Engineering topics

Leininger, G. G.

Publications and source records attributed to Leininger, G. G..

At least 19 records

NASA NTRS1981

Application of the MNA design method to a nonlinear turbofan engine

Using nonlinear digital simulation as a representative model of the dynamic operation of the QCSEE turbofan engine, a feedback control system is designed by variable frequency design techniques. Transfer functions are generated for each of five power level settings covering the range of operation from approach power to full throttle (62.5% to 100% full power). These transfer functions are then used by an interactive control system design synthesis program to provide a closed loop feedback control using the multivariable Nyquist array and extensions to multivariable Bode diagrams and Nichols charts.

Leininger, G. G.↗

NASA NTRS1981

Model degradation effects on sensor failure detection

This paper discusses the effects of imperfect modeling on the detection and isolation of sensor failures. For systems with non-zero set points, deterministic inputs or non-zero noise biases, the model mismatch appears as a bias on the stochastic innovation process. This bias, if left unaccounted for, would be sufficient to declare a false alarm failure in one or more sensors. A practical design procedure based upon the Generalized Likelihood Ratio (GLR) form uses a finite data window sequential t-test to detect and isolate model mismatch effects and soft sensor failures. Application to an eighth order model of the QCSEE turbofan engine is discussed.

Leininger, G. G.↗

NASA NTRS1980

Multivarable nyquist array method with application to turbofan engine control

Extensions to the multivariable Nyquist array (MNA) method are used to design a feedback control system for the quiet clean shorthaul experimental engine. The results of this design are compared with those obtained from the deployment of an alternate control system design on a full scale nonlinear, real time digital simulation. The results clearly demonstrate the utility of the MNA synthesis procedures for highly nonlinear sophisticated design applications.

Leininger, G. G.↗

NASA NTRS1980

Sensor/actuator failure detection for turbofan engines

A procedure for sensor/actuator failure detection using a generalized likelihood ratio (GLR) test is described. The GLR concept can provide a reliable evaluation of failure occurence when associated with a feedback control design which does not require sensor outputs to provide data estimates. A GLR detector was developed and tested.

Behbehani, K.↗

NASA NTRS1980

Sensor/actuator failure detection and isolation for airbreathing propulsion systems

In this paper, the Generalized Likelihood Ratio (GLR) test is used to detect and isolate sensor and/or actuator failures when a digital computer simulation model of the physical system is available. The input to the GLR detector is an innovation sequence formed by subtracting the model outputs from the sensed outputs. Application of the GLR detector to the General Electric QCSEE turbofan engine demonstrates the utility of the proposed procedure.

Leininger, G. G.↗

NASA NTRS1979

New dominance characteristics for the multivariable Nyquist array method

Three new dominance characteristics are introduced to the multivariable Nyquist array methods. The first characteristic utilizes a conformal mapping procedure to establish a new set of bands in the 'image' plane to assist in feedback gain selection and stability assessment. The second characteristic uses the 'image' band concept to provide a theoretical foundation for finite frequency dominance considerations, thus removing the restrictive requirement of dominance for all s on the Nyquist D contour. The third characteristic provides for the sharing of system dominance among the feedback control loops. The dominance sharing concept may be used to establish dominance and/or to improve the dominance condition in prespecified feedback loops.

Leininger, G. G.↗

NASA NTRS1979

A new traffic control design method for large networks with signalized intersections

The paper presents a traffic control design technique for application to large traffic networks with signalized intersections. It is shown that the design method adopts a macroscopic viewpoint to establish a new traffic modelling procedure in which vehicle platoons are subdivided into main stream queues and turning queues. Optimization of the signal splits minimizes queue lengths in the steady state condition and improves traffic flow conditions, from the viewpoint of the traveling public. Finally, an application of the design method to a traffic network with thirty-three signalized intersections is used to demonstrate the effectiveness of the proposed technique.

Leininger, G. G.↗

NASA NTRS1978

A sensitivity analysis for the F100 turbofan engine using the multivariable Nyquist array

In the feedback control design of multivariable systems, closed loop performance evaluations must include the dynamic behavior of variables unavailable to the feedback controller. For the multivariable Nyquist array method, a set of sensitivity functions are proposed to simplify the adjustment of compensator parameters when the dynamic response of the unmeasurable output variables is unacceptable. A sensitivity study to improve thrust and turbine temperature responses for the Pratt-Whitney F100 turbofan engine demonstrates the utility of the proposed method.

Leininger, G. G.↗

NASA NTRS1977

Diagonal dominance for the multivariable Nyquist array using function minimization

A new technique for the design of multivariable control systems using the multivariable Nyquist array method was developed. A conjugate direction function minimization algorithm is utilized to achieve a diagonal dominant condition over the extended frequency range of the control system. The minimization is performed on the ratio of the moduli of the off-diagonal terms to the moduli of the diagonal terms of either the inverse or direct open loop transfer function matrix. Several new feedback design concepts were also developed, including: (1) dominance control parameters for each control loop; (2) compensator normalization to evaluate open loop conditions for alternative design configurations; and (3) an interaction index to determine the degree and type of system interaction when all feedback loops are closed simultaneously. This new design capability was implemented on an IBM 360/75 in a batch mode but can be easily adapted to an interactive computer facility. The method was applied to the Pratt and Whitney F100 turbofan engine.

