Engineering topics

Lemmer, O. J.

Publications and source records attributed to Lemmer, O. J..

4 records

NASA NTRS1977

Laser velocimeter measurements of two-bladed helicopter rotor flow fields

Data from a wind tunnel investigation of the flow fields around helicopter rotors were presented. A two component laser velocimeter was used to measure the velocity fields of two 2.1 m diameter rotors. A minicomputer-based online data system is described which monitored, reduced, and plotted the results. Tip vortices constitute the primary disturbances in the flow field, but present theories do not predict vortex positions and velocity distributions with sufficient accuracy.

Biggers, J. C.↗

NASA NTRS1977

Measurements of helicopter rotor tip vortices

This paper presents results from a recent wind-tunnel investigation of model helicopter rotor tip vortices. Measurements were made of the vortex positions, core sizes, and velocity distributions. A laser velocimeter was used to make the measurements, and a minicomputer-based data system was used to process the data and to aid in controlling the experiment. The velocimeter, the data system, and the software developed for the minicomputer are briefly described. The rotors investigated were two-bladed, teetering rotors with diameters of 2.1 m. Two sets of blades were used, one set with zero twist and one set with -11 deg of linear twist. The vortex positions were obtained by making flow field traverses while strobing the data system at a fixed azimuth. Aging of a vortex element was also studied by following the convected element while strobing the data system at different azimuths. By this method, the effects on the vortex of a close interaction with a blade and another vortex were studied.

Biggers, J. C.↗

NASA NTRS1975

Velocity and rolling-moment measurements in the wake of a swept-wing model in the 40 by 80 foot wind tunnel

Measurements were made in the wake of a swept wing model to study the structure of lift generated vortex wakes shed by conventional span loadings and by several span loadings designed to reduce wake velocities. Variations in the span loading on the swept wing generator were obtained by deflecting seven flap segments on each side by amounts determined by vortex lattice theory to approximate the desired span loadings. The resulting wakes were probed with a three component, hot wire probe to measure velocity, and with a wing to measure the rolling moment that would be induced on a following aircraft. The experimental techniques are described herein, and the measured velocity and rolling moments are presented, along with some comparisons with the applicable theories.

Rossow, V. J.↗

NASA NTRS1974

Equation solving program for aerodynamic lifting surface theory

A description of and user's manual are presented for one of a group of FORTRAN programs which, together, can be used for the analysis and design of wings in steady, subsonic flow according to a kernel function method lifting surface theory. This particular program is the one which solves the sets of simultaneous, linear, algebraic equations arising from the thin wing analysis. This program has the capability of striking out rows and columns of the aerodynamic influence matrix and rows of the associated boundary condition vectors (right hand sides). This capability significantly enhances the effectiveness of the kernel function method of lifting surface theory because studies of the convergence of solutions with the number of control points can be done with the calculation of only a single influence matrix.

Medan, R. T.↗