Search NASA⌕ Search

Engineering topics

Lee, Y.

Publications and source records attributed to Lee, Y..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2019

Seasonal, Solar Zenith Angle, and Solar Flux Variations of O+ in the Topside Ionosphere of Mars

Using observations from Mars Atmosphere and Volatile EvolutioN's Neutral Gas and Ion Mass Spectrometer, we characterize the seasonal, solar zenith angle (SZA), and solar flux dependent variations of the O+ peak and the O+/O+2 ratio in the topside ionosphere of Mars.We find that the O+ peak is between 220 and 300 km and forms at a roughly constant neutral atmospheric pressure level of 10(−8.7±0.4) Pa. The O+ peak altitude also decreases with increasing SZA near the terminator and varies sinusoidally with an amplitude of 26 km over a period of one Mars year in response to the changing solar insolation. The O+ peak altitude reaches a maximum near Northern Winter solstice and Mars perihelion. The O+ peak density on the dayside has an average value of (1.1 ± 0.5) × 103 cm−3, has no dependence on SZA for SZAs up to ∼90◦, and is mainly controlled by the thermospheric O/CO2 ratio as predicted by photochemical theory. Above the O+ peak, the O+/O+2 ratio in the dayside ionosphere approaches a constant value of 1.1 ± 0.6, decreases with increasing SZA, and is highly variable on timescales of days or less.We discuss why the O+ peak is different than the main (M2) peak at Mars and why it is similar to the F2 peak at Earth.

Girazian, Z.↗
NASA NTRS2017

OGLE-2016-BLG-1469L: Microlensing Binary Composed of Brown Dwarfs

We report the discovery of a binary composed of two brown dwarfs, based on the analysis of the micro lensing event OGLE-2016-BLG-1469. Thanks to the detection of both finite-source and micro lens-parallax effects, we are able to measure both the masses M(sub 1) ~ 0.05 Solar Mass and M(sub 2) ~ 0.01 Solar Mass, and the distance D(sub L) ~ 4.5 kpc, as well as the projected separation a(sub perpendicular) ~ 0.33 au. This is the third brown-dwarf binary detected using the micro lensing method, demonstrating the usefulness of micro lensing in detecting field brown-dwarf binaries with separations of less than 1 au.

OGLE-2016-BLG-1469↗
NASA NTRS1994

Heat-transfer measurements and computations of swept-shock-wave boundary-layer interactions

An experimental and computational research program providing new knowledge of the heat transfer in swept-shock-wave/boundary-layer interactions is described. An equilibrium turbulent boundary layer on a flat plate is subjected to impingement by a swept planar shock wave generated by a sharp fin. Five different interactions with fin angles ranging from 10 to 20 deg at freestream Mach numbers of 3 and 4 produce a variety of interaction strengths ranging from weak to very strong. A foil heater generates a uniform heat flux over the flat plate surface, and miniature thin-film-resistance sensors are used to measure the local surface temperature. The heat convection equation is then solved for the heat transfer distribution within an interaction, yielding an uncertainty of about +/- 10%. These data are compared with numerical Navier-Stokes solutions that employ a k-epsilon turbulence model. A simple peak heat transfer correlation for fin interactions is suggested.

Lee, Y.↗
NASA NTRS1992

Swept shock/boundary layer interaction experiments in support of CFD code validation

Research on the topic of shock wave/turbulent boundary-layer interaction was carried out during the past three years at the Penn State Gas Dynamics Laboratory. This report describes the experimental research program which provides basic knowledge and establishes new data on heat transfer in swept shock wave/boundary-layer interactions. An equilibrium turbulent boundary-layer on a flat plate is subjected to impingement by swept planar shock waves generated by a sharp fin. Five different interactions with fin angle ranging from 10 deg to 20 deg at freestream Mach numbers of 3.0 and 4.0 produce a variety of interaction strengths from weak to very strong. A foil heater generates a uniform heat flux over the flat plate surface, and miniature thin-film-resistance sensors mounted on it are used to measure the local surface temperature. The heat convection equation is then solved for the heat transfer distribution within an interaction, yielding a total uncertainty of about +/- 10 percent. These experimental data are compared with the results of numerical Navier-Stokes solutions which employ a k-epsilon turbulence model. Finally, a simplified form of the peak heat transfer correlation for fin interactions is suggested.

