Engineering topics
Publications and source records attributed to Leonard, R. G..
Sliding-gate valve originally developed for rocket exhaust-gas ducts is sealed by a Belleville spring. It is simple, compact, and operates over a wider range of temperatures than conventional O-ring sealed valves.
An attempt to obtain a dynamic model for a turbofan gas turbine engine for the purpose of adaptive control is described. The requirements for adaptive control indicate that a dynamic model should be identified from data sampled during engine operation. The dynamic model identified was of the form of linear differential equations with time varying coefficients. A turbine engine is, however, a highly nonlinear system, so the identified model would be valid only over a small area near the operating point, thus requiring frequent updating of the coefficients in the model. Therefore it is necessary that the identifier use only recent information to perform its function. The identifier selected minimized the square of the equation errors. Known linear systems were used to test the characteristics of the identifier. It was found that the performance was dependent on the number of data points used in the computations and upon the time interval over which the data points were obtained. Preliminary results using an engine deck for the quiet, clean, shorthaul experimental engine indicate that the identified model predicts the engine motion well when there is sufficient dynamic information, that is when the engine is in transient operation.
The purpose of this paper is to demonstrate the convenience of using a systematic straight forward procedure to obtain meaningful dynamic information for a class of complex distributed parameter fluid line networks. System transients in the time domain are determined by means of state space techniques. Digital computer implementation yields a simple but consistent way of obtaining overall system time solutions. A step-by-step analysis procedure flow chart is shown in Appendix I which illustrates the basic approach for modeling, approximating and selecting digital techniques for simulating the dynamic response of fluid line systems.
Computer model of fluid transmission line using digital technique to simulate transport delay associated with pressure wave propagation along fluid line