Engineering topics
Publications and source records attributed to Leiser, Daniel B..
The dimensional stability of ceramic coated thermal protection materials developed for use on advanced entry vehicles is evaluated. Dimensional stability of these ceramic materials were studied as a function of temperature and pressure during exposure to simulated atmospheric entry in an arc-jet facility.
Engineering model gives useful predictions. Pair of reports presents theoretical and experimental analyses of thermal responses of multiple-component, lightweight, porous, ceramic insulators. Particular materials examined destined for use in Space Shuttle thermal protection system, test methods and heat-transfer theory useful to chemical, metallurgical, and ceramic engineers needing to calculate transient thermal responses of refractory composites.
The need for improved coatings on low-density reusable surface insulation (RSI) materials used on the space shuttle has stimulated research into developing tougher coatings. The processing of a new porous composite "coating" for RST called toughened unipiece fibrous insulation Is discussed. Characteristics including performance in a simulated high-speed atmospheric entry, morphological structure before and after this exposure, resistance to Impact, and thermal response to a typical heat pulse are described. It is shown that this coating has improved impact resistance while maintaining optical and thermal properties comparable to the previously available reaction-cured glass coating.
Laminated composite insulations developed for potential use on advanced spacecraft operating between GEO and LEO were tested in an aerothermodynamic environment simulating an AOTV aerobraking maneuver (altitude 82.3 km and velocity = 9.0 km/s). Comparisons are discussed between these data and predictions of in-depth temperature response using dynamical thermal conductivity values to 2000 K.
The heatshield material requirements for future space vehicles (Aerobraking Orbital Transfer Vehicle & National Aerospace Plane) will depend upon the desired flight capability, configuration and location on the vehicle. These requirements will be more demanding and different from those derived for the materials used in the Shuttle Orbiter thermal protection system. Research was therefore initiated into improving the thermal efficiency of this class of materials by first characterizing their thermal and structural capabilities. Alternate material systems have been developed, tested, and compared with the baseline Shuttle system. This research resulted in the development of several very low density, high porosity (80-90%) materials with enhanced durability and temperature capability. One of the developments was a family of materials referred to as Fibrous Refractory Composite Insulation (FRCI) utilizing a mixture of fibers, each serving a unique purpose. One composition of the FRCI family with two fibers was adopted as a baseline material for use on the third and fourth Orbiters in selected areas due to its strength at a lower density compared to earlier materials. A further improvement in the FRCI family of materials is the Alumina Enhanced Thermal Barrier (AETB), a three-fiber composite. It has a higher temperature capability (composition dependent) than the baseline FRCI as proven by convective heating tests of one composition. AETB was studied to better characterize its performance at high temperature and the mechanisms by which its properties change. In conclusion, the shrinkage of AETB is a factor of six better than baseline FRCI at 1260 C (2300 F) with about a 20% improvement in mechanical properties. This improvement could translate into a 110 C (200 F) higher temperature capability in use as a heat shield material, but further testing in a convective heating environment is required to determine the actual improvement attainable.
A family of high strength per unit density fibrous insulation materials has undergone preliminary development for heat-shielding advanced, reusable entry vehicles. These materials have a range of temperature capabilities dependent on composition. They have an unusually high thermal-shock resistance, an unusually high strain-to- failure, low thermal conductivity, and good morphological stability. One composition within the family, 22% aluminoborosilicate fiber (0.19 g/cc), has been successfully produced in a pilot plant and scaled up to full production. This fiber's additional strength makes it a desirable composition; it will be used on the third and fourth Space Shuttle vehicles. Another composition, 15% aluminoborosilicate fiber (0.14 g/cc) , has been adopted for use on limited parts of the third vehicle and as a replacement for the 0.14 g/cc density, rigid silica RSI on the fourth.