Settles, G. S.↗
NASA NTRS1992

Heat transfer measurements and CFD comparison of swept shock wave/boundary-layer interactions

An experimental research program providing basic knowledge and establishing new data on the heat transfer in swept shock wave/boundary-layer interactions is described. An equilibrium turbulent boundary-layer on a flat plate is subjected to impingement by swept planar shock waves generated by a sharp fin. Five different interactions with fin angles ranging from 10 to 20 deg at freestream Mach numbers of 3.0 and 4.0 produce a variety of interaction strengths from weak to very strong. A foil heater generates a uniform heat flux over the flat plate surface and miniature thin-film-resistance sensors mounted on it are used to measure the local surface temperature. The heat convection equation is then solved for the heat transfer distribution within an interaction, yielding a total uncertainty of about +/- 10 percent. These experimental data are compared with the results of numerical Navier-Stokes solutions which employ a kappa-epsilon turbulence model. Finally, a simplified form of the peak heat transfer correlation for fin interactions is suggested.

Lee, Y.↗
NASA NTRS1991

Laser interferometer/Preston tube skin-friction comparison in shock/boundary-layer interaction

An evaluation is conducted of the accuracy of the 'Preston tube' surface pitot-pressure skin friction measurement method relative to the already proven laser interferometer skin-friction meter in a swept shock wave/turbulent boundary-layer interaction. The Preston tube was used to estimate the total shear-stress distribution in a fin-generated swept shock-wave/turbulent boundary-layer interaction. The Keener-Hopkins calibration method using the isentropic relation to calculate the Preston-tube Mach number produces the best results.

Kim, K.-S.↗
NASA NTRS1990

Swept shock/boundary layer interaction experiments in support of CFD code validation

Research on the topic of shock wave/turbulent boundary layer interaction was carried out. Skin friction and surface pressure measurements in fin-induced, swept interactions were conducted, and heat transfer measurements in the same flows are planned. The skin friction data for a strong interaction case (Mach 4, fin-angles equal 16 and 20 degrees) were obtained, and their comparison with computational results was published. Surface pressure data for weak-to-strong fin interactions were also obtained.

Settles, G. S.↗
NASA NTRS1990

Laser skin friction measurements and CFD comparison of weak-to-strong swept shock/boundary-layer interactions

A joint experimental and computational study of skin friction in weak-to-strong swept shock wave/turbulent boundary-layer interactions has been carried out. A planar shock wave is generated by a sharp fin at angles of attack alpha = 10 deg and 16 deg at M(infinity) = 3 and 16 and 20 deg at M(infinity) = 4. Measurements are made using the Laser Interferometer Skin Friction meter, which optically detects the rate of thinning of an oil film applied to the test surface. The results show a systematic rise in the peak c(f) at the rear part of the interaction, where the separated flow atttaches. For the stronget case studied, this peak is an order of magnitude higher than the incoming freestream c(f)level.

Kim, K.-S.↗
NASA NTRS1985

Nearfield acoustic holography. I - Theory of generalized holography and the development of NAH

Because its underlying principles are so fundamental, holography has been studied and applied in many areas of science. Recently, a technique has been developed which takes the maximum advantage of the fundamental principles and extracts much more information from a hologram than is customarily associated with such a measurement. In this paper the fundamental principles of holography are reviewed, and a sound radiation measurement system, called nearfield acoustic holography (NAH), which fully exploits the fundamental principles, is described.

Maynard, J. D.↗
NASA NTRS1984

Characterizing the scientific potential of satellite sensors

Algorithms and software were developed for the correction of coherent noise, scan correlated shift, and the bright target saturation effect in Thematic Mapper imagery. In addition, a package of LANDSAT Assessment System programs was developed to demonstrate the results from TM radiometric characterization and calibration work.

