Lemay, Scott P. | Search NASA

NASA NTRS1992

Forebody vortex flow control on the F-16C using tangential slot and jet nozzle blowing

The present experimental investigation of the effects of tangential slot and nozzle forebody blowing on the aerodynamic and stability characteristics of the F-16C configuration, for up-to-55 deg alpha and up-to-20 deg sideslip, was conducted on a 1/15th-scale model at freestream Mach = 0.4 and Re of 2.5 million/ft, for one tangential slot-nozzle location and two chordwise jet nozzle locations. Both the slot and the jet nozzles generated large yawing moments at very low blowing rates, over a wide range of alpha and sideslip angles. The centers of pressure of the side forces which generated the yawing moments due to slot and nozzle blowing were located in the region of the leading-edge extensions (LEXs); the moments may accordingly be due to the manipulation of the combined forebody and LEX flowfields.

Lemay, Scott P.↗

NASA NTRS1988

Leading edge vortex dynamics on a pitching delta wing

The leading edge flow structure was investigated on a 70 deg flat plate delta wing which was pitched about its 1/2 chord position, to increase understanding of the high angle of attack aerodynamics on an unsteady delta wing. The wing was sinusoidally pitched at reduced frequencies ranging from k being identical with 2pi fc/u = 0.05 to 0.30 at chord Reynolds numbers between 90,000 and 350,000, for angle of attack ranges of alpha = 29 to 39 deg and alpha = 0 to 45 deg. The wing was also impulsively pitched at an approximate rate of 0.7 rad/s. During these dynamic motions, visualization of the leading edge vorticies was obtained by entraining titanium tetrachloride into the flow at the model apex. The location of vortex breakdown was recorded using 16mm high speed motion picture photography. When the wing was sinusoidally pitched, a hysteresis was observed in the location of breakdown position. This hysteresis increased with reduced frequency. The velocity of breakdown propagation along the wing, and the phase lag between model motion and breakdown location were also determined. When the wing was impulsively pitched, several convective times were required for the vortex flow to reach a steady state. Detailed information was also obtained on the oscillation of breakdown position in both static and dynamic cases.

Lemay, Scott P.↗