for suppression of the secondary yield, clearing electrodes dedicated for the injection region and parasitic on BPMs around the ring, solenoid windings in the collimation region, and planning of vacuum systems for beam scrubbing upon operation.

43 PARTICLE ACCELERATORS↗