Lee, Y.↗
NASA NTRS1984

LANDSAT instruments characterization

Twelve subscenes were selected from LANDSAT 5, scene 50129-17075 over White Sands, NM. Data set WHITE covers the entire White Sands desert area. Black and white films and hard copy prints of each band in this area were produced. A new command file was written for the interactive digital image manipulation system (IDIMS) to generate pseudocolor pixel prints of LANDSAT Thematic Mapper bands for data from B and A tapes. The program PCMAIN.FOR of principal component analysis and a supplemental program HEDIT.FOR for generating sampled data sets were developed. The procedures for performing component analysis on a subscene by using these programs are described. Modifications to various subroutines are listed. Bright target saturation internal calibration lamp state dependence was examined using calibration data of night scene 50052-02182, WRS 111/112 over Harrisburg, PA.

Lee, Y.↗
NASA NTRS1984

LANDSAT instruments characterization

Several studies were performed using LANDSAT-4 and -5 simultaneous overpath data 40608-15472 and 50014-15465 over Pensacola, FL. The overlap region of these two scenes was determined visually on the IAT and then sampled into 32 x 32 segments. The mean and standard deviation (SD) for each segment were calculated. In general, the plots of the means of LANDSAT-4 versus LANDSAT-5 lie on the diagonal line. Some of the data lie out of the diagonal line, which indicates a possible bidirectional observation effect occurs. In addition to editing the five FCL files on CALDUMP tapes into seven 1000 minor frame (MF). CAL files, program LEE.FOR was modified to use information from start of shutter obscuration extracted from program START.FOR to create seven 200 MF.CAL files that can be run through the current TRAPP program for TM sensor characterization. The location of start of shutter obscuration was determined for both LANDSAT-4 and -5.

Lee, Y.↗
NASA NTRS1984

LANDSAT instruments characterization

The present CALDUMP tape consists of five calibration files and one reduced calibration file. The calibration files, each with data of 200 pixels, cover an entire calibration region starting from the 6251 minor frame (mf). Program LEE.FOR was developed to edit these five files into seven .CAL files in the TAE mode. Program PCAL.FOR reads the .CAL files and plots the 1000 pixels of any scan line in linear or log scale. The typical spectra of the calibration region of forward and reverse scans are shown. The positions of the start and the end of shutter obscuration and the calibration pulse are shifted increasingly or decreasingly from Channel 1 to Channel 16, due to the timing of data acquisition. To produce TRAPP usable input files are, the following procedures need to be taken: (1) determine the start of shutter obscuration position; (2) determine the calibration pulse and background region relative to the start of shutter obscuration; and (3) determine the end of shutter obscuration position.

Lee, Y.↗
NASA NTRS1984

LANDSAT instruments characterization

Work performed for the LANDSAT instrument characterization task in the areas of absolute radiometry, coherent noise analysis, and between-date smoothing is reported. Absolute radiometric calibration for LANDSAT-5 TM under ambient conditions was performed. The TM Radiometric Algorithms and Performance Program (TRAPP) was modified to create optional midscan data files and to match the TM Image Processing System (TIPS) algorithm for pulse determination. Several data reduction programs were developed, including a linear regression and its plotted result. A fast Fourier transformation study was conducted on the resequenced TM data. Subscenes of homogeneous water within scenes over Pensacola, Florida were used for testing the FFT on the resequenced data. Finally, a gain and pulse height stability study of LANDSAT 5 TM spectral bands was performed.

Lee, Y.↗
NASA NTRS1984

Threshold kinetics of a solar-simulator-pumped iodine laser

A model of the chemical kinetics of the n-C3F7I solar-simulator-pumped iodine laser is utilized to study the major kinetic processes associated with the threshold behavior of this experimental system. Excited-state diffusion to the cell wall is the dominant limiting factor below 5 torr. Excited-state diffusion to the cell wall is the dominant limiting factor below 5 torr. Excited-state recombination with the alkyl radical and quenching by the parent gas control threshold at higher pressures. Treatment of the hyperfine splitting and uncertainty in the pressure broadening are important factors in fixing the threshold level. In spite of scatter in the experimental data caused by instabilities in the simulator high-pressure high-pressure arc, reasonable agreement is achieved between the model and experiment. Model parameters arrived at are within the uncertainty range of values found in the literature.

Wilson, J. W.↗