Search NASA⌕ Search

Engineering topics

Li, F.

Publications and source records attributed to Li, F..

At least 181 records · Page 10

ARMAR Observations during TOGA/COARE

The NASA/JPL Airborne Rain Mapping Radar (ARMAR) was deployed for rainfall observations during TOGA/COARE on the NASA DC-8 aircraft. A total of approx. 30 hours of rain profiling measurements were collected over the Western Pacific Ocean during January and February 1993.

radar bright bands rain attenuation study Airborne↗

A combined algorithm for minimum time slewing of flexible spacecraft

The use of Pontryagin's Maximum Principle for the large-angle slewing of large flexible structures usually results in the so-called two-point boundary-value problem (TPBVP), in which many requirements (e.g., minimum time, small flexible amplitude, and limited control powers, etc.) must be satisfied simultaneously. The successful solution of this problem depends largely on the use of an efficient numerical computational algorithm. There are many candidate algorithms available for his problem (e.g., quasilinearization, gradient, and shooting, etc.). In this paper, a proposed algorithm, which combines the quasilinearization method with a time shortening technique and a shooting method, is applied to the minimum-time, three-dimensional, and large-angle maneuver of flexible spacecraft, particularly the orbiting Spacecraft Control Laboratory Experiment (SCOLE) configuration. Theoretically, the nonlinear TPBVP can be solved only through the shooting method to find the 'exact' switching times for the bang-bang controls. However, computationally, a suitable guess for the missing initial costates is crucial because the convergence range of the unknown initial costates is usually narrow, especially for systems with high dimensions and when a multi-bang-bang control strategy is needed. On the other hand, the problems of near minimum time attitude maneuver of general rigid spacecraft and fast slewing of flexible spacecraft have been examined by the authors through a numerical approach based on the quasilinearization algorithm with a time shortening technique. Computational results have demonstrated its broad convergence range and insensitivity to initial costate choices. Consequently, a combined approach is naturally suggested here to solve the minimum time slewing problem. That is, in the computational process, the quasilinearization method is used first to obtain a near minimum time solution. Then, the acquired converged initial costates from the quasilinearization approach are transformed (tailored) to and used as the initial costate guess for starting the shooting method. Finally, the shooting method takes over the remaining calculations until the minimum-time solution converges. The nonlinear equations of motion of the SCOLE are formulated by using Lagrange's equations, with the mast modeled as a continuous beam subject to three-dimensional deformations. The numerical results will be presented and some related computational issues will also be discussed.

Bainum, P. M.↗

Remote sensing of ocean waves: The Surface Wave Process Program experiment

An airborne synthetic aperture radar (SAR) has been used as an interferometer to obtain direct, calibrated measurements of the ocean wind wave directional spectrum. Flights over the same area from three different directions produced reasonably consistent results. The SAR-derived wave data agree well with simultaneous observations by a conventional wave measuring system and with a novel in situ acoustic Doppler system.

Goldstein, R. M.↗

Pulse Compression with Very Low Sidelobes in an Airborne Rain Mapping Rada

The pulse compression system for an airborne rain mapping rada is described. This system uses time domain weighting of the transmit pulse and is able to achive a pulse compression sidelobe level of -55 dB. This is significantly lower than any values previously reported in the open literature.

Pulse Compression↗

Three-dimensional boundary layer stability and transition

Nonparallel and nonlinear stability of a three-dimensional boundary layer, subject to crossflow instability, is investigated using parabolized stability equations (PSEs). Both traveling and stationary disturbances are considered and nonparallel effect on crossflow instability is found to be destabilizing. Our linear PSE results for stationary disturbances agree well with the results from direct solution of Navier-Stokes equations obtained by Spalart (1989). Nonlinear calculations have been carried out for stationary vortices and the computed wall vorticity pattern results in streamwise streaks which resemble remarkably well with the surface oil-flow visualizations in swept-wing experiments. Other features of the stationary vortex development (half-mushroom structure, inflected velocity profiles, vortex doubling, etc.) are also captured in our nonlinear calculations. Nonlinear interaction of the stationary amplitude of the stationary vortex is large as compared to the traveling mode, and the stationary vortex dominates most of the downstream development. When the two modes have the same initial amplitude, the traveling mode dominates the downstream development owing to its higher growth rate, and there is a tendency for the stationary mode to be suppressed. The effect of nonlinear wave development on the skin-friction coefficient is also computed.

Malik, M. R.↗

Vibration control of a manipulator tip on a flexible body

Vibration control of a rigid manipulator tip on a main flexible uniform beam is examined. It is proposed to add a compensator between the manipulator and the beam to rotate and extend/retrieve the manipulator during the control period. The 2D station-keeping maneuvers within the linear range without gravity and damping are considered. The compensatory open-loop control law, which depends on the amplitudes of the beam's flexible deformations at the connection joint, is synthesized using linear quadratic regulator techniques. After introducing the compensatory control into the system, system control is still stable, and the tip coordinates of the manipulator can be made to closely follow the rigid beam motion, which is assumed to be a desired motion.

Xu, J.↗

C-band measurement of radar backscatter from the ocean surface during SWADE

A preliminary analysis of backscatter measurements collected during the joint NASA/ONR Surface Wave Dynamics Experiment (SWADE) by a C-band scatterometer (C-SCAT) is presented. Data were collected during a total of ten flights on board the NASA/Ames C-130B off the coast of Virginia. These backscatter measurements are vertically polarized, and were obtained over a full 360* in azimuth, at incidence angles ranging from 20 to 50 . The data set is now in a state where it can provide a unique test bed for normalized radar cross section (NRCS) model functions because of the variety of phenomena encountered, and the quantity and quality of the measurements.

Carson, S. C.↗

Air-sea fluxes and surface layer turbulence around a sea surface temperature front

The observed effects of sharp changes in sea surface temperature (SST) on the air-sea fluxes, surface roughness, and the turbulence structure in the surface layer and the marine atmospheric boundary layer are discussed. In situ flux and turbulence observations were carried out from three aircraft and two ships within the FASINEX framework. Three other aircraft used remote sensors to measure waves, microwave backscatter, and lidar signatures of cloud tops. Descriptions of the techniques, intercomparison of aircraft and ship flux data, and use of different methods for analyzing the fluxes from the aircraft data are described. Changing synoptic weather on three successive days yielded cases of wind direction both approximately parallel and perpendicular to a surface temperature front. For the wind perpendicular to the front, wind over both cold-to-warm and warm-to-cold surface temperatures occurred. Model results consistent with the observations suggest that an internal boundary layer forms at the SST.

Friehe, C. A.↗