Engineering topics
Publications and source records attributed to Li, Binsong.
An electrode including an electrode active material including lithium (Li) and a polymer layer coating at least a portion of the electrode active material is provided. The polymer layer includes a polymerization product of a monomer having Formula I: where R1 and R2 are independently an aryl or a branched or unbranched C1-C10 alkyl and X1 and X2 are independently chlorine (Cl), bromine (Br), or iodine (I).
Double-layered protective coatings for lithium metal electrodes, as well as methods of formation relating thereto, are provided. The negative electrode assembly includes an electroactive material layer including lithium metal and a protective dual-layered coating. The protective dual-layered coating includes a polymeric layer disposed on a surface of the electroactive material layer and an inorganic layer disposed on an exposed surface of the polymeric layer. The polymeric layer has an elastic modulus of greater than or equal to about 0.01 GPa to less than or equal to about 410 GPa. The inorganic layer has an elastic modulus of greater than or equal to about 10 GPa to less than or equal to about 1000 GPa.
The success of polyacrylic acid (PAA) to suppress Li dendrite growth suggests that the mechanical properties of polymer-based coatings, including the modulus, toughness, and interfacial adhesion are important design criteria. However, the measurement of the adhesion of thin PAA, as well as other polymer coatings to the reactive Li-metal anode surface is limited experimentally and challenging computationally. In this paper, a strategy was proposed to estimate the adhesion and delamination of the PAA(polymer)/Li interface, based on the bonding nature at the simpler PAA (oligomer)/Li interfaces using density functional theory calculations. It has been shown that the carboxylic acid groups in PAA reacted strongly with metallic Li, which significantly enhances the interfacial adhesion through the Li–O bonds formation, Li ionization and its incorporation into PAA, and –H or –OH termination of Li after decomposition of the COOH functional group. During delamination, it was found that the most likely PAA delamination route involved breaking partial Li–O bonds and lifting some ionized Li atoms from the Li-metal, especially for the Li atoms that showed a charge closer to +1 or are bonded with two O atoms from PAA. Based on the average bonding energies from PAA(oligomer)/Li interface delamination calculations, the work of separation, W sep , of the PAA(polymer)/Li interface was estimated to be ~1.0 (J/m 2 ). The high W sep of PAA (polymer)/Li was comparable with the Li 2 O/Li interface and higher than Li 2 CO 3 /Li and LiF/Li interfaces. This order correlated well with the areal density of Li–O bonds, which can serve as a descriptor for the interfacial adhesion. Furthermore, this computational approach can be applied to other interfaces with polymer-based coatings.
Abstract Porous structured silicon has been regarded as a promising candidate to overcome pulverization of silicon-based anodes. However, poor mechanical strength of these porous particles has limited their volumetric energy density towards practical applications. Here we design and synthesize hierarchical carbon-nanotube@silicon@carbon microspheres with both high porosity and extraordinary mechanical strength (>200 MPa) and a low apparent particle expansion of ~40% upon full lithiation. The composite electrodes of carbon-nanotube@silicon@carbon-graphite with a practical loading (3 mAh cm −2 ) deliver ~750 mAh g −1 specific capacity, <20% initial swelling at 100% state-of-charge, and ~92% capacity retention over 500 cycles. Calendered electrodes achieve ~980 mAh cm −3 volumetric capacity density and <50% end-of-life swell after 120 cycles. Full cells with LiNi 1/3 Mn 1/3 Co 1/3 O 2 cathodes demonstrate >92% capacity retention over 500 cycles. This work is a leap in silicon anode development and provides insights into the design of electrode materials for other batteries.