Leininger, G. G.↗

NASA NTRS1977

Diagonal dominance using function minimization algorithms

A new approach to the design of multivariable control systems using the inverse Nyquist array method is proposed. The technique utilizes a conjugate direction function minimization algorithm to achieve dominance over a specified frequency range by minimizing the ratio of the moduli of the off-diagonal terms to the moduli of the diagonal term of the inverse open loop transfer function matrix. The technique is easily implemented in either a batch or interactive computer mode and will yield diagonalization when previously suggested methods fail. The proposed method has been successfully applied to design a control system for a sixteenth order state model of the F-100 turbofan engine with three inputs.

Leininger, G. G.↗

NASA NTRS1975

Analysis and correction of ground reflection effects in measured narrowband sound spectra using cepstral techniques

Ground reflections generate undesirable effects on acoustic measurements such as those conducted outdoors for jet noise research, aircraft certification, and motor vehicle regulation. This paper shows how cepstral techniques developed in speech processing can be adapted to identify the echo delay time and to correct for ground reflection effects. A sample result is presented using an actual narrowband sound pressure level spectrum. The technique can readily be adapted to existing fast Fourier transform type spectrum measurement instrumentation to provide field measurement of echo time delays.

Miles, J. H.↗

NASA NTRS1975

Analysis and correction of ground reflection effects in measured narrowband sound spectra using cepstral techniques

Ground reflections generate undesirable effects on acoustic measurements such as those conducted outdoors for jet noise research, aircraft certification, and motor vehicle regulation. Cepstral techniques developed in speech processing are adapted to identify echo delay time and to correct for ground reflection effects. A sample result is presented using an actual narrowband sound pressure level spectrum. The technique can readily be adapted to existing fast Fourier transform type spectrum measurement instrumentation to provide field measurements/of echo time delays.

Miles, J. H.↗

NASA NTRS1974

A dual extremum principle for a population equation

A dual extremum principle for the Verhulst-Pearl population equation is constructed using a complementary variational technique. The dual formulation utilizes a minimum principle recently developed by Leitmann to convert the functional optimization problem into a parameter optimization problem.

Chan, W. L.↗

NASA NTRS1974

The discrete complementary variational principle and optimal control systems

A discrete complementary variational principle is developed and applied to linear and nonlinear discrete-time optimal control systems. Using the variational approach, a primal-dual relationship is established. This relationship provides a precise measure of system suboptimality independent of any a priori knowledge of the optimal solution.

Chan, W. L.↗

NASA NTRS1974

Multilevel control optimization using subsystem relative performance index sensitivity

A method is presented for the design of optimal feedback controllers for large multivariable systems with subsystem sensitivity constraints. The weighted sum of subsystem and/or operational mode relative performance index sensitivities is defined as the overall performance index. The method is developed for linear systems with quadratic performance criteria and either full or partial state feedback. An example concerning the design of a stability augmentation system for a VTOL aircraft in the transition mode demonstrates the effectiveness of the design method.

Leininger, G. G.↗

NASA NTRS1973

Complementary variational principle and duality in mathematical programming.

The relationship between the complementary variational principle and duality in mathematical programming is demonstrated through a geometric approach in a Hilbert space setting. A necessary and sufficient condition for the existence of such a principle is given in the case of a convex functional constrained by linear dynamics. Its relationship to the Kuhn-Tucker saddle point theory is indicated. Applications to various programming and control problems are discussed.

Chan, W. L.↗

NASA NTRS1973

Solution of coupled and singular perturbation methods using duality theory.

Dual variational techniques developed by Chan and Leininger (1972) are summarized, and duality theory in the form of the Complementary Variational Principle is employed to provide a suboptimal measure for the singular and epsilon-coupled perturbation methods proposed by Kokotovic and Cruz. The suboptimal measure is independent of any a priori knowledge of the optimal solution, thereby providing an absolute estimate of the performance loss rather than an estimate relative to the unknown optimal solution.

Chan, W. L.↗

NASA NTRS1972

Pilot/vehicle control optimization using averaged operational mode and subsystem relative performance index sensitivities

A method is presented for designing optimal feedback controllers for systems having subsystem sensitivity constraints. Such constraints reflect the presence of subsystem performance indices which are in conflict with the performance index of the overall system. The key to the approach is the use of relative performance index sensitivity (a measure of the deviation of a performance index from its optimum value). The weighted sum of subsystem and/or operational mode relative performance index sensitivies is defined as an overall performance index. A method is developed to handle linear systems with quadratic performance indices and either full or partial state feedback. The usefulness of this method is demonstrated by applying it to the design of a stability augmentation system (SAS) for a VTOL aircraft. A desirable VTOL SAS design is one that produces good VTOL transient response both with and without active pilot control. The system designed using this method is shown to effect a satisfactory compromise solution to this problem.

Leininger, G. G.↗