Engineering topics

Leland, T. J. W.

Publications and source records attributed to Leland, T. J. W..

14 records

NASA NTRS1977

Experimental and analytical dynamic flow characteristics of an axial-flow fan from an air cushion landing system model

An investigation was conducted to compare the steady-state and dynamic flow characteristics of an axial-flow fan which had been used previously as the air supply fan for some model air cushion landing system studies. Steady-state flow characteristics were determined in the standard manner by using differential orifice pressures for the flow regime from free flow to zero flow. In this same regime, a correlative technique was established so that fan inlet and outlet pressures could be used to measure dynamic flow as created by a rotating damper. Dynamic tests at damper frequencies up to 5 Hz showed very different flow characteristics when compared with steady-state flow, particularly with respect to peak pressures and the pressure-flow relationship at fan stall and unstall. A generalized, rational mathematical fan model was developed based on physical fan parameters and a steady-state flow characteristic. The model showed good correlation with experimental tests at damper frequencies up to 5 Hz.

Thompson, W. C.↗

NASA NTRS1975

Landing impact studies of a 0.3-scale model air cushion landing system for a Navy fighter airplane

An experimental study was conducted in order to determine the landing-impact behavior of a 0.3-scale, dynamically (but not physically) similar model of a high-density Navy fighter equipped with an air cushion landing system. The model was tested over a range of landing contact attitudes at high forward speeds and sink rates on a specialized test fixture at the Langley aircraft landing loads and traction facility. The investigation indicated that vertical acceleration at landing impact was highly dependent on the pitch angle at ground contact, the higher acceleration of approximately 5g occurring near zero body-pitch attitude. A limited number of low-speed taxi tests were made in order to determine model stability characteristics. The model was found to have good pitch-damping characteristics but stability in roll was marginal.

Leland, T. J. W.↗

NASA NTRS1973

Numerical solution for low-velocity penetration of rigid body into still fluid

A modified marker-and-cell computational method is developed which can be used to study problems related to impact and penetration of a rigid body into a viscous medium. The method has been applied to solving (in two dimensions) the problem of low-velocity penetration of a rigid block into still water. The solution gives the complete pressure and velocity of the flow field so that the force and displacement time histories of the rigid body during the impact and entry phase are evaluated from the boundary stresses imposed by the fluid on the rigid body. Some limited experimental comparisons are also given to demonstrate the feasibility of the computational method.

Cheng, R. Y.-K.↗

NASA NTRS1973

Preliminary results from dynamic model tests of an air cushion landing system.

Experimental study of the behavior of an air cushion landing system on 1:10 and 1:4-scale dynamic models of the CC-115 aircraft over a range of initial impact, on a smooth hard surface of fiberglass-coated plywood, on calm water, and on rough water with waves 5 ft high and 100 ft crest-to-crest wide. The performance was satisfactory with the 1:10 scale model on hard surfaces and calm water and was less certain, requiring more tests, on rough water, while substantial pitching oscillations were observed in tests on the 1:4 scale model.

Leland, T. J. W.↗

NASA NTRS1973

Recent studies of tire braking performance

The results from recent studies of some factors affecting tire braking and cornering performance are presented together with a discussion of the possible application of these results to the design of aircraft braking systems. The first part of the paper is concerned with steady-state braking, that is, results from tests conducted at a constant slip ratio or steering angle or both. The second part deals with cyclic braking tests, both single cycle, where brakes are applied at a constant rate until wheel lockup is achieved, and rapid cycling of the brakes under control of a currently operational antiskid system.

Mccarty, J. L.↗

NASA NTRS1972

An evaluation of some unbraked tire cornering force characteristics

An investigation to determine the effects of pavement surface condition on the cornering forces developed by a group of 6.50x13 automobile tires of different tread design was conducted at the Langley aircraft landing loads and traction facility. The tests were made at fixed yaw angles of 3,4.5, and 6 deg at forward speeds up to 80 knots on two concrete surfaces of different texture under dry, damp, and flooded conditions. The results showed that the cornering forces were extremely sensitive to tread pattern and runway surface texture under all conditions and that under flooded conditions tire hydroplaning and complete loss of cornering force occurred at a forward velocity predicted from an existing formula based on tire inflation pressure. Futher, tests on the damp concrete with a smooth tire and a four-groove tire showed higher cornering forces at a yaw angle of 3 deg than at 4.5 deg; this indicated that maximum cornering forces are developed at extremely small steering angles under these conditions.

Leland, T. J. W.↗

NASA NTRS1972

Aircraft tire behavior during high-speed operations in soil

An investigation to determine aircraft tire behavior and operating problems in soil of different characteristics was conducted at the Langley landing-loads track with a 29 x 110.0-10, 8-ply-rating, type 3 tire. Four clay test beds of different moisture content and one sand test bed were used to explore the effects on axle drag loads developed during operation at different tire inflation pressures in free rolling, locked-wheel braking, and yawed (cornering) modes, all at forward speeds up to 95 knots. The test results indicated a complicated drag-load--velocity relationship, with a peak in the drag-load curve occurring near 40 knots for most test conditions. The magnitude of this peak was found to vary with tire inflation pressure and soil character and, in certain cases, might prove large enough to make take-off hazardous.

Leland, T. J. W.↗

NASA NTRS1971